Layer stackings in the ideal and real kaolinite structures are considered in terms of layer orientations i = 1, 2, … 6, intra- and interlayer displacements of adjacent 0- and T-sheets, si and tk, distortions of these displacements δ1 and δ2, deviations of unit cell parameters ηi = b2i/a2i − 3, εi = γi − π/2, and normal projections cn of the axis vector c on the ab plane.

The ideal monoclinic angle of dickite (cnx = −1/3) and the deviation α - π/2 ≠ 0 for kaolinite are explained by combinations of the δ1 and δ2 values in the sequence of symbols si and tk defining the corresponding structures. Twenty stacking variants in the 3 successive layers of the kaolinite structure are derived, incorporating layer orientations of the same parity, displacements t+, − = [0, ± 1/3] and reflection operations in planes normal to the axis b3. Two deformation mechanisms are proposed for the accommodation of successive layer unit cells adjusting either angular or linear parameters at the agreement of either linear or angular parameters corresponding.

Prograde evolution of illite/smectite occurring in an unusually-thick (8000 m) sequence of Mesozoic-Cenozoic sediments in the Basque-Cantabrian Basin, Spain, has been studied using XRD and TEM/AEM. The sediments, which are only slightly tilted, cover the range from smectite to illite, and the most deeply buried ones are unique in that they span the range from diagenesis through low-grade metamorphism (anchizone), with no apparent overprinting due to tectonic deformation.

Pelites are absent from the shallow section, but smectite occurs in marls as high-charge, K-dominant and low-charge, K-poor anastomosing arrays of layers. At intermediate depths, authigenic clay is identified largely as R1 I/S, coexisting with packets of R≫3 I/S (nearly pure illite), where illite-like and smectitelike layers can be identified by contrast in TEM images, which is consistent with XRD data. The authigenic clay of the deepest samples consists of illite with no or almost no expandable layers, which occurred as packets with layers largely subparallel to bedding, K-deficient composition in comparison with muscovite, 1Md-like SAED patterns, and 100 Å mean packet thickness. There is no evidence of deformation stress-induced, non-bedding-parallel clays in the deepest samples. Detrital micas with either a phengiterich or a phengite-poor composition range dominate the phyllosilicate fraction of all the samples. Detrital micas show no changes over the diagenesis/metamorphism range and appear to have behaved as if isolated from authigenic clays.

Authigenic clays occur as bedding-subparallel packets that evolved during passive burial metamorphism through dissolution/crystallization of less-evolved clays. Where illite-like and smectite-like layers can be identified, TEM images imply a discontinuous series in which packets of R1 I/S (50% I) transform to packets of nearly-pure illite, that is, an Ostwald-step-rule-like sequence. Such immature illite remains unmodified with further burial, and is apparently the potential predecessor of stress-induced, highly-evolved mica of higher-grade, tectonically-deformed pelites.

Sedimentary zeolites clinoptilolite, mordenite and erionite occur as diagenetic products of ash falls of rhyolitic composition from the Oligocene Chichindaro Formation at the limits of the Mexican Volcanic Belt with the Mexican Highland. These zeolitic tuffs were formed from open hydrologic environments where rhyolitic glass altered to clinoptilolite + opal-C and to clinoptilolite + mordenite + erionite + opal-C. The process of diagenesis was hydrolysis associated with the removal of SiO2, K2O, and Na2O from the rhyolitic precursor and enrichment of Al2O3, MgO, and CaO. The crystallization of clinoptilolite occurs at ratios of SiO2/Al2O3 between 4.91 and 7.14 and (K2O + Na2O)/(MgO + CaO) from 2.19 to 0.79. Formation of clinoptilolite appears to be directly from glass and through a vitreous proto-zeolite intermediate. The zeolitic tuff is in contact with a vitric tuff where ash falls were devitrified to K-feldspar and diagenetically altered to smectite + opal-C.

