The pH of Na-saturated, carbonate-containing and carbonate-free Leda clay, at salinities of 2 and 10 g/liter, was decreased from pH 8 to 4 by the addition of HCl. The Bingham yield stress, as determined with a coaxial viscometer, increased in all materials as the pH decreased. Above about pH 7 the 2-g/liter materials had a lower yield stress at any water content than the 10-g/liter materials, whereas, below about pH 6.8 the yield stress of the carbonate-containing soil at a salinity of 10 g/liter was lower. For the carbonate-free material, the change occurred at about pH 6.2. The influence of salinity on the remolded shear strength of these materials was pH-dependent. A yield stress increase with decreasing pH was likely due to a change in ion saturation. The carbonate-free material exhibited a maximum yield stress at about pH 5.5–6.2, depending on salinity. The isoelectric points for oxides and clay mineral edges most probably account for the existence of the maximum.

The rheological behavior of concentrated lateritic suspensions from Cuba is affected by mineral composition and particle size. Electrophoretic mobility and yield stress were considered. The lateritic samples were found to be mostly composed of mixtures of serepentine and goethite in varying proportions. The flow properties of the lateritic suspensions are strongly affected by the mineral composition and particle size. This result was determined by comparison of flow properties of the bulk sample and the colloidal fraction. The electrokinetic curves suggest that heterocoagulation is present in all samples, with a zeta potential minimum at the isoelectric point (IEP), which varies with the serpentine to goethite ratio. A relationship between yield stress (τ0) and the sample volume fraction (ϕ) and particle size (d) was obtained at the IEP from the expression τ0 = kϕ3/d0.5, with the constant k dependent on the sample serpentine to goethite ratio.

The influence of dissolved species and particle morphology on the electrokinetic behavior and the initial yield stress values of Cuban lateritic aqueous suspensions was studied. The lateritic samples were mixtures of serpentine and goethite in different relative proportions. The addition of silicate and Mg ionic species, which are normally found in natural waters used in industrial processes, affected the electrokinetic and flow behavior of the lateritic suspensions. Specific adsorption of these species on particle surfaces was shown by a shift of the isoelectric point and the maximum of the initial yield stress to more acidic pH (Si ionic species adsorption) and more basic pH (Mg ionic species adsorption), when compared to suspensions containing only non-adsorbing electrolytes. The initial yield-stress values determined in samples consisting entirely of goethite varied from sample to sample. A detailed crystallochemical characterization revealed that these changes were associated with the axial ratio (i.e. ratio of particle length to width) of the mineral particles. Goethite samples with larger particle size (smaller number of particles for a given solid concentration) and greater axial ratios presented initial yield-stress values greater than those goethites with smaller particle size and lower axial ratio.

The effects of pH and ionic strength on the rheological behavior of aqueous suspensions of both crude and purified Wyoming bentonite and natural interstratified illite-smectite from Tunisia were investigated. Flow tests were performed on the four clay suspensions at a 10% clay concentration at different pH values. They showed that the rheological properties were highly sensitive to pH and the nature of the clay. The evolution of the yield stress as a function of pH is characterized by the presence of maxima and minima attributed to changes in the mode of association of the particles. The effect of pH on the behavior of clay suspended in NaCl solutions was also studied. The results show that the presence of NaCl has very little effect on the pH and yield stress values of the four materials.

