The diffusion of water in Li-montmorillonite was studied by incoherent quasielastic neutron scattering. Experiments were carried out on sedimented samples equilibrated at relative humidities of 32%, 58%, and 98%, corresponding approximately to 1, 2, and 3 molecular layers of water in the clay. At all three humidities, although the mobility of the water molecules is less than in bulk water, all water molecules in the system undergo translational diffusion, at least over short distances (>5 Å), with correlation times shorter than 5 × 10−11 sec.

Various models of molecular motion have been used to account for the exact shape of the scattering. The only completely successful model is one where a water molecule undergoes jump-translational diffusion and rotational diffusion. The mean square jump length is 10–15 Å2 with a residence time between jumps of 4–2 × 10−11 sec. The translational diffusion coefficient increases with humidity, having values of 4, 7, and 10 × 10−10 m2/sec for the three humidities. These values can be combined with values previously obtained by tracer measurements to give an estimate of 0.75–0.8 for the tortuosity factor. Although the samples are anisotropic, there is no clear evidence that the diffusion of water over distances 5–20 Å is anisotropic. An upper limit of 3 can be deduced for the rate of diffusion parallel to the direction perpendicular to the platelets.

Clay samples from shales and bentonites in the Mancos Shale (Cretaceous) and its stratigraphic equivalents in the southern Rocky Mountain and Colorado Plateau have been analyzed by X-ray powder diffraction methods. The major clay in the shales is mixed layered illite/smectite, with 20–60% illite layers. The regional distribution of ordered vs. random interstratification in the illite/smectite is consistent with the concept of burial metamorphism in which smectite interlayers are converted to illite, resulting finally in ordered interstratification. The interstratification data correlate with other geologic information, including rank of coal and Laramide tectonic activity. In addition, contact metamorphism of the shale by Tertiary igneous intrusions produced a similar clay suite. Chemical variation within these shales (particularly the presence or absence of carbonate) affected the clay conversion reactions in the interbedded bentonites and the shale itself during the early stages of transformation. In extreme cases, shales and bentonites from a single outcrop may contain clays that range from pure smectite (calcareous shales) to ordered illite/smectite containing ⩾50% illite layers (noncalcareous shales). The use of mixed-layered illite/smectite compositions to infer thermal regimes, therefore, may be misleading unless allowance is made for local chemical controls.

Integrated intensities of the fundamental modes of vibrations of ammonium in heat-treated, NH4+-exchanged swelling minerals permits (1) a quantitative determination of the amount of tetrahedral substitutions of Si4+ by M3+ in dioctahedral smectites, and (2) an estimate of the degree of interlayer surface heterogeneity in trioctahedral minerals to be made. This is possible because NH4+ cations balancing the negative charge of tetrahedral sites that are not influenced by an excess positive charge of the octahedral layer have a symmetry lower (probably C3v) than the usual tetrahedral Td symmetry of NH4+. In C3v symmetry the ν1 band is infrared active whereas it is only Raman active in Td symmetry. Protons left after deammoniating dioctahedral smectites with tetrahedral substitutions form interlayer silanol groups, the stretching vibration of which give a band that is distinct from that of octahedral OH-stretching modes.

The dissolution of synthetic magnetite, maghemite, hematite, goethite, lepidocrocite, and akaganeite was faster in HCl than in HClO4. In the presence of H+, the Cl− ion increased the dissolution rate, but the ClO4− ion had no effect, suggesting that the formation of Fe-Cl surface complexes assists dissolution. The effect of temperature on the initial dissolution rate can be described by the Arrhenius equation, with dissolution rates in the order: lepidocrocite > magnetite > akaganeite > maghemite > hematite > goethite. Activation energies and frequency factors for these minerals are 20.0, 19.0, 16.0, 20.3, 20.9, 22.5 kcal/mole and 5.8 × 1011, 1.8 × 1010, 7.4 × 107, 5.1 × 1010, 2.1 × 1010, 3.0 × 1011 g Fe dissolved/m2/hr, respectively. The complete dissolution of magnetite, maghemite, hematite, and goethite is well described by the cube-root law, whereas that of lepidocrocite is not.

The sand and silt fractions of soils derived from Tertiary basalt in northeastern Ireland exhibit unusually high cation-exchange capacities. Smectite was identified by X-ray powder diffraction in all size fractions and was selectively dissolved by treatment with 1 N HCl and 0.5 N NaOH. Structural formulae, based on chemical analysis of the dissolved material, suggest that the smectite is intermediate in composition between a di- and a trioctahedral mineral and that the octahedral cation occupancy, together with the numbers of Mg and Fe atoms per unit cell, decreases with decrease in particle size of the soil fraction examined. The mean formula for the smectite in the clay separates is:

M+0.40(Si3.33Al0.67)(Al1.07Fe2+0.09 Fe3+0.41Mg0.82)O10(OH)2.

Similar analysis of smectite present in clay-size material separated from weathered basalt rock taken from the bases of the soil profiles showed that it had close to the full trioctahedral occupancy. It is suggested that the soil smectite is a weathering product of the trioctahedral smectite inherited from the weathered basalt.

