In an article published in Microscopy and Microanalysis recently (Jia et al., 2004), it was claimed that aberration-corrected high resolution transmission electron microscopy (HRTEM) allows the quantitative measurement of oxygen concentrations in ceramic materials with atomic resolution. Similar claims have recently appeared elsewhere, based on images obtained through aberration correction (Jia et al., 2003; Jia & Urban, 2004) or very high voltages (Zhang et al., 2003). Seeing oxygen columns is a significant achievement of great importance (Spence, 2003) that will doubtlessly allow some exciting new science; however, other models could provide a better explanation for some of the experimental data than variations in the oxygen concentration. Quantification of the oxygen concentrations was attempted by comparing experimental images with simulations in which the fractional occupancy in individual oxygen columns was reduced. The results were interpreted as representing nonstoichiometry within the bulk and at grain boundaries. This is plausible because previous studies have shown that grain boundaries can be nonstoichiometric (Kim et al., 2001), and it is indeed possible that oxygen vacancies are present at boundaries or in the bulk. However, is this the only possible interpretation? We show that for the thicknesses considered a better match to the images is obtained using a simple model of surface damage in which atoms are removed from the surface, which would usually be interpreted as surface damage or local thickness variation (from ion milling, for example).

The authors are grateful to the Editor for the opportunity to reply to the letter by Lupini et al. The authors of the above letter comment on a set of recent articles in which the novel technique of imaging at a negative value of the spherical aberration coefficient of the objective lens in an aberration-corrected transmission electron microscope (NCSI technique) is methodically described and applied to the measurement of the occupancy of atomically resolved oxygen columns in perovskites. In particular, the authors raise doubts about the possibility of inferring quantitative data from measurements of the local image intensity at the position of the oxygen atom columns. With reference to the study by Jia et al. (2003a), the letter authors present an image simulation on the basis of which it is stated that the observed effect of a reduced intensity at the oxygen atomic columns should not be interpreted in terms of reduced oxygen occupancy but can, as the authors claim, be “better” explained on the basis of the effect of surface roughness on contrast. In addition, the authors emphasize the work of Kim et al. (2001) with respect to the nonstoichiometry of the oxygen occupancy in grain boundaries of SrTiO3 and criticize our reference to the literature in which it is reported that oxygen cannot be observed by the scanning transmission electron microscopy (STEM) technique in Z-contrast. In the following, we shall demonstrate that in spite of the fact that a nonideal surface morphology can—as in the application of any (!) electron microscopic technique whether used in TEM or in STEM—have an effect on local image intensity, meaningful quantitative measurements of relative oxygen-atom site occupancies can be carried out employing the NCSI technique.

In this article, two simple methods, evaporation-condensation and catalytic thermal evaporation, were used to investigate the synthesis of CdS nanostructures for nanoscale optoelectronic applications. To understand their growth mechanisms, various electron microscopy and microanalysis techniques were utilized in characterizing their morphologies, internal structures, growth directions and elemental compositions. The electron microscopy study reveals that when using the evaporation-condensation method, branched CdS nanorods and self-assembled arrays of CdS nanorods were synthesized at 800°C and 1000°C, respectively. Instead of morphological differences, both types of CdS nanorods grew along the [0001] direction. However, when using the catalytic thermal evaporation method (Au as the catalyst), patterned CdS nanowires and nanobelts were formed at the temperature region of 500–600°C and 600–750°C, respectively. Their growth direction was along the direction [1010] instead of [0001]. Based on the microscopy and microanalysis results, we propose some growth mechanisms in relation to the growth processes of those exotic CdS nanostructures.

