Hostname: page-component-78c5997874-s2hrs Total loading time: 0 Render date: 2024-11-20T03:56:22.409Z Has data issue: false hasContentIssue false
  • English
  • Français

Nano Cuprous Oxides Film Prepared by Magnetron Sputtering

Published online by Cambridge University Press:  03 September 2012

Yang-Ming Lu ,
Jun-Yuan Chen  and
Tzuu-Shaang Wey
Yang-Ming Lu
Affiliation:
Department of Electronics Engineering& Nano Research and Development Center, Kun Shan University of Technology, Taiwan, ROC
Jun-Yuan Chen
Affiliation:
Department of Electronics Engineering& Nano Research and Development Center, Kun Shan University of Technology, Taiwan, ROC
Tzuu-Shaang Wey
Affiliation:
Department of Electronics Engineering& Nano Research and Development Center, Kun Shan University of Technology, Taiwan, ROC
Get access

Abstract

Cuprous oxide (Cu2O) is a direct-gap semiconductor with band-gap energy of 2.0 eV and has been extensively investigated as a candidate for a photovoltaic material. However, practical applications have not been achieved to date due to the difficulty in controlling its physical properties. We have investigated the controllability of the formation of pure Cu2O thin films deposited by the reactive DC sputtering method and analysis by XPS and Raman spectrometer to identify the Cu+1 in the cuprous oxide. The formation of pure Cu2O films is not only dependent on the substrate temperature but also strongly effected by the oxygen and argon flow rate ratio. When the substrate temperature was kept constant at 100°C and varied the oxygen and argon flow rate ratio from 3ml/min to 10ml/min, it is found a mixture of Cu2O and CuO phases is formed. At the flow rate of oxygen to 5ml/min, the pure and single phase of Cu2O is formed. Further increasing the oxygen flow rate, the phase is changed to be the CuO phase. The crystallity is improved as increasing the substrate temperature. The electrical resistivity of Cu2O obtained in this study is about 316 ohm-cm at 100°C substrate temperature and 2.66Pa condition. The dependence of cupper oxides resistivity is not only on the substrate temperature and reactive gases but also on the sputter pressure. Because the characteristic resistivity values change with sputter pressure variation due to different phase compositions forming in the films. The lowest resistivity of Cu2O film is obtained when the Cu2O single phase exists in the films.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 822: Symposium S – Nanostructured Materials in Alternative Energy Devices , 2004 , S3.14
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Rakshani, A.E.,Solid State Electronics. 29(1986)7 Google Scholar
2. Tabuchi, Norikazu and Matsumura, Hideki,The Japan Society of Applied physics, 41(2002)5060 Google Scholar
3. Matsumura, H., Hujii, A. and Kitatani, T.,The Japan Society of Applied Physics,35(1996)5631 Google Scholar
4. Wang, E.Y., Trivich, D., Sawalha, H. and Thomas, G.,Proc.COMPILES INT.Conf, Dhahran, Saudi Arabia,1975, in Heliotech and Dev,1(1976)643Google Scholar
5. Zhou, Y.C., Switzer, J.A., Mater.Res.Innovat.,2(1998)22 Google Scholar
6. Ottosson, M., Carlsson, J.O., Surf.Coat.Technol., 78(1996)263 Google Scholar
7. Maruyama, T., Jpn.J.Appl. Phys. 37 (1998)4099 Google Scholar
8. Gong, Y.S., Lee, C., Yang, C.K.,J.Appl.Phys.,77(1995)5422 Google Scholar
9. Kita, R., Kawaguchi, K., Hase, T., Koga, T., Itti, R., Morishita, T.,J.Mater.Res.,9(1994)1280 Google Scholar
10. Drobny, V.F., Pulfrey, D.L.,Thin Solid Films,61(1979)89 Google Scholar
11. Xu, J.F., Ji, W., Shen, Z.X., Li, W.S., Tang, S.H., Ye, X.R., Jia, D.Z. and Xin, X.Q.,Journal of Raman Spectroscopy,20(1999)413–415 Google Scholar
12. Wagner, C.D., Riggs, W.M., Davis, L.E., Moulder, J.E., Muilenber, G.E., Handbook of X-ray photoelectron spectroscopy, Perkin Elmer Corporation Physical Electronics Division, USA 1979 Google Scholar