To understand and predict the effects of a thermal pulse induced by a radioactive waste repository on clinoptilolite-bearing rocks, the lattice parameters of 6 natural and 3 cation-exchanged (Ca, K, Na) clinoptilolites were studied as a function of temperature. The samples were examined at room temperature, under vacuum, and at 50°C increments to 300°C using a high-temperature X-ray powder diffractometer. The unit cell of all samples decreased in volume between 20° and 300°C Na-saturated clinoptilolite underwent the greatest volume decrease (8.4%) and K-saturated clinoptilolite the smallest (1.6%), of the clinoptilolites studied. The volume decrease for the Ca-saturated clinoptilolite was 3.6%. The highest percentage decrease for each sample was along the b axis, generally 80–90% of the total volume decrease. The change in the a axis was the smallest and was usually <5%, although 26.5% of the contraction of the Na-exchanged clinoptilolite was along a. The bulk of the volume contraction of many samples occurred on evacuation at room temperature, demonstrating that the observed changes were due to water loss and not to temperature-induced structural changes. Low-angle scattering was significantly reduced upon evacuation for every sample, and the 110 reflection of clinoptilolite at 7.45°2θ became obvious, whereas it was not in the untreated samples.

These data show that the effects of heating on the unit-cell volume of clinoptilolite depend strongly on the exchangeable cation content. Significant reductions in the unit-cell volumes of natural, mixed Na-K-Ca clinoptilolites could take place in rocks in a repository environment, particularly if the clinoptilolites occurred in unsaturated, dehydrated rock. The unit-cell volumes of clinoptilolites in partially saturated rocks at temperatures below 100°C, however, should not decrease significantly.

A corrensite from Taro Valley, Italy, was studied by infrared analysis at different temperatures in the natural state and after exchange with seven different cations. The vibrational bands in the OH-stretching region can be divided into three main absorption regions: 3690-3640, 3580-3560, and 3500-3000 cm−1. The influence of the cation hydration water was observed in the third region only, whereas the intensity, frequency, and shape of the residual bands were not related to the nature of the exchangeable cations. The bands of region I were unaffected by heating the sample to 500°C; however, those in regions II and III were destroyed. Deuteration was not observed for any of the three OH-stretching regions. The dichroic behavior of the OH-stretching bands in the three regions were relatively affected by the exchangeable cations. Generally, the bands in region I exhibited a more dichroic behavior than those in regions II and III.

From the IR data corrensite appears to consist of: (1) a trioctahedral silicate layer with an OH-stretching band at about 3685 cm−1, (2) a hydroxide layer with OH-stretching bands at about 3570 and 3420 cm−1, and (3) a distinct interlayer space that is not interstratified with the hydroxide layers.

A laboratory study of the hydraulic conductivity (HC) of a marine clay with monovalent, divalent and trivalent cations revealed large differences in HC. The exchangeable cations employed in this study are Na, K, NH4, Mg, Ca and Al in order of increasing valency. An interpretation of the results derived from consolidation tests suggests that HC is significantly affected by the valency and size of the adsorbed cations. An increase in the valency of the adsorbed cations leads to quicker rates of consolidation and higher HC, while, for a constant valency an increase in the hydrated radius of the adsorbed cations results in a lower rate of consolidation and HC. The reduction in HC was related to the dispersion and deflocculation of clay. Lower valency and higher hydrated radii of the exchangeable cations enable the double layer repulsive forces to predominate, thereby increase dispersion and deflocculation.

An environmental infrared microbalance (EIRM) cell was used to study H2O sorption on two montmorillonite samples as a function of water content and type of exchangeable cation. The vibrational spectra showed that H2O sorbed to the clay at low-water content was strongly influenced by the exchangeable cation and by the close proximity to the clay surface. At water contents <6 H20 molecules per exchangeable cation, the H-O-H bending mode of H2O (v2 mode) shifts to a lower frequency and is characterized by an increase in molar absorptivity. In contrast, the positions of the asymmetric and symmetric OH-stretching modes of sorbed water (v1 and v3 modes) shift to higher energies. These observations indicate that H2O molecules sorbed to the clay surface at low-water content are less hydrogen bonded than in bulk H2O. In addition, the vibrational-stretching and bending bands of the structural OH groups of the 2:1 layer are also strongly influenced by H2O content and type of exchangeable cation. By using the EIRM cell, the molar absorptivities of the structural OH-bending vibrations were measured as a function of H2O content. The position and molar absorptivity of the structural OH-bending bands at 920, 883, and 840 cm-1 are strongly influenced by H2O content and type of exchangeable cation. The molar absorptivity of the 920-cm-1 band, which is assigned to the AlAlOH group, decreased strongly at low-H2O content. This reduction in intensity is assigned to a dehydration-induced change in orientation of the structural OH groups resulting from the penetration of H2O molecules into siloxane ditrigonal cavities that are not associated with a net negative charge from isomorphous substitutions.