Evaporation rate and subsequent exposure to humid air affect the surface morphology and composition of cesium iodide (CsI) films and, in turn, their photoemissive efficiency when used as photocathodes. The surface morphology and elemental composition of 300-nm-thick CsI films grown at two different rates (1 nm/s and 0.04 nm/s), both freshly evaporated and after 24-h exposure to humid air were investigated by means of atomic force microscopy and scanning electron microscopy/electron diffraction spectroscopy. The CsI film freshly evaporated at a slow rate exhibited a granular surface presenting circular holes or craters where the CsI material was moved from the center to the boundaries. After 24-h exposure to humid air, this film coalesced in large grain showing a marked increase of surface roughness. Conversely, the CsI film grown at a fast rate mostly retained its original surface uniformity and homogeneity with no presence of holes and craters after 24-h exposure to humid air. Further, surface roughness and average peak height decreased, but the surface coalesced in large grains spaced by small fractures where the CsI coverage was almost lost. In conclusion, the films grown at a fast evaporation rate were affected by 24-h exposure to humid air less than those grown at a slow rate, and are thus expected to possess a greater long-term stability.

Solid phase crystallization of plasma-enhanced chemical-vapor-deposited (PECVD) amorphous silicon (α-Si:H) in α-Si:H/Al and Al/α-Si:H structures has been investigated using transmission electron microscopy (TEM) and X-ray diffraction (XRD). Radiative heating has been used to anneal films deposited on carbon-coated nickel (Ni) grids at temperatures between 200 and 400°C for TEM studies. α-Si:H films were deposited on c-Si substrates using high vacuum (HV) PECVD for the XRD studies. TEM studies show that crystallization of α-Si:H occurs at 200°C when Al film is deposited on top of the α-Si:H film. Similar behavior was observed in the XRD studies. In the case of α-Si:H deposited on top of Al films, the crystallization could not be observed at 400°C by TEM and even up to 500°C as seen by XRD.

The intracellular distribution of the elements carbon, nitrogen, and oxygen was measured in cultured rat hepatocytes by energy dispersive electron probe X-ray microanalysis of 100-nm-thick freeze-dried cryosections. Electron irradiation with a dose up to 106 e/nm2 caused no or merely negligible mass loss in mitochondria and in cytoplasm. Cell nuclei lost carbon, nitrogen, and—to a clearly higher extent—oxygen with increasing electron irradiation. Therefore, electron doses less than 3 × 105 e/nm2 were used to measure the subcellular compartmentation of carbon, nitrogen, and oxygen in cytoplasm, mitochondria, and nuclei of the cells. The subcellular distribution of carbon, nitrogen, and oxygen reflects the intracellular compartmentation of various biomolecules. Cells exposed to inorganic mercury before cryofixation showed an increase of oxygen in nuclei and cytoplasm. Concomitantly the phosphorus/nitrogen ratio decreased in mitochondria. The data suggest mercury-induced production of ribonucleic acid (RNA) and decrease of adenosine triphosphate (ATP). Although biomolecules cannot be identified by X-ray microanalysis, measurements of the whole element spectrum including the light elements carbon, nitrogen, and oxygen can be useful to study specific biomolecular activity in cellular compartments depending on the functional state of the cell.

Mouse oocyte microfilaments (MF) were perturbed by depolymerization (cytochalasin B) or stabilization (jasplakinolide) and correlated meiotic defects examined by confocal microscopy. MF, microtubules, and mitochondria were vitally stained; centrosomes (γ-tubulin), after fixation. MF depolymerization by cytochalasin in culture medium did not affect central migration of centrosomes, mitochondria, or nuclear breakdown (GVBD); some MF signal was localized around the germinal vesicle (GV). In maturation-blocking medium (containing IBMX), central movement was curtailed and cortical MF aggregations made the plasma membrane wavy. Occasional long MF suggested that not all MF were depolymerized. MF stabilization by jasplakinolide led to MF aggregations throughout the cytoplasm. GVBD occurred (unless IBMX was present) but no spindle formed. Over time, most oocytes constricted creating a dumbbell shape with MF concentrated under one-half of the oocyte cortex and on either side of the constriction. In IBMX medium, the MF-containing half of the dumbbell over time sequestered the GV, MF, mitochondria, and one to two large cortical centrosomes; the non-MF half appeared empty. Cumulus processes contacted the oocyte surface (detected by microtubule content) and mirrored MF distribution. Results demonstrated that MF play an essential role in meiosis, primarily through cortically mediated events, including centrosome localization, spindle (or GV) movement to the periphery, activation of (polar body) constriction, and establishment of oocyte polarity. The presence of a cortical “organizing pole” is hypothesized.

