The performance of the solid fuel ramjet is accurately predicted using full part simulation of this propulsion system, where the flow fields of the intake, combustion chamber, and the nozzle are numerically studied all together. The conjugate heat transfer is considered between the solid phase and the gas phase to directly compute the regression rate of the fuel. The finite volume solver of the compressible turbulent reacting flow is utilized to study the axisymmetric three dimensional flow fields, and two blocks are used to discretize the computational domain. It is shown that the combustion chamber's pressure is changed due to the fuel flow rate's increment which must be taken into account in predictions. The results demonstrate that omitting the pressure dependence of the regression rate and also the effect of the combustor's inlet profile on the regression rate, which specially exists when simulating the combustion chamber individually, under-predicts the solid fuel burning rate when the regression rate augmentation technique is applied to improve the performance of the solid fuel ramjets. It is also illustrated that using the inlet swirl to increase the regression rate of the solid fuel augments considerably the thrust level of the considered SFRJ, while the predictions without considering all parts of the ramjet is not accurate.

Installation effects on the S-duct intakes of a high power turboprop were investigated by comparing three different nacelle configurations as the channel wing, over-the-wing and conventional tractor wing using computational fluid dynamic methods. The interaction of the propeller, the wing, and the nacelle on the scoop type turboprop intakes were identified in terms of recovery and distortion on the aerodynamic interface planes. An actuator disc model was used to simulate the propeller downstream effects. The channel wing installation of S-ducts showed approximately 2% higher total pressure recovery than the other configurations. The channel wing configuration with a wrap-around S-duct experienced a 2% lower circumferential distortion intensity, whereas over-the-wing had an increase by 3% in comparison to the tractor wing. It was also observed that the S-duct type had a greater influence on the radial distortion intensity than the installation type. The swirl coefficient distribution showed that multiple peaks occurred as opposed to swirl results based on a single sector of the aerodynamic interface plane. The difference between swirl peaks of shaft penetration S-duct was reduced by 14% when installed on channel wing, whereas the peaks of wrap-around experienced 90° phase shift, and their difference showed 10% increase on channel wing.