Hostname: page-component-78c5997874-v9fdk Total loading time: 0 Render date: 2024-11-19T04:29:29.758Z Has data issue: false hasContentIssue false

Development of transparent conductive oxide materials for improved back reflector performance for amorphous silicon based solar cells

Published online by Cambridge University Press:  21 March 2011

Scott J. Jones
Affiliation:
Energy Conversion Devices, Inc., Troy, MI 48084
David Tsu
Affiliation:
Energy Conversion Devices, Inc., Troy, MI 48084
Tongyu Liu
Affiliation:
Energy Conversion Devices, Inc., Troy, MI 48084
Jeff Steele
Affiliation:
Energy Conversion Devices, Inc., Troy, MI 48084
Rey Capangpangan
Affiliation:
Energy Conversion Devices, Inc., Troy, MI 48084
Masat Izu
Affiliation:
Energy Conversion Devices, Inc., Troy, MI 48084
Get access

Abstract

A new back reflector comprised of an Al/(multi-layered stack)/ZnO structure is being developed to replace Al/ZnO used in manufacturing and boost conversion efficiencies with improved back reflector performance. Use of the multi-layered stack should lead to improved reflectivity which will in turn improve solar cell currents and efficiencies. The results from studies of different transparent conductive oxides (TCOs) which comprise the multi-layered stack are reported with emphasis on ZnO alloys. Alloying with Si or MgF2 and using moderately high substrate temperatures, TCOs with low indices of refraction between 1.6 and 1.7 have been fabricated. The Si, Mg and F contents for these alloys were near 14, 12 and 33 at.%. Structural analysis demonstrates that alloys with MgF2 have smother surfaces and finer morphologies than those for ZnO. The expected high values for multi-layered structures with these alloys have yet to be achieved but this is likely due to properties of layers in the structure other than the ZnO alloys which have yet to be fully optimized.

Type
Research Article
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.For example, Arya, R.R., Oswald, R.S., Li, Y.M., Maley, N., Jansen, K., Yang, L., Chen, L.F., Willing, F., Bennett, M.S., Morris, J. and Carlson, D.E., 1st WCPEC conference, 394 (1994).Google Scholar
2. Hoffman, K. and Glatfelter, T., Proc. of 1993 IEEE Photovoltaics Spec. Conf., 986 (1993).Google Scholar
3. Tsu, David V., J.Vac. Sci. Technol. A 17 (4), 1854 (1999).Google Scholar
4. Hu, J. and Gordon, R, J. Appl. Phys. 72(11), 5381 (1992).Google Scholar