Offscraped strata within the toe of Nankai accretionary prism display an overall facies pattern of thickening and coarsening upward. Detrital clay minerals within the Quaternary trench-wedge facies are dominated by illite; chlorite is the second-most abundant clay mineral, followed by smectite. Relative mineral percentages change only modestly with depth. The hemipelagic clay-mineral population is virtually identical to clays washed from turbidite matrix, and different size fractions (<2 μm and 2–6 μm) show nominal amounts of mineral partitioning. Smectite content increases beneath the trench-wedge deposits, where the upper subunit of the Shikoku Basin stratigraphy (late Pliocene and early Pleistocene) includes abundance of volcanic ash. Syneruptive, subaerial chemical weathering of volcanic source rocks, together with in situ alteration of disseminated glass shards, caused the increase in smectite. Smectite begins a monotonic transformation to illite/smectite (I/S) mixed-layer clay at ~555 mbsf and an estimated temperature of ~65 °C. Ordered (R = 1) I/S interlayering first appears at ~1220 mbsf (<2 μm size fraction) and ~1100 mbsf (<0.2 μm size fraction). The illitization gradient coincides with a reduction in pore-water chlorinity, but depth-related changes in bulk mudstone geochemistry (K2O, Rb) are subtle. The absolute abundances of discrete smectite and I/S appear to be insufficient to account for the magnitude of pore-water dilution via in situ dehydration reactions. Instead, pore water probably was transported to Site 808, either from sources located deeper in the accretionary prism, where bulk mudstone porosities are lower, or from strike-parallel sources where mudstones originally deposited in the Shikoku Basin might contain higher percentages of smectite.

Nacrite, dickite and intermediate dickite-nacrite phases have been identified from the upper Paleozoic sequences of the Maláguide Complex (Betic Cordilleras, Spain). Nacrite developed as euhedral, pseudohexagonal or elongated crystals within sandstones and thin, irregular veins. Dickite developed preferently within extensive zones of fractures as very irregular, compact packets. Intermediate phases occurred in the sandstones and veins similar to the nacrite, or accompanying dickite. The mineral assemblage of the sandstones includes quartz-muscovite-kaolinite-type minerals, with or without albite, carbonates, chlorite and mixed-layers containing chlorite. The metamorphic conditions in which these minerals formed belong to anchizone, as can be deduced from the IC values. Dickite, nacrite and intermediate phases were studied by X-ray diffraction, infrared spectroscopy, differential thermal analysis and micros-copy. The results for dickite indicate a well-ordered mineral and agree with most of the published data. Conversely, IR spectra and DTA curves of nacrite show some differences in relation to the available data for this mineral. Based on the comparison with dickite and nacrite data, intermediate phases can be interpreted either as disordered varieties or as mixed-layered dickite/nacrite.

The roles of molecular structure and charge are examined in the transport of cations within montmorillonite clay films. The series of Ru(NH3)63+, Co(NH3)3+, Co(en)33+, Co(sep)3+ and Co(bpy)33+ are examined in detail via electrochemical and spectrochemical methods. The electrochemical signal is enhanced both in minimizing the time required to develop the signal and in the magnitude of the signal for Ru(NH3)63+. In addition, the potential for the observed reduction peak is shifted negative and the current peak associated with reduction disappears with rinsing of the clay film. These observations are characteristic of a compound that is held by simple electrostatic charge characteristics. In contrast, the compounds Co(NH3)3+, Co(en)33+ and Co(sep)3+, while showing rapid and enhanced signal development, eventually evolve a signal that is diminished with respect to the bare electrode, consistent with a hydrophobic mode of retention. The signal for Co(bpy)33+ is slow to be observed, is diminished with respect to the bare electrode and is shifted positive in potential, all hallmarks of a strong, non-electrostatic mode of binding within the clay.

The response of two swelling clays (SWy-1 and SAz-1) and of one non-swelling clay (KGa-1) and of a series of mixtures of these clays to different electrolyte concentrations was examined using clay-modified electrode techniques. A non-interacting probe ion, Fe(CN)63−, was monitored via reduction for its arrival at a Pt electrode coated with thin films of the clay mixtures. The three clays had both different temporal responses and different equilibrium currents. For SWy-1 the currents were developed over time and were dependent upon the electrolyte of the bathing solution, which was consistent with X-ray diffraction data literature for the interlayer dimension. Similar behavior was found for SAz-1, but for KGa-1, currents were instantaneous and were independent of the bathing electrolyte. This suggests that the pores controlling the probe ion transport were between particle or pinhole in nature. When mixtures of the clays were examined, it was found that KGa-1 caused defects within the structures of the mixed clay films. The SWy-1 mixture was not as affected by these disruptions as was the SAz-1 mixture.

