The aim of this work was to determine if volumetric modulated arc therapy (VMAT) plans, created for constant dose-rate (cdrVMAT) delivery are a viable alternative to step and shoot five-field intensity modulated radiation therapy (IMRT).

The cdrVMAT plans, inverse planned on a treatment planning system with no solution to account for couch top or rails, were created for delivery on a linear accelerator with no variable dose rate control system. A series of five-field IMRT and cdrVMAT plans were created using dual partial arcs (gantry rotating between 260° and 100°) with 4° control points for ten prostate patients with the average rectal constraint incrementally increased. Pareto fronts were compared for the planning target volume homogeneity and average rectal dose between the two techniques for each patient. Also investigated were tumour control probability and normal tissue complication probability values for each technique. The delivery parameters [monitor units (MU) and time] and delivery accuracy of the IMRT and VMAT plans were also compared.

Pareto fronts showed that the dual partial arc plans were superior to the five-field IMRT plans, particularly for the clinically acceptable plans where average rectal doses were less for rotational plans (p = 0·009) with no statistical difference in target homogeneity. The cdrVMAT plans had significantly more MU (p = 0·005) but the average delivery time was significantly less than the IMRT plans by 42%. All clinically acceptable cdrVMAT plans were accurate in their delivery (gamma 99·2 ± 1·1%, 3%3 mm criteria).

Accurate delivery of dual partial arc cdrVMAT avoiding the couch top and rails has been demonstrated.

To examine detail depth dose characteristics of ideal proton beams using the GATE Monte Carlo technique.

In this study, in order to improve simulation efficiency, we used pencil beam geometry instead of parallel broad-field geometry. Depth dose distributions for beam energies from 5 to 250 MeV in a water phantom were obtained. This study used parameters named Rpeak, R90, R80, R73, R50, full width at half maximum (FWHM), width of 80–20% distal fall-off (W(80–20)) and peak-to-entrance ratio to represent Bragg peak characteristics. The obtained energy–range relationships were fitted into third-order polynomial formulae. The present study also used the GATE Monte Carlo code to calculate the stopping power of proton pencil beams in a water cubic phantom and compared results with the National Institute of Standards and Technology (NIST) standard reference database.

The study results revealed deeper penetration, broader FWHM and distal fall-off and decreased peak-to-entrance dose ratio with increasing beam energy. Study results for monoenergetic proton beams showed that R73 can be a good indicator to characterise a range of incident beams. These also suggest FWHM is more sensitive than W(80–20) distal fall-off in finding initial energy spread. Furthermore, the difference between the obtained stopping power from simulation and NIST data almost in all energies was lower than 1%.

Detail depth dose characteristics for monoenergetic proton beams within therapeutic energy ranges were reported. These results can serve as a good reference for clinical practitioners in their daily practice.

The unique behaviour of microbubbles under ultrasound acoustic pressure makes them useful agents for drug and gene delivery. Several studies have demonstrated the potential application of microbubbles as a non-invasive, safe and effective technique for targeted delivery of drugs and genes. The drugs can be incorporated into the microbubbles in several different approaches and then carried to the site of interest where it can be released by destruction of the microbubbles using ultrasound to achieve the required therapeutic effect.

The objective of this article is to report on a review of the recent advances of ultrasound-mediated microbubbles as a vehicle for delivering drugs and genes and its potential application for the treatment of cancer.

Ultrasound-mediated microbubble technology has the potential to significantly improve chemotherapy drug delivery to treatment sites with minimal side effects. Moreover, the technology can induce temporary and reversible changes in the permeability of cells and vessels, thereby allowing for drug delivery in a spatially localised region which can improve the efficiency of drugs with poor bioavailability due to their poor absorption, rapid metabolism and rapid systemic elimination.

Whole-breast external beam radiotherapy results in significant reduction in the risk for breast cancer-related death, but this may be offset by an increase in deaths from other causes and toxicity to surrounding organs. Partial breast irradiation techniques are approaches that treat only the lumpectomy area rather than the whole breast. Quality assurance in the radiation therapy treatment planning process is essential to ensure accurate dose delivery to the patient. For this purpose, this article compares the results from an anthropomorphic PRESAGE® dosimeter, radiation treatment planning system and from the GAFCHROMIC® EBT2 film.

