The interaction of near infrared femtosecond laser pulses with a Cu based alloy (brass) in ambient air at atmospheric pressure and under different laser conditions was investigated. The effects of laser fluence and number of pulses on surface morphology and ablation rate were studied using scanning electron microscopy (SEM) and optical microscopy. Ablation rates were found to rapidly increase from 83 to 604 nm/pulse in the fluence range 1.14–12.21 J/cm2. At fluence >12.21 J/cm2, ablation rates increased slowly to a maximum (607 nm/pulse at 19.14 J/cm2), and then decreased at fluence higher than 20.47 J/cm2 to 564 nm/pulse at 24.89 J/cm2. Large amounts of ablated material in a form of agglomerated fine particles were observed around the ablation craters as the number of laser pulses and fluence increased. The study of surface morphology shows reduced thermal effects with femtosecond laser ablation in comparison to nanosecond laser ablation at low fluence.

Plasma was generated by focusing 10 ns Nd:YAG (λ = 1064 nm) laser pulse on the thick tungsten target. The laser fluence at the target was varied in the range of 3.57–10.97 J/cm2. The ion emission from the expanding tungsten plasma was analyzed with the help of an ion collector and time-of-flight electrostatic ion energy analyzer. About 44 times rise in the ion charge per laser shot was observed in the investigated laser fluence range. The measured threshold fluence for onset of the tungsten plasma was 3.27 J/cm2. The estimated plume expansion coefficient Zinf/Xinf = 2.5 ± 0.2 was in agreement with the previous experimental studies and the predictions of self-similar plume expansion model. The electrostatic ion energy analyzer study showed that charge state of the W ions increases with the laser fluence and maximum ion charge state was 5+. It was observed that threshold fluence for appearance of a specific charge state can be measured. A clear correlation between the relative abundances of W(n−1)+, Wn+, and W(n+1)+ indicates that higher order charge states are most probably produced by stepwise ionization process.

An intense electron-beam accelerator, which consists of a primary storage capacitor system, a magnetic core Tesla transformer, Blumlein pulse forming line of water dielectric, and a field-emission diode, are constructed and described. The experimental results show that the output voltage of transformer is more than 740 kV, the rise time is about 5 µs, the diode voltage is about 596 kV, electron beam current is about 60 kA, the duration is about 100 ns, and the power is 36 GW when charging voltage is 40 kV. It was suitable to drive magnetically insulated transmission line oscillator. And it can be also used in materials surface modification. This accelerator is very compact and works stably and reliably.

It is shown that various spectroscopic methods based on measurements of X-ray spectra radiated from cluster targets can be used for estimation of the destruction degree of clusters by laser prepulses. These methods allow insight to be gained regarding the important issue of preservation of the dense cluster core at the moment of the arrival of the main laser pulse. In addition, they can be used for quantitative estimation of the size of the undestroyed parts of the clusters and also for measuring the temperature and density of the preplasmas produced by the laser prepulses.

In order to improve the total laser-proton energy conversion efficiency, a nanobrush target is proposed for proton acceleration and investigated by two-dimensional particle-in-cell simulation. The simulation results show that the nanobrush target significantly enhances the energy and number of hot electrons through the target rear side. Compared with plain target, the sheath field on the rear surface is increased near 100% and the total laser-proton energy conversion efficiency is prompted more than 70%. Furthermore, the proton divergence angle is less than 30° by using nanobrush target. The proposed target may serve as a new method to increase the energy conversion efficiency from laser to protons.

The self-focusing of an intense right circularly polarized Gaussian laser pulse in magnetized plasma is studied. The ions are taken to be immobile and relativistic mass effect is incorporated in both the plasma frequency (ωp) and the electron cyclotron frequency (ωc) while determining the ponderomotive force on electrons. The ponderomotive force causes electron expulsion when the effective electron cyclotron frequency is below twice the laser frequency. The nonlinear plasma dielectric function due to ponderomotive and relativistic effects is derived, which is then employed in beam-width parameter equation to study the self-focusing of the laser beam. From this, we estimate the importance of relativistic self-focusing in comparison with ponderomotive self-focusing at moderate laser intensities. The beam width parameter decreases with magnetic field indicating better self-focusing. When the laser intensity is very high, the relativistic gamma factor can be modeled as ${\rm \gamma} = 0.8\left({{{{\rm \omega} _c } / {\rm \omega} }} \right)+ \sqrt {1 + a_0^2 }$$\text{γ}=0.8({\text{ω}}_c/\text{ω})+\sqrt{1+a_0^2}$ where ω and a0 are the laser frequency and the normalized laser field strength, respectively. The cyclotron effects on the self-focusing of laser pulse are reduced at high field strengths.

X-ray emission from Kr13+ ions in the energy range 1.2–3.6 MeV in steps of 0.6 MeV impacting on an Au target was investigated on electron cyclotron resonance ion source at the Heavy Ion Research Facility in Lanzhou. It was found that a shift of the X-ray lines to the higher energy side occurred. We measured the relationship between the characteristic of X-ray yield of Au M X-rays and Kr L X-rays as a function of incident energy. Furthermore, M-shell X-ray production cross-section of Au induced by Kr13+ was measured. The measured cross-section of target is compared to the classical binary-encounter approximation and plane-wave-born approximation theoretical model, which is a significant different between experimental and theoretical model.

