No CrossRef data available.
Published online by Cambridge University Press: 01 February 2011
We have investigated the switching properties of ferroelectric lead strontium titanate (Pbx Sr1-x)TiO3 (PST) capacitors using epitaxial and polycrystalline La0.5Sr0.5CoO3 (LSCO) electrodes to evaluate its potential for non-volatile memory applications (FRAM'S). The electrical performance of the PST based capacitors grown on epitaxial and polycrystalline LSCO substrates were evaluated through Polarization-Voltage (P-V) and Fatigue measurements. The [001] preferentially oriented PST ferroelectric capacitor did not show a decrease in polarization up to 108 switching cycles at an applied voltage of 4 volts and a frequency of 100 kHz. Polycrystalline PST films, on the other hand were severely fatigued. It is proposed that the good performance of the PST capacitors can be attributed to the high degree of orientation of the PST films in the [001] direction induced by the epitaxial LSCO film. However, after 1010 switching cycles in the fatigue tests, the decay of the non-volatile polarization of these films was about 18% of its initial value. We use a simple model to describe two major microscopic scenarios for the suppression of polarization at the electrodes interfaces. This model is supported by Auger Electron Spectroscopy to determine the bulk and interfacial characteristics. The depth distribution of the elements of the PST film is nearly uniform throughout the volume of the film; however the relative concentrations of Pb and O were abnormally distributed on the surface. It is concluded that, in spite of the good performance due to the favorable conditions for the growth of the PST films provided by the textured LSCO, higher quality interfaces and better control of composition is necessary to improve on fatigue.