Hostname: page-component-cd9895bd7-hc48f Total loading time: 0 Render date: 2024-12-27T02:06:27.114Z Has data issue: false hasContentIssue false
  • English
  • Français

Electrical Resistance and Structural Changes on Crystallizaiton Process of Amorphous Ge-Te Thin Films

Published online by Cambridge University Press:  31 January 2011

Yuta Saito ,
Yuji Sutou  and
Junichi Koike
Yuta Saito
Affiliation:
[email protected], Tohoku University, Sendai, Japan
Yuji Sutou
Affiliation:
[email protected], Tohoku University, Sendai, Japan
Junichi Koike
Affiliation:
[email protected], Tohoku University, Sendai, Japan
Get access

Abstract

GeTe-Sb2Te3 pseudobinary compounds are attracting considerable attention as phase change materials for optical disk and phase change random access memory (PRAM). In these compounds, Ge2Sb2Te5 (GST) has been used for an optical disk memory such as DVD-RAM because the crystallization by laser beam heating is very fast (∼20ns). Recently, the GST has been much considered as material for PRAM and, therefore, the electrical resistance change due to crystallization and the phase change by applying an electrical current have been widely investigated. On the other hand, although GeTe compound has been suggested as the phase change material for the optical disk by Chen et al in 1986, the study focusing on the phase change material for PRAM is limited. Since GeTe is known to show the phenomenon of electrical switching, this compound has a potential of PRAM. In this study, the electrical resistance and crystalline structural changes on crystallization process in Ge-Te thin films were investigated.

Films of amorphous Ge100–xTex (x : 46-94) with 200 nm thickness were deposited by sputtering of GeTe alloy target or co-sputtering of GeTe and Te targets on SiO2/Si substrates. In-situ electrical resistance measurements during heating process of these films were performed by two point probe method in a heating rate of 2∼50°C/min. X-ray diffraction (XRD) analysis was employed for the structural identification of thin films for 10-60° in 2′ using X-ray diffractometer with Cu-K. Transmission electron microscope (TEM) analysis was carried out to investigate the microstructure and to identify crystalline structure. The compositions of these films were confirmed by energy dispersive X-ray spectroscopy (EDS) attached TEM.

All as-deposited Ge-Te films were confirmed amorphous by XRD and TEM. From the in-situ electrical resistance measurements, it is found that resistance change with crystallization process depends on the composition and the stoichiometric GeTe compound shows abrupt electrical resistance change at around 190 °C. The crystallization temperature of GeTe was higher than that of GST and resistance difference between the amorphous and the crystal was also larger. While the electrical resistance of GST film gradually decreased with increasing temperature after the crystallization at around 160 °C, that of GeTe film showed small temperature dependence after crystallization. It was found by X-ray measurement observation that the amorphous GeTe compound film crystallized first into a cubic state, and then into a stable rhombohedral state by further heating. The crystallization kinetics of Ge-Te thin films will be also presented.

Keywords

amorphousmemorythin film
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 1160: Symposium H – Materials and Physics for Nonvolatile Memories , 2009 , 1160-H12-05
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Yamada, N., Ohno, E., Nishiuchi, K., Akahira, N. and Takao, M., J. Appl. Phys., 69, 2849 (1991).Google Scholar
[2] Lankhorst, M. H. R., Ketelaars, B. W. S. M. M. and Wolters, R. A. M., Nat. Mat., 4, 347 (2005).Google Scholar
[3] Chen, Y. C., Rettner, C. T., Raoux, S., Burr, G. W., Chen, S. H., Shelby, R. M., Salinga, M., Risk, W. P., Happ, T. D., McClelland, G. M., Breitwisch, M., Schrott, A., Philipp, J. B., Lee, M. H., Cheek, R., Nirschl, T., Lamorey, M., Chen, C. F., Joseph, E., Zaidi, S., Yee, B., Lung, H. L., Bergmann, R. and Lam, C., IEDM Tech Dig., 346910. 1 (2006).Google Scholar
[4] Chen, M., Rubin, K. A. and Barton, R. W., Appl. Phys. Lett., 49, 502 (1986).Google Scholar
[5] Shelimova, L. E., Abrikosov, N. Kh. and Zhdanova, W., Zh. Neorg. Khim., 10(5), 1200 (1965) [Russ. J. Inorg. Chem., 10(5), 650 (1965)].Google Scholar
[6] Abdel-Aziz, M. M., Appl. Sur. Sci., 253, 2059 (2006).Google Scholar
[7] Chattopadhyay, T., Boucherle, J. X. and Schnering, H. G. von, J. Phys. C: Solid State Phys., 20, 1431 (1987).Google Scholar
[8] Fukumoto, H., Tsunetomo, K. and Imura, T., J. Phys. Soc. Jpn., 56, 158 (1987).Google Scholar
[9] Sarrach, D. J., DeNeufville, J. P. and Haworth, W. L., J. Non-Cryst. Solids, 22, 245 (1976).Google Scholar
[10] Messier, R., Roy, R., Mat. Res. Bull., 6, 749 (1971).Google Scholar
[11] Kaban, I., Dost, E. and Hoyer, W., J. Alloys and Compounds, 379, 1661 (2004).Google Scholar