Hostname: page-component-586b7cd67f-2brh9 Total loading time: 0 Render date: 2024-11-22T22:28:38.735Z Has data issue: false hasContentIssue false
  • English
  • Français

Sol-gel synthesis and the effect of boron addition on the phosphorescent properties of SrAl2O4:Eu2+,Dy3+ phosphors

Published online by Cambridge University Press:  26 November 2012

I-Cherng Chen  and
Teng-Ming Chen
I-Cherng Chen
Affiliation:
Institute of Applied Chemistry, National Chiao Tung University, Hsinchu 30050, Taiwan, Republic of China
Teng-Ming Chen*
Affiliation:
Institute of Applied Chemistry, National Chiao Tung University, Hsinchu 30050, Taiwan, Republic of China
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

The effects of boron addition on the microstructure and afterglow properties of the long-phosphorescent SrAl2O4:Eu2+,Dy3+ (SAED), synthesized via a novel sol-gel route, were systematically investigated. Significant improvement on luminescence intensity and the lengthening of afterglow persistent time in boron-added SAED (BSAED) phases were observed, as compared to those without boron addition and commercial phosphors. Typical bluish-green emissions attributed to the doublet phosphorescence with wavelengths peaking at 412 and 501 nm for BSAED phase and 398 and 486 nm for the pristine SAED phase were observed. Afterglow with wavelengths peaking at 403 and 485 nm was observed for BSAED phase, whereas that with wavelengths peaking at 486.5 nm was found for the pristine SAED phase, as indicated by time-dependent afterglow decay profiles. Results from scanning electron microscopic morphological studies were used to investigate the modification of microstructure of the BSAED phases.

Type
Articles
Information
Journal of Materials Research , Volume 16 , Issue 3 , March 2001 , pp. 644 - 651
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Blasse, G. and Bril, A., Philips Res. Repts. 23, 201 (1968).Google Scholar
2.Palilla, F.C., Albere, A.K., and Tomkus, M.R., J. Electrochem. Soc. Solid State Scien. 115, 642 (1968).Google Scholar
3.Murayama, Y., Takeuchi, N., Aoki, Y., and Matsuzawa, T., U.S. Patent No. 5 424 006 (1995).Google Scholar
4.Matsuzawa, T., Aoki, Y., Takeuchi, N., and Murayama, Y., J. Electrochem. Soc. 143, 2670 (1996).Google Scholar
5.Katsumata, T., Nabae, T., Sasajima, K., Kumuro, S, and Morikawa, T., J. Am. Ceram. Soc. 81, 413 (1998);Google Scholar
Katsumata, T., Nabae, T., Sasajima, K., Kumuro, S, and Morikawa, T., J. Electrochem. Soc. 144, L243 (1997).Google Scholar
6.Sakai, R., Katsumata, T., Komuro, S., and Morikawa, T., J. Luminescence 85, 149 (1999).Google Scholar
7.Jia, W., Yuan, H., Lu, L., Liu, H., and Yen, W.M., J. Luminescence 76&77, 424 (1998).Google Scholar
8.Lange, H., U.S. Patent No. 3 294 699 (1966).Google Scholar
9.Sirazhiddinov, N.A. and Arifov, P.A., Russ. J. Inorg. Chem. 16, 40 (1971).Google Scholar
10.Pet, R.J., van den Nieuwenhof, M., and Duisters, J.P.H.M., U.S. Patent No. 4 795 588 (1989).Google Scholar
11.Chen, I-C. and Chen, T-M., J. Mater Res. (submitted, 2000).Google Scholar
12.Nass, R. and Schmidt, H., J. Non-Cryst. Solids 121, 329 (1990).CrossRefGoogle Scholar
13.Blasse, G., J. Solid State Chem. 62, 207 (1986).CrossRefGoogle Scholar
14.Pei, Z., Zeng, Q., and Su, Q., J. Phys. Chem. Solids. 61, 9 (2000).Google Scholar
15.Machida, K., Adachi, G., and Shiokawa, J., J. Luminescence 21, 101 (1979).Google Scholar
16.Sun, J.Y., Shi, C.S., and Li, Y.M., Chinese Sci. Bull. 34, 703 (1989).Google Scholar
17.Qiu, J., Miura, K., Sugimoto, N., and Hirao, K., J. Non-Crystalline Solids. 213&214, 266 (1997).Google Scholar
18.Blasse, G. in Luminescence of Inorganic Solids, edited by Bartolo, B.O. (PlenumPress, New York, 1978), p. 463.Google Scholar
19.Schulze, Von A-R., Müller-Buschbauch, Hk., Z. Anorg. Allg. Chem. 475, 205 (1981).Google Scholar
20.Ohta, M., Maruyama, M., Hayakawa, T., and Nishijo, T., J. Ceram. Soc. Japan 108, 284 (2000).CrossRefGoogle Scholar