CaMnt is much less important than NaMnt due to its limited commercial applications. The time-dependent property of NaMnt gel has been studied extensively as it is exploited in many applications such as drilling mud and viscosity-modifier applications. In contrast, the time-dependent property of CaMnt suspension and the factors affecting it are largely unknown. The speciation of Ca2+ ions is one such factor to be evaluated. In the current study, pH and solids concentration were examined and then used to validate a recent theory on clay gel time dependency. The results supported the theory that a strong electrostatic double layer (EDL) repulsion in the 3-D network is needed to reorganize the structure and drive it toward the state of minimum free energy. The 12 wt.% CaMnt (STx-1b) gel displayed time-dependent behavior at pH 5 but not at its natural pH of 8.4. At pH 5, the interlayer Ca2+ ions became fully hydrated and desorbed from the platelet surface. This enhanced the EDL repulsion between the platelets. At pH >6.5, the positively charged hydrolysis product Ca(OH)+ began to form and was adsorbed, partially neutralizing the permanent layer charge and weakening the repulsion. However, at 19.4 wt.% solids, the gel displayed pronounced time-dependent behavior despite the high natural pH of 8. The platelets were much closer together, allowing the EDL force to operate and effect structural reorganization. The microstructure of these CaMnt gels showed high platelet concentrations interacting to form a relatively open structure. The microstructure of a kaolin (KGa-2) suspension which showed no time-dependent behavior even after 1 day of ageing revealed the importance of particle morphology and layer charge on time dependency. Its 3-D structure was formed by relatively thick, layered platelets with a low layer charge.

The zeta potential and yield-stress behaviour of gels prepared from as-received SHCa-1 hectorite (Ht) containing 50 wt.% impurities, mainly of calcite, dolomite and quartz, were characterized. The zeta potential is negative in the pH range 4–12. At pH <5, reaction of CaCO3 producing CO2 and Ca2+ increased the solution conductivity significantly and reduced the zeta potential. The buffering effect due to this chemical reaction was also observed in the yield stress–pH characterization below pH 8. Low yield stress was observed below pH 6 and above pH 12. The yield stress peaked at pH ~8, where Ht displayed a zeta potential of –20 mV. The relationship between maximum yield stress and Ht content (wt.%) was linear and was not affected by impurities. The ageing behaviour was characterized by an initial phase of rapid yield-stress increase and then by a phase of gradual increase. The Leong model performed better than the two-parameter glassy polymer ageing model in describing this ageing behaviour. However, the empirical power law model was more accurate. The timescale of the ageing process is long, lasting several days. An open cellular microstructure was observed to form in the gels. Impurities appeared not to interact with or bind to the Ht platelets.

A new two-phase model for concentrated suspensions is derived that incorporates a constitutive law combining the rheology for non-Brownian suspension and granular flow. The resulting model exhibits a yield-stress behaviour for the solid phase depending on the collision pressure. This property is investigated for the simple geometry of plane Poiseuille flow, where an unyielded or jammed zone of finite width arises in the centre of the channel. For the steady states of this problem, the governing equations are reduced to a boundary value problem for a system of ordinary differential equations and the conditions for existence of solutions with jammed regions are investigated using phase-space methods. For the general time-dependent case a new drift-flux model is derived using matched asymptotic expansions that takes into account the boundary layers at the walls and the interface between the yielded and unyielded region. The drift-flux model is used to numerically study the dynamic behaviour of the suspension flow, including the appearance and evolution of an unyielded or jammed regions.

To determine whether plastic-hardening behavior occurs in metal nanowires, an atomistic simulation was performed to investigate the tension process in a bicrystal Cu nanowire. The results indicate that bicrystal Cu nanowires exhibit strain-hardening behavior, unlike their single-crystal counterparts. The strain-hardening behavior is related to the orientation of two crystal grains, and the number of atoms determines whether strain-hardening behavior occurs in the asymmetrically tilted bicrystal Cu nanowires. Strain hardening occurs in almost bicrystal Cu nanowires with different orientation angles. The initial yield stress is determined by the grain whose orientation angle is closer to 45° among the two crystal grains, resulting in a high value of the tilting tendency factor, and thus making it easier to generate slip.

The displacement of a plastic fluid by an elastic disc approaching a plane rigid surface oriented perpendicular to the disc axis is computed with a numerical scheme accounting for the coupled deformation of the disc and flow of plastic. The axial force to push the disc is in agreement with lubrication theory approximation. The existence of un-yielded fluid situated at the corners of the fluid region on the centre-line have been predicted, similar to the case observed for rigid disc squeeze flow.