To control the shape of the ultra-thin electron layer produced by directly interaction of ultrahigh contrast laser with ultra-thin foil target, we investigated the spacial distribution and temporal evolution of electron layers produced from single and double foil targets through two-dimensional particle-in-cell simulations. Results show that electron layers produced from double foil targets can fly with unperturbed velocity for a much longer time than in the single foil case, which can be explained by the integrated contribution of charge separation field from both the two foils. Further studies show that through adjusting the foil expansion, electron layers with different shapes can be obtained. Detailed studies on the forming process of layers show that electron momentum distribution evolves rapidly along with the pump laser and then the vanishing of electron transverse momentum induced by the reflected laser results in the forming of layer shape. So different foil expansion corresponds to different moments that reflected laser interact with electron layer, when the electron transverse momentum distribution is different. After the reflected laser interact with electron layer, the resultant longitude momentum distribution will finally lead to various electron layer shapes.

Laser plasma experiments, which demonstrated the single order diffraction property of spectroscopic photon sieve (a novel single-order diffraction grating), were performed on the SILEX-I femto-second laser facility. High-intensity laser radiation was focused onto a Cu target to generate plasma. The spectra of soft X-ray from copper plasmas have been measured with spectroscopic photon sieve based spectrograph. The results show that the spectroscopic photon sieve is able to provide soft X-ray spectrum free from higher-order diffraction components. The measured spectra obtained with such a spectroscopic photon sieve need no unfolding process to extract higher-order diffraction interference.

The out-of-equilibrium situation in which an initially sharp-edged cylindrical electron beam, that could, e.g., model electrons flowing within a wire, is injected into a plasma is considered. A detailed computation of the subsequently produced magnetic field is presented. The control parameter of the problem is shown to be the ratio of the beam radius to the electron skin depth. Two alternative ways to address analytically the problem are considered: one uses the usual Laplace transform approach, the other one involves Riemann's method in which causality conditions manifest through some integrals of triple products of Bessel functions.

This paper presents numerical simulations to study the heating of a two-dimensional (2D) solid target under an ion cluster interaction. 2D quantum hydrodynamic (QHD) model is employed for the heating of solid target to warm dense matter on a picosecond time scale. A Gaussian cluster is used to uniformly heat the solid target to a temperature of several eV. The density and temperature of the target are calculated by a full self-consistent treatment of the QHD formalisms and the Poisson's equation. The technique described in this paper provides a method for creating uniformly heated strongly coupled plasma states.

Total electron emission yield for impact of slow Neq+(q = 2, 4, 6, 8) ions with various kinetic energy under normal incidence on n-type Si has been measured. It is shown that for the same charge state, the total electron yield γ increases linearly as the kinetic energy of projectile at impact increases, up to velocities corresponding to the “classical” threshold. Separation of kinetic electron yield γKE and potential electron yield γPE shows that γPE is proportional to the ion charge state and γKE increases linearly with projectile velocity. Finally, based on “single hole without hopping” hypothesis, the expression of the “CRF” F(q) is given, and the relation between γKE and q is obtained successfully for the first time, which is also a basis for judging whether the “trampoline effect” exists.

Arguments are discussed on how ion energy measurements from ultra-thin diamond irradiation with 45 fs laser pulses of 26 terawatt power may be related to the ultra-high acceleration of plasma blocks where the significance of the highly efficient direct conversion of laser radiation into mechanical motion of ions or plasma blocks is dominated by nonlinear (ponderomotive) forces in fundamental contrast to thermo-kinetic dominated interaction with ns laser pulses.

In this work, we review current trends in China to investigate beam plasma interaction phenomena. Recent progresses in China on low energy heavy ions and plasma interaction, ion beam-plasma interactions under the influences of magnetic fields, high energy heavy ion radiography through marginal range method, energy deposition of highly charged ions on surfaces and Raman spectroscopy of surfaces after irradiation of highly charged ions are presented.

This paper presents an investigation of a self-consistent, theoretical model, which explains the ring formation in a super-Gaussian laser beam propagating in plasma with transverse magnetic field, characterized by relativistic nonlinearity. Higher order terms (up to r4) in the expansion of the dielectric function and the eikonal have been taken into account. The condition for the formation of a dark and bright ring has been used to study focusing/defocusing of the beam. It is seen that inclusion of higher order terms does significantly affect the dependence of beam width parameter on the distance of propagation. Self-focusing of super-Gaussian beam is studied at various values of super-Gaussian coefficient, m and magnetic field. Further, we have studied some distinct features of critical power curves for varying values of magnetic field.

The electron emission yield γ induced by Ne2+ and O2+ impacting on a clean tungsten surface has been measured. The range of projectile energy is from 3 keV/u to 14 keV/u. The total electron yield gradually increases with the projectile velocity. It is found simultaneously that the total electron yield for O2+ is larger than the total electron yield for Ne2+, which is opposite to the results for higher projectile velocity. After considering the contribution from recoiling atoms to the energy distribution and electron emission yield, we find that recoiling atoms are of crucial importance in electron emission in our energy range. Thus, the unexpected results in our experiment can be explained successfully.