Hostname: page-component-586b7cd67f-2plfb Total loading time: 0 Render date: 2024-11-30T07:28:34.447Z Has data issue: false hasContentIssue false

Development of low-fluorine solution route and UV photolysis process for YBa2Cu3O7−x coated conductors

Published online by Cambridge University Press:  24 July 2018

Yuanqing Chen
Affiliation:
Department of Materials Physics and Chemistry, Xi'an University of Technology, Xi'an 710048, China School for Engineering of Matter, Transport and Energy, Arizona State University, AZ 85287, USA
Wenwen Qu
Affiliation:
Department of Materials Physics and Chemistry, Xi'an University of Technology, Xi'an 710048, China
Weibai Bian
Affiliation:
Department of Materials Physics and Chemistry, Xi'an University of Technology, Xi'an 710048, China
Lingwei Li
Affiliation:
Department of Materials Physics and Chemistry, Xi'an University of Technology, Xi'an 710048, China
Aditya S. Yerramilli
Affiliation:
School for Engineering of Matter, Transport and Energy, Arizona State University, AZ 85287, USA
Na Li
Affiliation:
Department of Materials Physics and Chemistry, Xi'an University of Technology, Xi'an 710048, China
Yang Song
Affiliation:
Department of Materials Physics and Chemistry, Xi'an University of Technology, Xi'an 710048, China School for Engineering of Matter, Transport and Energy, Arizona State University, AZ 85287, USA
Huimin Wu
Affiliation:
Department of Materials Physics and Chemistry, Xi'an University of Technology, Xi'an 710048, China
Aijuan Wang
Affiliation:
Department of Materials Physics and Chemistry, Xi'an University of Technology, Xi'an 710048, China
N. David Theodore
Affiliation:
School for Engineering of Matter, Transport and Energy, Arizona State University, AZ 85287, USA CHD-Fab, NXP Semiconductors, 1300 N. Alma School Rd, Chandler, AZ 85224, USA
T. L. Alford*
Affiliation:
School for Engineering of Matter, Transport and Energy, Arizona State University, AZ 85287, USA
*
Address all correspondence to T. L. Alford at [email protected]
Get access

Abstract

The influence of the content of trifluoroacetate (TFA), in the precursor solution, on the critical current density (Jc) of YBa2Cu3O7−x (YBCO) superconducting films was investigated. We found that a TFA/Ba ratio of 0.68 is optimal to obtain high-performance YBCO films. Using this optimal solution, we then developed an ultraviolet (UV) light soaking technique to prepare YBCO films. This resulted in the constituent elements being uniformly distributed in the films, and this then enabled enhanced Jc. The addition of water vapor during the UV soaking process decreased the content of carbon residue in the films, and further increased the Jc of the resulting YBCO films.

