Hostname: page-component-586b7cd67f-dlnhk Total loading time: 0 Render date: 2024-11-27T00:32:46.140Z Has data issue: false hasContentIssue false
  • English
  • Français

Design of an optical transmission WDM link using plastic optical fibers

Published online by Cambridge University Press:  17 June 2013

P. Louro ,
P. Soares ,
H. Ferraz ,
P. Pinho  and
M. Vieira
P. Louro
Affiliation:
Electronics, Telecommunications and Computer Dept., ISEL, Lisbon, Portugal CTS-UNINOVA, Lisbon, Portugal
P. Soares
Affiliation:
Electronics, Telecommunications and Computer Dept., ISEL, Lisbon, Portugal
H. Ferraz
Affiliation:
Electronics, Telecommunications and Computer Dept., ISEL, Lisbon, Portugal
P. Pinho
Affiliation:
Electronics, Telecommunications and Computer Dept., ISEL, Lisbon, Portugal Instituto de Telecomunicações, Aveiro, Portugal
M. Vieira
Affiliation:
Electronics, Telecommunications and Computer Dept., ISEL, Lisbon, Portugal CTS-UNINOVA, Lisbon, Portugal DEE-FCT-UNL, Quinta da Torre, Monte da Caparica, 2829-516, Caparica, Portugal
Get access

Abstract

In this paper we present the design of an optical transmission system, using plastic optical fiber (POF), which operates in the visible range of the electromagnetic spectrum. The optical signals are generated by modulated visible LEDs, transmitted through POF and at the reception end a pin-pin photodetector is implemented. A computer simulation tool dedicated to the analysis of optical circuits was used for preliminary analysis of the optical system. The performance of the optical link was analyzed by BER prediction variation on the transmission rate. The tested optical system was assembled using high efficiency LEDs of the same wavelengths, a commercial POF and a pin-pin photodetector based on a-SiC:H/a-SI:H. This detector behaves as an optical filter with controlled wavelength sensitivity. Different optical signals, obtained by adequate modulation of LED optical sources, were coupled into the POF and the combined optical signal at the fiber termination was directed onto the photodetector active area. The output photocurrent was measured with and without optical bias. Results compare the use of a pin-pin transducer device in free space and in a POF transmission link.

Keywords

optoelectronicsensorsemiconducting
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1536: Symposium A – Film Silicon Science and Technology , 2013 , pp. 85 - 90
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Ziemann, O., Krauser, J., Zamzow, P. E. e Werner, D., POF Handbook Optical Short Range Transmission Systems, 2nd Edition, Springer-Verlag Berlin Heidelberg, 2008.Google Scholar
Louvros, S. and Kougias, I. E., Contemporary Eng. Sciences, vol. 2, n.° 2, pp. 47–58, 2009.Google Scholar
Bas, M., Fiber Optics Handbook, Fiber, Dev.. and Syst. for Opt. Comm., Chap, 13, Mc Graw-Hill, 2002.Google Scholar
Louro, P., Vieira, M., Vieira, M. A., Amaral, S., Costa, J., Fernandes, M., Sensors & Actuators: A Physical vol. 172(1), 35–39 (2011) http://dx.doi.org/10.1016/j.sna.2011.01.026..CrossRefGoogle Scholar
Louro, P.; Vieira, M.; Fernandes, M.; Vieira, M. A.; Costa, J.; Fantoni, A., J. Nanoscience and Nanotechnology 11(6) 2011, pp. 5318–5322(5). DOI: 10.1166/jnn.2011.3779.10.1166/jnn.2011.3779CrossRefGoogle Scholar
VPIphotonics™, "VPItransmissionMaker™ Optical Systems," 2012. [Online]. Available: http://www.vpiphotonics.com.Google Scholar
Louro, P., Fernandes, M., Costa, J., Vieira, M. A, Fantoni, A., Vieira, M, MRS Proc. 2011, 1321, 223–228.Google Scholar