Collagen extraction depends on the state of bone preservation, and the acidity of Brazilian soils often prevents the use of this material for radiocarbon dating. When available, however, bone samples constitute very important chronological records for both archaeological sites and natural depositional sites of specific animals. The extraction of collagen was performed using two filters, the first aiming to remove insoluble contaminants, and the second, a vivaspin ultrafilter 30KD to retain large molecular weight materials. The collagen was liofilized and converted to CO2 by combustion in sealed quartz tubes with CuO and Ag. The graphite was produced by zinc reduction in independently sealed Pyrex™ tubes. In order to verify the accuracy of this protocol, we analyzed a modern bone and four previously dated fragments, including those from the Sixth International Radiocarbon Intercomparison (SIRI), and a fragment of human bone from the Amourins site, a Brazilian shellmound. The results for the known age material are in agreement with the expected and the studied sector of Amourins shellmound was dated 4100–3900 years cal BP from a chronological model performed with charcoal dating found in different stratigraphic layers. Samples were dated at the radiocarbon laboratory of Universidade Federal Fluminense (LAC-UFF) in Brazil.

Human milk oligosaccharides, such as 2′-fucosyllactose (2′-FL), and galacto-oligosaccharides (GOS), a prebiotic carbohydrate mixture, are being increasingly added to infant formulas, necessitating the understanding of their impact on the oral microbiota. Here, for the first time, the effects of 2′-FL and GOS on the planktonic growth and adhesion characteristics of the caries-associated oral pathogen Streptococcus mutans were assessed, and the results were compared against the effects of xylitol, lactose and glucose. There were differences in S. mutans growth between 2′-FL and GOS. None of the three S. mutans strains grew with 2′-FL, while they all grew with GOS as well as lactose and glucose. Xylitol inhibited S. mutans growth. The adhesion of S. mutans CI 2366 to saliva-coated hydroxyapatite was reduced by 2′-FL and GOS. Exopolysaccharide-mediated adhesion of S. mutans DSM 20523 to a glass surface was decreased with 2′-FL, GOS and lactose, and the adhesion of strain CI 2366 strain was reduced only by GOS. Unlike GOS, 2′-FL did not support the growth of any S. mutans strain. Neither 2′-FL nor GOS enhanced the adhesive properties of the S. mutans strains, but they inhibited some of the tested strains. Thus, the cariogenic tendency may vary between infant formulas containing different types of oligosaccharides.

The hydroxyapatite nanoparticles (nHAPs) were synthesized rapidly by the self-assembled dual-frequency ultrasonic method. The ultrasonic time and power effect on the morphology and phase composition of nHAPs were investigated through field-emission scanning electron microscopy (FE-SEM), X-ray diffraction, energy dispersive spectrometer (EDS) spectrometer, and Fourier transform infrared spectroscopy, which showed that the most uniform nanoparticles were obtained when the ultrasonic time was 30 min and the ultrasonic power was 280 W. Cytotoxicity and hemolysis tests showed that an indistinctive cytotoxic effect was within the concentration of 25–400 μg/mL and the hemolytic ratio was below 2.0% at concentration of 25–200 μg/mL, respectively, revealing a good biocompatibility of nHAPs. By loading tetracycline hydrochloride onto nHAPs spheres, the drug release results showed that the drug loading and encapsulation efficiency were (26.34 ± 2.99)% and (52.68 ± 5.98)%, respectively. The drug-loaded sample shows a slow-release property, indicating that nHAPs may be promising as drug carriers.

Calcium phosphate derivatives have been widely employed in medical and dental applications for hard tissue repair, as they are the main inorganic constitution of hard tissue; such as bones and teeth. Owing to their excellent osteoconductive and bioactive properties, hydroxyapatite- (HA) based ceramics are the best candidates of this group for medical, bioscience, and dental applications. However, when replacing a bone or tooth, HA is not able to sustain similar mechanical properties. In this study, to improve the mechanical properties, nanoscale hexagonal boron nitride with different compositional percentages was added to the nano HA to form composites. The effect of compositional changes and sintering parameters on microstructural and morphological properties of the ceramic composites was comparatively investigated. Detailed chemical characterization of the composite materials was carried out using X-ray diffraction, Fourier transform infrared spectroscopy, Raman spectroscopy, and energy-dispersive X-ray spectroscopy, whereas scanning electron microscopy and atomic force microscopy investigations were employed to monitor morphological and surface features. Additional transmission electron microscopy investigations were carried out to reveal the nanostructure and crystal structure of the composites.