A breast dosimeter was created and a three-field partial plan was generated in the Pinnacle3 treatment planning system. Dose distribution comparisons were made between Pinnacle3 treatment planning system, GAFCHROMIC® EBT2 film and PRESAGE® dosimeter. Dose–volume histograms (DVHs), gamma maps and line profiles were used to evaluate the comparison.

DVHs of gross tumour volume, clinical tumour volume and planning tumour volume for the PRESAGE® dosimeter and Pinnacle3 treatment planning system shows that both measured and calculated statistics were in agreement, with a value of 97.8% of the prescribed dose. Gamma map comparisons showed that all three distributions passed 95% at the ±3%/±3 mm criteria. Comparisons of isodose line distribution between the PRESAGE® dosimeter, EBT2 film and planning system demonstrated agreement, with an average difference of 1.5%.

This work demonstrated the feasibility of PRESAGE® to function as an anthropomorphic phantom and laid the foundation for research studies in PRESAGE®/optical-computed tomography three-dimensional dosimetry with the most complex anthropomorphic phantoms.

In this study, the differences between calculated and measured dose values were then analysed to assess the performance, in terms of accuracy, of the tested treatment planning system (TPS) algorithms applied to calculate electron beam dose targeted and non-targeted the breast region.

The beryllium oxide (BeO) dosimeters placed on the female RANDO phantom were irradiated 12 MeV electron energy with medical linear accelerator and repeatedly read in the Risø thermoluminescence (TL)/optically stimulated luminescence (OSL) system via OSL method at least three times.

For electron treatment, one made quantitative comparisons of the dose distributions calculated by TPSs with those from the measurements by OSL at various points in the RANDO phantom.

The mean dose measured from the dosimeters placed on the female RANDO phantom target left breast region was 160 cGy and non-target right breast region was 1·2 cGy. Analysis of Generalised Gaussian Pencil Beam (GGPB) and Electron Monte Carlo (eMC) algorithms for determined region mean point dose values, respectively, 174 and 164 cGy. Two algorithms for non-targeted region calculated same point dose values of 0·2 cGy.

The results of this study showed that BeO dosimeters can be used with OSL method in radiotherapy applications and it is a very important tool for the determination of targeted/non-targeted absorbed dose.

To investigate whether a radiographer-led radiotherapy pathway can provide an efficient service for patients requiring treatment for symptomatic skeletal metastases.

A retrospective review of 425 courses of palliative radiotherapy was conducted. Data was analysed assessing diagnosis, dose/fractionation, time from referral to treatment, gender, age, inpatient/outpatient status and referring clinic location for radiographer- and clinical oncologist-led cohorts.

Patients aged ≥70 years were more likely to be planned by radiographers (n = 162/57, p < 0·001). Patients were more likely to be treated with 8 Gy in single fraction than with 20 Gy in five fractions (n = 279/136, p = 0·012). The median referral to treatment time in 8-Gy single-fraction prescriptions was 3 days for radiographer-led versus 7 days for clinical oncologist-led cohorts. In all patients and in 20 Gy in five-fraction prescriptions, it was 4 versus 8 days. A comparison of all prescriptions (p < 0·001), 8 Gy in single-fraction (p < 0·001) and 20 Gy in five-fraction prescriptions (p = 0·001) showed radiographer-led procedures as enabling faster access to treatment in each category.

A radiographer-led service can facilitate faster access to treatment than a clinical oncologist-led pathway for an appropriately selected patient caseload.

We propose to use the PTV dose–volume factor (PDVF) to evaluate treatment plans of prostate volumetric modulated arc therapy (VMAT) and intensity modulated radiotherapy (IMRT).

PDVF was used to compare the variation of planning target volume (PTV) coverage between VMAT and IMRT because of weight loss of patient.

VMAT and IMRT plans of five patients (prostate volume = 32–86·5 cm3) using the 6 MV photon beams were created with the external contour reduced by depths of 0·5–2 cm to reflect the weight loss. Moreover, integral doses (volume integral of the patient dose) and prostate tumour control probability (TCP) were calculated.

We found that reduced depth resulted in PDVF decreasing 0·03 ± 4·7 × 10−4 (VMAT) and 0·04 ± 9·7 × 10−3 (IMRT) per cm for patients. The decrease of PDVF or degradation of PTV coverage was found more significant in IMRT plans than VMAT with patient size reduction. The integral dose did not change significantly between VMAT and IMRT, while the prostate TCP increased with an increase of reduced depth.