Type
Research Letters
Copyright
Copyright © Materials Research Society 2018 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Chen, Y., Tang, X., Bian, W., Li, M., Jiang, P., and Zhao, G.: All chemical solution deposition of textured YBa2Cu3O7−x/Y0.2Ce0.8O2/La2Zr2O7 multilayer films on biaxially textured Ni-W tape. Supercond. Sci. Technol. 28, 075015 (2015).Google Scholar
2.Obradors, X., Puig, T., Pomar, A., Sandiumenge, F., Mestres, N., Coll, M., Cavallaro, A., Romà, N., Gázquez, J., González, J.C., Castaño, O., Gutierrez, J., Palau, A., Zalamova, K., Morlens, S., Hassini, A., Gibert, M., Ricart, S., Moretó, J.M., Piñol, S., Isfort, D., and Bock, J.: Progress towards all-chemical superconducting YBa2Cu3O7−x coated conductors. Supercond. Sci. Technol. 19, S13 (2006).Google Scholar
3.Bian, W., Chen, Y., Yin, X., Tang, X, Feng, Y., Zhang, K., Wu, H., Li, L., Hong, F., Zhao, G., and You, C.: Manipulation of YBCO film properties by the introduction of perovskite BaTiO3 nanodots as substrate decorations. J. Eur. Ceram. Soc. 36, 3417 (2016).Google Scholar
4.Chen, Y., Wu, C., Zhao, G., and You, C.: An advanced low-fluorine solution route for fabrication of high-performance YBCO superconducting films. Supercond. Sci. Technol. 25, 062001 (2012).Google Scholar
5.Llordés, A., Zalamova, K., Ricart, S., Palau, A., Pomar, A., Puig, T., Hardy, A., Van Bael, M.K., and Obradors, X.: Evolution of Metal-Trifluoroacetate Precursors in the thermal decomposition toward high-performance YBa2Cu3O7−δ superconducting films. Chem. Mater. 22, 1686 (2010).Google Scholar
6.Dawley, J.T., Clem, P.G., Boyle, T.J., Ottley, L.M., Overmyer, D.L., and Siegal, M.P.: Rapid processing method for solution deposited YBa2Cu3O7−δ thin films. Physica C 402, 143151 (2004).Google Scholar
7.Chen, Y., Yin, X., Feng, Y., Bian, W., Li, M., and Niu, J.: High-efficiency preparation of high-quality YBCO superconducting films using an ultralow-fluorine sol–gel method. J Sol-Gel Sci. Technol. 74, 249 (2015).Google Scholar
8.Jin, L.H., Li, C.S., Feng, J.Q., Yu, Z.M., Wang, Y., Lei, L., Zhao, G.Y., Sulpice, A., and Zhang, P.X.: Optimization of fluorine content in TFA-MOD precursor solutions for YBCO film growth, Supercond. Sci. Technol. 29, 015001 (2016).Google Scholar
9.Wu, W., Feng, F., Zhao, Y., Tang, X., Grivel, J.C., Han, Z., Hong, Z, and Jin, Z.: Intermediate phase study on YBCO films coated by precursor solutions with F/Ba atomic ratio of 2. IEEE Trans. Appl. Supercond. 26, 7200505 (2016).Google Scholar
10.Sebastian, M.A.P., Reichart, J.N., Ratcliff, M.M., Bullard, T.J., Burke, J.L., Ebbing, C.R., Panasyuk, G.Y., Tsai, C.F., Zhang, W., Huang, J., Wang, H., Wu, J., and Haugan, T.J.: Study of the flux pinning landscape of YBCO thin films with single and mixed phase additions BaMO3 + Z: M = Hf, Sn, Zr and Z = Y2O3, Y211. IEEE. Trans. Appl. Supercond. 27, 7500805 (2017).Google Scholar
11.Luo, W., Liao, J., Li, R., and Chen, X.: Determination of Judd–Ofelt intensity parameters from the excitation spectra for rare-earth doped luminescent materials. Phys. Chem. Chem. Phys. 12, 3276 (2010).Google Scholar
12.Umeda, K., Miyasako, T., Sugiyama, A., Tanaka, A., Suzuki, M., Tokumitsu, E., and Shimoda, T.: Impact of UV/O3 treatment on solution-processed amorphous InGaZnO4 thin-film transistors. J. Appl. Phys. 113, 184509 (2013).Google Scholar
13.Hu, W, Zou, L, Chen, X, Qin, N, Li, S, and Bao, D: Highly uniform resistive switching properties of amorphous InGaZnO thin films prepared by a low temperature photochemical solution deposition method. ACS Appl. Mater. Interfaces. 6, 5012 (2014).Google Scholar
14.Gyorgy, E.M., van Dover, R.B., Jackson, K.A., Schneemeyer, L.F., and Waszczak, J.V.: Anisotropic critical currents in Ba2YCu3O7 analyzed using an extended Bean model. Appl. Phys. Lett. 55, 283 (1989).Google Scholar
Supplementary material: File

Chen et al. supplementary material

Chen et al. supplementary material 1

Download Chen et al. supplementary material(File)
File 2 MB