Di-ethyl 2-hexylphosphoric acid (di-2 EHPA) was chemisorbed on kaolinite and smectite in decane solution. The resultant isotherms were of the Langmuir type and made possible the determination of limiting adsorption values of 12 mg/g and 23.8 mg/g on H+-kaolinite and H+-montmorillonite, respectively. The acidic phosphoric group of the di-2 EHPA molecule reacted in the anionic form (RO)2PO2− with the surface cations of the clay structures. Theoretical calculations, based on structural considerations, are in agreement with the experimental data and show that adsorption took place at the rate of one alkylphosphate anion per surface cation if the phyllosilicate was dioctahedral (e.g., montmorillonite and kaolinite). If the phyllosilicate was trioctahedral (e.g., hectorite), adsorption took place at the rate of two di-2 EHPA molecules for three surface cations. Spectroscopic investigations performed with visible, ultraviolet, and infrared radiation confirmed the formation of salts or surface complexes.

Intercalation compounds of styrene and quaternary ammonium montmorillonite were prepared by immersion of the clay in styrene monomer. The intercalation of stearyltrimethylammonium (CH3(CH2)17N(CH3)3+)-montmorillonite and styrene showed an expansion of the basal spacing to a constant value of ∼32 Å after immersion for 10 days. After polymerization, the amount of polystyrene in the interlayer region was determined by thermal gravimetric analysis. Styrene adsorption initially increased with increasing quaternary ammonium cation and then became approximately constant when loading of the quaternary ammonium cation exceeded 100 meq/100 g clay. The volume resistivity of the stearyltrimethylammonium-montmorilionite-polystyrene complex, which was determined with a high resistance meter, was greater than that of both the quaternary ammonium-montmorillonite and the montmorillonite, and increased in proportion to the amount of polymer adsorbed. These data indicate that polystyrene improved the insulating properties of the clay films.

The immobilization of soluble Cs from spent fuel elements by ion exchange and direct chemical reaction with clay minerals or shales was investigated under hydrothermal conditions. Various clay minerals or shales were reacted with likely Cs sources and water at 300 bars pressure and 100°, 200°, and 300°C for 4, 2, and 1 months, respectively. Pollucite was the principal product, but CsAlSiO4 was also observed, along with unreacted or hydrothermally altered aluminosilicates. From Cs concentrations of the product solutions partition of Cs between liquid and solids was found to vary depending on the Cs source, the clay or shale phase, temperature, and run duration. For example, illite-Cs2MoO4 interactions resulted in 19, 32, and 95% fixation of added Cs at 100°, 200°, and 300°C respectively. Fixation of as much as 97% of the Cs in some solids was observed. In addition to Cs-aluminosilicates, Cs was fixed on cation-exchange sites by interlayer collapse in montmorillonite. Reactions with Cs2MoO4 also produced powellite because Ca was available in the reaction mixture. The U6+ from β-Cs2U2O7 was reduced to form uraninite by sulfide- and/or organic-rich shales. (Cs,Na)2(UO2)(Si2O5)3·4H2O, an analog of weeksite, was produced in reactions with β-Cs2U2O7. The reaction products pollucite and uraninite can immobilize much of the Cs and U from spent fuel elements because Cs in pollucite is extremely difficult to exchange and U in uraninite is insoluble.

Mineralogy, O18/O16, and D/H ratios have been determined in five size fractions (<0.1, 0.1–0.5, 0.5–1.0, 1.0–2.0, and >2.0µm) of seven samples taken from 500 m of Pleistocene deep-sea sediments cored at Deep Sea Drilling Project Site 180 in the Aleutian Trench. The depositional age of the samples spans the last 300,000 years; the samples have been interpreted by others to be continental detritus weathered from a mixed igneous, metamorphic, and sedimentary source area and then deposited by ice-rafting and turbidity currents. The minerals present are quartz, feldspar, illite, chlorite and/or non-expandable vermiculite, and expandable vermiculite and/or mixed-layer illite/expandable vermiculite. The relative amounts of quartz, feldspar, and total clay vary with particle size, but are nearly constant from sample to sample for a given particle size. δO18 is values of the four coarser size fractions range from +9.7 to +12.0‰ with variations attributable to changes in quartz/feldspar and clay/(quartz + feldspar) abundances. Values of δO18 for the expandable vermiculite-rich <0.1-µm size fraction range from +12.1 to +16.3‰ which indicates some oxygen isotope exchange at surface temperatures between meteoric waters and the parent rock during vermiculite formation. Values of δD range from −46 to −74‰ with variations attributable to changes in amounts of different clay minerals present. There is no mineralogic or isotopic evidence of post-depositional reactions in the coarser size fractions, but a general change in δD of the vermiculite-rich, <0.1-µm size fraction from about −50‰ to about −70‰ with increasing depth may be due either to post-depositional isotopic exchange or to climatic changes in the terrestrial weathering environment.