Spores of the biocontrol agent, Streptomyces melanosporofaciens EF-76, were entrapped by complex coacervation in beads composed of a macromolecular complex (MC) of chitosan and polyphosphate. A proportion of spores entrapped in beads survived the entrapment procedure as shown by treating spores from chitosan beads with a dye allowing the differentiation of live and dead cells. The spore-loaded chitosan beads could be digested by a chitosanase, suggesting that, once introduced in soil, the beads would be degraded to release the biocontrol agent. Spore-loaded beads were examined by optical and scanning electron microscopy because the release of the biological agent depends on the spore distribution in the chitosan beads. The microscopic examination revealed that the beads had a porous surface and contained a network of inner microfibrils. Spores were entrapped in both the chitosan microfibrils and the bead lacuna.

Toxoplasma gondii, the causative agent of toxoplasmosis, is capable of actively penetrating and multiplying in any nucleated cell of warm-blooded animals. Its survival strategies include escape from fusion of the parasitophorous vacuole with host cell lysosomes and rearrangement of host cell organelles in relation to the parasitophorous vacuole. In this article we report the rearrangement of host cell organelles and elements of the cytoskeleton of LLCMK2 cells, a lineage derived from green monkey kidney epithelial cells, in response to infection by T. gondii tachyzoites. Transmission electron microscopy made on flat embedded monolayers cut horizontally to the apical side of the cells or field emission scanning electron microscopy of monolayers scraped with scotch tape before sputtering showed that association of mitochondria to the vacuole is much less frequent than previously described. On the other hand, all parasitophorous vacuoles were surrounded by elements of the endoplasmic reticulum. These data were complemented by observations by laser scanning microscopy using fluorescent probes from mitochondria and endoplasmic reticulum and reinforced by three-dimensional reconstruction from serial sections observed by transmission electron microscopy and labeling of mitochondria and endoplasmic reticulum by fluorescent probes.

The present study was designed to evaluate the efficacy of different microwave pretreatment methods to retrieve microtubule-associated protein 2 (MAP-2) immunoreactivity in formalin-fixed, paraffin-embedded guinea pig brain sections. Brain sections, microwave pretreated in boiling sodium citrate, citric acid, Tris hydrochloride, and EDTA buffers of pH 4, 6, and 8, were labeled with four different clones of MAP-2 monoclonal antibodies. No MAP-2 immunoreactivity was observed in control sections processed without microwave pretreatment. Optimal MAP-2 immunoreactivity was observed only when MAP-2 antibody clone AP18 was used in conjunction with citric acid buffer of pH 6.0. Using this combination, brain sections from nerve agent soman-exposed guinea pigs were found to exhibit marked reduction in MAP-2 immunostaining in the hippocampus. These observations suggest that the clone of the antibody in addition to the type and pH of antigen retrieval (AR) solution are important variables to be considered for establishing an optimal AR technique. When studying counterpart antigens of species other than that to which the antibodies were originally raised, different antibody clones must be tested in combination with different microwave-assisted AR (MAR) methods. This MAR method makes it possible to conduct retrospective studies on archival guinea pig brain paraffin blocks to evaluate changes in neuronal MAP-2 expression as a consequence of chemical warfare nerve agent toxicity.

Following is a list of microscopy-related meetings and courses. The editors would greatly appreciate input to this list via the electronic submission form found in the MSA World-Wide Web page at http://www.msa.microscopy.com. We will gladly add hypertext links to the notice on the web and insert a listing of the meeting in the next issue of the Journal. Send comments and questions to JoAn Hudson, [email protected] or Nestor Zaluzec, [email protected].