We concluded that PDVF can be successfully used to evaluate the variation of PTV coverage because of weight loss of patient in prostate VMAT and IMRT. Degradation of PTV coverage in prostate VMAT is less significant than IMRT regarding patient size reduction.

Current literature suggests the information and support needs of oncology patients undergoing radical radiotherapy to the prostate often remain unmet and can impact quality of life. We aimed to explore the effectiveness of delivery and opportunities for service improvement, including a group-based treatment review.

A total of 60 prostate patients completing radical radiotherapy (mean age 70, range 47–79) in a UK cancer-centre completed a self-designed questionnaire assessing information and support. To explore views on a group-based treatment review, 11% took part in a semi-structured interview. Descriptive data were computed and interviews transcribed and analysed thematically.

In all, 87% were satisfied with information and support when delivered by radiographers. However, 26% were only ‘sometimes’ able to complete bladder-filling, suggesting information regarding treatment delays would improve this. In total, 49% preferred both Doctor and Urology nurse reviews whereas 26% preferred nurse only; 70% stated their ‘concerns were always addressed’ by a nurse and 49% by a Doctor. Interviews revealed that a group review was generally acceptable with peer support an influencing factor.

Overall patients felt their needs were being met. Suggestions for improvement (more information on preparation, side effects and delays) will be implemented locally. Future work will explore the feasibility of group reviews in patients undergoing radical radiotherapy to the prostate.

To evaluate the dosimetric parameters of level II lymph nodes in chest wall three-dimensional conformal radiotherapy (3D-CRT) and intensity-modulated radiotherapy (IMRT) of mastectomy patients using dual-isocentric (DIT) and mono-isocentric techniques (MIT).

Computed tomography (CT) images of 20 mastectomy patients undergoing chest wall external radiotherapy were used as the input data for the abovementioned techniques. Selected dosimetric parameters were calculated for the axillary level I–III lymph nodes, chest wall, heart and lung. Paired t-test statistical analysis was used for comparing the results of MIT and DIT in both 3D-CRT and IMRT methods.

There were significant differences in Dmin (minimum dose), Dmax (maximum dose) and maximum–minimum dose between MIT and DIT techniques (13, −8·6, −52·2% differences for Dmin, Dmax and maximum–minimum, respectively) in IMRT. There were also significant differences for Dmean (mean dose), Dmax and maximum–minimum dose (7·8, −11·4, −44·6% differences in Dmean, Dmax and maximum–minimum, respectively) in 3D-CRT (p < 0·05). In addition, there were not any differences in the dosimetric parameters for heart, lung and level I and III lymph nodes.

In both 3D-CRT and IMRT methods, level II lymph node dose distribution in MIT was closer to the prescribed dose compared with DIT due to the position of these nodes in the field junction area. To achieve a better dose homogeneity, it could be recommended to use MIT instead of DIT in 3D-CRT and IMRT for mastectomy patients.

The main aim was to examine the effect of bit depth on computed tomography (CT) number for high-density materials. Analysis of the CT number for high-density materials using 16-bit scanners will extend the CT scale that currently exists for 12-bit scanners and thus will be beneficial for use in CT–electron density (ED) curve in radiotherapy treatment planning system (TPS). Implementation of this extended CT scale will compensate for tissue heterogeneity during CT–ED conversion in treatment planning.

An in-house built phantom with 10 different metal samples was scanned using 80, 100 and 120 kVp in two different CT scanners. A region of interest was set at the centre of the material and the mean CT numbers together with data deviation were determined. Dosimetry calculation was performed by applying a direct anterior beam on 12-bit, 12-bit extended and 16-bit.

High-density materials (>4·34 g cm−3) in 16-bit depth provide disparities up to 44% compared to Siemens’ 12-bit extended. Influence of tube voltage showed a significant difference (p<0·05) in both bit depth and CT number of the gold and amalgam saturated in 16-bit depth. A 120 kVp energy illustrated a low variation on CT number for different scanners, but dosimetry calculation showed significant disparities at the metal interface in 12-bit, 12-bit extended and 16-bit.

High-density materials require 16-bit scanners to obtain CT number to be implemented in treatment planning in radiotherapy. This also suggests that proper tube voltage together with correct CT–ED resulted in accurate TPS algorithm calculation.