Angstrom resolution images of human tooth enamel (HTE) crystallites were obtained using aberration-corrected high-resolution transmission electron microscopy and atomic-resolution scanning transmission electron microscopy in the modes of bright field, annular dark field, and high-angle annular dark-field. Images show that the central dark line (CDL) defect observed around the center of the HTE crystals is a site for caries formation in the HTE and has a thickness of ~0.2 nm. Results also suggest that the CDL goes through one of the OH− planes.

The surface properties of hydroxyapatite, including electric charge, can influence the biological response, tissue compatibility, and adhesion of biological cells and biomolecules. Results reported here help in understanding this influence by creating charged domains on hydroxyapatite thin films deposited on silicon using electron beam irradiation and investigating their shape, properties, and carbon contamination for different doses of incident injected charge by two methods. Photoluminescence laser scanning microscopy was used to image electrostatic charge trapped at pre-existing and irradiation-induced defects within these domains, while phase imaging in atomic force microscopy was used to image the carbon contamination. Scanning Auger electron spectroscopy and Kelvin probe force microscopy were used as a reference for the atomic force microscopy phase contrast and photoluminescence laser scanning microscopy measurements. Our experiment shows that by combining the two imaging techniques the effects of trapped charge and carbon contamination can be separated. Such separation yields new possibilities for advancing the current understanding of how surface charge influences mediation of cellular and protein interactions in biomaterials.

Remineralization of hard dental tissues is thought to be a tool that could close the gap between prevention and surgical procedures in clinical dentistry. The purpose of this study was to examine the remineralizing potential of different toothpaste formulations: toothpastes containing bioactive glass, hydroxyapatite, or strontium acetate with fluoride, when applied to demineralized enamel. Results obtained by scanning electron microscopy (SEM) and SEM/energy dispersive X-ray analyses proved that the hydroxyapatite and bioactive glass-containing toothpastes were highly efficient in promoting enamel remineralization by formation of deposits and a protective layer on the surface of the demineralized enamel, whereas the toothpaste containing 8% strontium acetate and 1040 ppm fluoride as NaF had little, if any, remineralization potential. In conclusion, the treatment of demineralized teeth with toothpastes containing hydroxyapatite or bioactive glass resulted in repair of the damaged tissue.

Electron Rutherford backscattering (ERBS) is a new technique that could be developed into a tool for materials analysis. Here we try to establish a methodology for the use of ERBS for materials analysis of more complex samples using bone minerals as a test case. For this purpose, we also studied several reference samples containing Ca: calcium carbonate (CaCO3) and hydroxyapatite and mouse bone powder. A very good understanding of the spectra of CaCO3 and hydroxyapatite was obtained. Quantitative interpretation of the bone spectrum is more challenging. A good fit of these spectra is only obtained with the same peak widths as used for the hydroxyapatite sample, if one allows for the presence of impurity atoms with a mass close to that of Na and Mg. Our conclusion is that a meaningful interpretation of spectra of more complex samples in terms of composition is indeed possible, but only if widths of the peaks contributing to the spectra are known. Knowledge of the peak widths can either be developed by the study of reference samples (as was done here) or potentially be derived from theory.

Mineralized dental tissues and dental pulp were characterized using advanced analytical transmission electron microscopy (TEM) methods. Quantitative X-ray energy dispersive spectroscopy was employed to determine the Ca/P and Mg/P concentration ratios. Significantly lower Ca/P concentration ratios were measured in peritubular dentine compared to intertubular dentine, which is accompanied by higher and variable Mg/P concentration ratios. There is strong evidence that magnesium is partially substituting calcium in the hydroxyapatite structure. Electron energy-loss near-edge structures (ELNES) of C-K and O-K from enamel and dentine are noticeably different. We observe a strong influence of beam damage on mineralized dental tissues and dental pulp, causing changes of the composition and consequently also differences in the ELNES. In this article, the importance of TEM sample preparation and specimen damage through electron irradiation is demonstrated.

In this study the structure of collagen-chondroitin sulphate-hydroxyapatite porous composites is investigated by histochemical (Von Kossa staining), immunohistochemical, and transmission electron microscopy. Examination of composites on picrosirius red stained sections showed that polarization colors of collagen were generally in the range of orange-red. Immunofluorescence data indicate that chondroitin sulphate was either chemically incorporated into the bulk structure of collagen scaffolds or attached on surfaces of collagen bundles. Depending on the ratio between collagen:chondroitin sulphate:hydroxyapatite, von Kossa histochemical staining showed a progressive loading of collagen-chondroitin sulphate bundles with hydroxyapatite. Transmission electron microscopy studies have shown that composites contain mostly collagen fibrils aggregated with random orientation with very few collagen fibers showing the 67-nm banding pattern. Hydroxyapatite deposits of various sizes occurred among the collagen fibrils.