The objective of this study was to observe flocculation of montmorillonite in the presence of a glucose polymer (dextran) and to observe the effect of saturating cation and coagulant addition on the flocculation process. Flocculation of montmorillonite was dependent on polymer molecular weight, polymer/clay ratio (w/w), nature of exchangeable cation, and ionic strength of the suspension to which the polymer was added. The T500 dextran (molecular weight = 5 × 105) caused enhanced sedimentation of Ca-montmorillonite suspension at a polymer/clay ratio of ≤0.01. Increasing the polymer concentration above this level stabilized the suspension such that sedimentation was less than or equal to that of the control. The T2000 dextran (molecular weight = 2 × 106) caused a similar increase in the sedimentation of Ca-montmorillonite at polymer/clay ratios of <0.1. The ability of the T2000 polymer to cause flocculation at greater polymer/clay ratios as compared to the T500 polymer was attributed to the lower osmotic pressure between clay particles for equal concentrations of the two polymers. Flocculation of Ca-montmorillonite by dextran was enhanced when the clay had initially been coagulated by the addition of salt. Reduction of the diffuse double layer upon addition of salt permitted the polymer to extend beyond the electrostatic barrier of the clays. Dextran was not able to flocculate Mg-montmorillonite suspensions with or without the presence of coagulant. The displacement of water molecules at the clay surface rather than within the hydration shell of the more highly polarizing Mg cations by polymer segments resulted in a greater polymer collapse on the clay surface leaving fewer and shorter polymer loops and tails available for contacting adjacent clay particles.

This paper aims at characterizing the morphology, texture, and microstructure of three hydrated kaolin rich clays (f < 0.2 μm) from volcanic soils. These clays represent a weathering sequence in which CEC, halloysite content with respect to kaolinite, as well as smectite content in the halloysite-smectite mixed-layer clays decrease with increased weathering. The clay samples were made homoionic (K+ or Mg2+) and hydrated under a low suction pressure (3.2 kPa). After replacing water by a resin, ultrathin sections were cut and examined by TEM. Particle shape varies with increased weathering, as follows: spheroids → tubes → platelets. Higher aggregation and dispersion are observed by TEM after Mg2+ and K+ saturation, respectively, at two levels of the clay-water system organization: intraparticle and interparticle. The microstructure variations induced by the nature of the exchangeable cation become less pronounced with decreasing layer charge of the 2:1 layers. They are thus related here to the presence of smectite layers localized in the halloysite habitus, mostly at the particle periphery. These results show that small amounts of smectite largely affect the organization of clays rich in kaolins at a high water content, and that K+ behaves here as a dispersing ion.

Organic, ionic soil stabilizers (OISS) are designed to regulate directly the hydration properties of clay minerals to improve their engineering behavior. The steps involved in this regulation by OISS are unclear and this might limit their application in the current construction environment in China. The purpose of the present study was to reveal the origin of changes in hydration properties of four typical clay samples (with clay mineral contents of >90 wt.%: Na-bentonite, Ca-bentonite, illite, and kaolinite) as affected by OISS. The water-retention capacity of each clay was measured first through liquid limit and water-vapor adsorption tests. Then, the changes in hydration sites, such as exchangeable cations and the surfaces of minerals, were investigated by a series of microscopic measuring and testing techniques. Finally, infrared spectroscopy (IR) and thermal analysis were performed to verify the regulation of hydration properties by OISS. The results suggested that the exchangeable cation and surface changes controlled the regulation of hydration properties. OISS could cause some of the exchangeable cations to become free ions and disrupt the interaction between some cations and water molecules by its long organic chains; thus, the amount of hydrated cations decreased. In addition, the long organic chains covered the mineral surface and weakened its adsorption capacity. Furthermore, the long chains had cementitious qualities, connecting them to the crystalline layer and resulting in more aggregated clay particles and a smaller specific surface area (SSA). With the decrease in the number of cations and in the SSA by OISS, the hydration of the four clay samples decreased, especially in the case of bentonite.

The rheological characteristics of purified bentonite suspensions as a function of exchangeable cation $({\text{Ca}}^{2+},{\text{NH}}_4^{+},{\text{Li}}^{+})$$({\rm{C}}{{\rm{a}}^{2 + }},{\rm{NH}}_4^ + ,\;{\rm{L}}{{\rm{i}}^ + })$ are studied at three different clay concentrations (40 gL−1, 60 gL−1, 80 gL−1). A Herschel-Bulkley model is used to determine rheological parameters such as yield value, consistency and fluidification index. The flow curves are typical for shear thinning fluids but differ on two points; presence of yield stress and/or thixotropy. The Li suspensions are not yield stress fluid, and the thixotropy is weakly expressed only for the 80 gL−1 suspension. On the contrary, Ca-clay suspension flow curves always present yield stress and a large thixotropic area. The NH4-clay suspensions exhibit an intermediate behavior as there is no thixotropy, but a yield stress appears for the most concentrated suspension. These differences in macroscopic mechanical properties are discussed with reference to the suggested microscopic clay organization in suspension.

The Kawasaki and Dobuyama bentonite deposits in northeastern Japan show contrasting properties even though they are only 5 km apart in a sequence of Neogene sedimentary and pyroclastic rocks. The Kawasaki deposit consists of stratiform bentonite layers up to >50 m thick, and its wall rocks are unaltered shallow marine sedimentary rocks. In contrast, the Dobuyama deposit consists of a funnel-shaped ore body 200 m across, and its wall rocks are hydrothermally altered terrestrial rhyolitic pyroclastic rocks. The Kawasaki and Dobuyama bentonites mainly consist of Na-Ca smectite and Ca smectite, respectively, with subordinate opal-CT, quartz and zeolite. The geological occurrences of the deposits and wall-rock properties suggest that the Kawasaki and Dobuyama deposits were probably formed by diagenesis and low-temperature hydrothermal alteration, respectively. The difference in exchangeable cation ratios of the smectite between the two deposits is attributable to the difference in their sedimentary environments and/or burial depth.