Conversion of tertiary butylacetate to isobutylene and acetic acid and cracking of n-octane were used as model reactions to monitor the catalytic activity of a condensate and aqueous extract derived from a sample of montmorillonite. The condensate was obtained by condensing the vapor phase evolved on heating the clay and the extract was derived from the clay by prolonged water extraction. Both condensate and extract were colloidal systems, which were separated into solid and liquid fractions by distillation. Reactions carried out in a dynamic system established that the solid components acted as true acid catalysts, whereas the liquid fractions were inactive under the experimental conditions adopted. The catalytic activity per weight of the condensate exceeded that of either the parent clay or the extract.

The present results confirm that colloidal size catalysts of high activity can be generated from clays. Such materials, mobilized and transported alone or with formation fluids, may act as catalysts in places removed in space and time from their source. This finding refutes objections previously raised to the operation of bulk clays as catalysts for reactions with particulate organics and supports the concept that acid catalysts derived from clays may participate in organic geochemical reactions in an aqueous medium.

The cleavage of two single-crystal chlorites (a clinochlore and a penninite) has been studied using angle-resolved X-ray photoelectron spectroscopy (XPS). Both minerals cleaved in regions not typical of the bulk; the composition of the clinochlore was found to be especially non-uniform. The brucitic interlayer divided evenly between the pair of new surfaces exposed for two cleaves in the clinochlore, but was partitioned unequally in two cleaves in the penninite. The differences in apparent composition between the complementary pairs of surfaces are interpreted to show a marked preference of octahedral Al for the brucitic layer, in agreement with X-ray bulk structure refinements. For both chlorites, the layer charge was reduced in regions of easy cleavage, which also had a higher proportion of Si and less tetrahedral Al than the bulk chlorite. The percentages of tetrahedral aluminium deduced from the XPS surface analyses agreed satisfactorily with the percentages independently determined by consideration of the magnitude of anisotropy in the X-ray photoelectron diffraction (XPD) patterns. The XPD patterns from the clinochlore for rotation about axes parallel and antiparallel to the crystallographic a-axis were identical, showing that tetrahedral ordering was absent.

Hydrogen- (δD = −106 to −97‰) and oxygen-(δ18O = +14.0 to +16.6‰) isotope compositions of kaolinite from late Cretaceous and Oligocene deposits at Iwaizumi, northeastern Japan, indicate that these clays formed by weathering of volcanic parent rocks, rather than during hydrothermal (>100 °C) alteration. The Iwaizumi kaolinites also are depleted of D and 18O relative to kaolinite formed during modern, tropical weathering, suggesting that the kaolinite developed under cool or cool-temperate conditions. The oxygen-isotope compositions of the kaolinite increase slightly upward through the deposits, perhaps implying a modest increase in temperature from late Cretaceous to Oligocene time. The δD and δ18O results for kaolinite from the Oligocene deposits closely follow the kaolinite weathering line. However, a small but systematic deviation from this line for the Cretaceous kaolinites is most simply explained by post-formational, hydrogen-isotope exchange between these clays and downward percolating meteoric water.

A comparative study is reported in which kaolinite has been hydrothermally synthesized at several pH conditions. The syntheses were carried out at 220 °C for 3 to 10 d with distilled water or acidic solutions using a mixture of silica-gel derived from alkoxide and gibbsite with a Si/Al ratio of 1:1 as the starting material. Use of acidic solution for the synthesis promotes the dissolution of the starting materials and leads to kaolinitization at an earlier stage of the reaction. However, the rate of kaolinitization is found to be rather slow, in comparison to the reaction with distilled water. The synthetic kaolinite was characterized by X-ray powder diffraction pattern. Kaolinite synthesized with distilled water was poorly grown for direction of the stacking. For example, crystallite size along the c*-axis = 155 Å, whereas kaolinite synthesized with acidic solution gave a higher crystallite size along the c*-axis, such as 253 Å in the case of the synthesis with 0.1 N HCl. Hinckley index of the synthetic kaolinite was varied from 0.35 to 0.80 by the acidity of the reaction. Different kaolinitization processes are implied by differences observed in the rate of kaolinitization, which has an influence on the nature of the stacking faults of the kaolinite.