Crystalline properties of synthetic nanostructured hydroxyapatite (n-HA) were studied using high-resolution transmission electron microscopy. The focal-series-restoration technique, obtaining exit-plane wavefunction and spherical aberration-corrected images, was successfully applied for the first time in this electron-beam-susceptible material. Multislice simulations and energy dispersive X-ray spectroscopy were also employed to determine unequivocally that n-HA particles of different size preserve stoichiometric HA-like crystal structure. n-HA particles with sizes of twice the HA lattice parameter were found. These results can be used to optimize n-HA sinterization parameters to improve bioactivity.

The obtention of hydroxyapatite (HAp) is reported using brushite (CaHPO4·2H2O) and the skeleton of a starfish (Mellita eduardobarrosoi sp. nov.), primarily composed of magnesian calcite ((Ca,Mg)CO3) as precursors. Stoichiometric amounts of both were reacted under hydrothermal conditions: a pressure of 5.8 MPa and a temperature of 200°C for 2, 4, 6, 8, 10, and 20 h of reaction times. The samples obtained were characterized by means of scanning electron microscopy, X-ray diffraction, infrared spectroscopy, and transmission electron microscopy. Two defined populations of HAp fibers were found: A bundle of fibers 75 μm in length and 1–13 μm in diameter, and a second bundle of fibers 5 μm in length and less than 0.5 μm in diameter. Furthermore, an increase in HAp formation and a Ca/P ratio as a function of reaction time were observed. The growth mechanism of HAp is also discussed.

An energy dispersive x-ray microanalysis study was performed throughout the total length of cementum on five impacted human teeth. Mineral content of calcium, phosphorous, and magnesium were determined with an electron probe from the cemento-enamel junction to the root apex on the external surface of the cementum. The concentration profiles for calcium, phosphorous, and magnesium were compared by using Ca/P and Mg/Ca atomic percent ratio. Our findings demonstrated that the Ca/P ratio at the cemento-enamel junction showed the highest values (1.8–2.2). However, the area corresponding to the acellular extrinsic fiber cementum (AEFC) usually located on the coronal one-third of the root surface showed a Ca/P media value of 1.65. Nevertheless, on the area representing the fulcrum of the root there is an abrupt change in the Ca/P ratio, which decreases to 1.3. Our results revealed that Mg2+ distribution throughout the length of human cementum reached its maximum Mg/Ca ratio value of 1.3–1.4 at.% around the fulcrum of the root and an average value of 0.03%. A remarkable finding was that the Mg/Ca ratio pattern distribution showed that in the region where the Ca/P ratio showed a decreasing tendency, the Mg/Ca ratio reached its maximum value, showing a negative correlation. In conclusion, this study has established that clear compositional differences exist between AEFC and cellular mixed stratified cementum varieties and adds new knowledge about Mg2+ distribution and suggests its provocative role regulating human cementum metabolism.

Both hydroxyapatite (Ha) and titanium (Ti) are well-accepted alloplastic materials for ossicular prostheses. Many different designs of Ha and Ti prostheses are presently available. Fourteen surgeons of different seniority and surgical experience were asked to ‘test-drive’ four different types of ossicular prostheses in cadaveric temporal bones to investigate the user-friendliness of these protheses. The Goldenberg design Ha incus prosthesis and the Dusseldorf design Bell Ti prosthesis were used as partial ossicular replacement prostheses (PORP). The Richards design Ha incus-stapes prosthesis and the Dusseldorf design Aerial Ti prosthesis were used as a total ossicular replacement prostheses (TORP). Nine out of 14 surgeons found the Ha PORP to be more user-friendly because of the notch design in the head. The Ti prosthesis was found to be more difficult to manipulate because it was too light. Half of the surgeons preferred the Ti TORP because of the open design of the top-plate. The Ha TORP was thought to be too top-heavy and to have a tendency to fall over.

Fifty-five consecutive patients undergoing a short-stay ophthalmic operation (orbital hydroxyapatite implantation) were recruited over 1 year to assess the frequency and duration of post-operative nausea and vomiting over 7 days. The incidence of nausea and vomiting in hospital was recorded. Patients scored their nausea and vomiting four times daily at home. By the end of the first day after surgery, 31 (75%) patients had experienced mild to severe nausea. Eighteen (38%) patients became nauseated on five or more occasions. Nineteen (35%) patients had vomited by the end of the first day after surgery and, over 7 days, 24 (43%) patients had vomited on one or more occasion. Three patients reported that they had vomited during the journey home. Vomiting was not correlated with pain or a past history of post-operative nausea and vomiting. However, there was a statistically significant correlation between nausea and pain. The high incidence of nausea and vomiting observed in this study appears to provide additional evidence of an oculo-emetic reflex. The timing of discharge and appropriate patient education are discussed.