Crossref Citations
This article has been cited by the following publications. This list is generated based on data provided by
Crossref.
Ng, H. P.
and
Ngan, A. H. W.
2002.
An in situ transmission electron microscope investigation into grain growth and ordering of sputter-deposited nanocrystalline Ni3Al thin films.
Journal of Materials Research,
Vol. 17,
Issue. 8,
p.
2085.
Han, B. O.
Mohamed, F. A.
Lee, Z.
Nutt, S. R.
and
Lavernia, E. J.
2003.
Mechanical properties of an ultrafine-grained Al-7.5 Pct Mg alloy.
Metallurgical and Materials Transactions A,
Vol. 34,
Issue. 3,
p.
603.
Han, Bing Q.
Lavernia, Enrique J.
and
Mohamed, Farghalli A.
2003.
Tension and compression of bulk Al-7.5 wt% Mg alloy.
Philosophical Magazine Letters,
Vol. 83,
Issue. 2,
p.
89.
Zhang, Z.
Zhou, F.
and
Lavernia, E. J.
2003.
On the analysis of grain size in bulk nanocrystalline materials via x-ray diffraction.
Metallurgical and Materials Transactions A,
Vol. 34,
Issue. 6,
p.
1349.
Xun, Yuwei
Mohamed, Farghalli A.
and
Lavernia, Enrique J.
2004.
Synthesis of nanocrystalline Zn-22 Pct Al using cryomilling.
Metallurgical and Materials Transactions A,
Vol. 35,
Issue. 2,
p.
573.
Zuo, B.
and
Sritharan, T.
2005.
Ordering and grain growth in nanocrystalline Fe75Si25 alloy.
Acta Materialia,
Vol. 53,
Issue. 4,
p.
1233.
Xun, Y.
Rodriguez, R.
Lavernia, E. J.
and
Mohamed, F. A.
2005.
Processing and microstructural evolution of powder metallurgy Zn-22 Pct Al eutectoid alloy containing nanoscale dispersion particles.
Metallurgical and Materials Transactions A,
Vol. 36,
Issue. 10,
p.
2849.
Ajdelsztajn, Leonardo
Schoenung, Julie M.
Jodoin, Bertrand
and
Kim, George E.
2005.
Cold spray deposition of nanocrystalline aluminum alloys.
Metallurgical and Materials Transactions A,
Vol. 36,
Issue. 3,
p.
657.
Han, B. Q.
and
Lavernia, E. J.
2005.
Deformation Mechanisms of Nanostructured Al Alloys.
Advanced Engineering Materials,
Vol. 7,
Issue. 6,
p.
457.
Chauhan, Manish
Roy, Indranil
and
Mohamed, Farghalli A.
2006.
High-strain-rate superplasticity in bulk cryomilled ultra-fine-grained 5083 Al.
Metallurgical and Materials Transactions A,
Vol. 37,
Issue. 9,
p.
2715.
Lucadamo, G.
Yang, N.Y.C.
Marchi, C. San
and
Lavernia, E.J.
2006.
Microstructure characterization in cryomilled Al 5083.
Materials Science and Engineering: A,
Vol. 430,
Issue. 1-2,
p.
230.
Chauhan, Manish
and
Mohamed, Farghalli A.
2006.
Investigation of low temperature thermal stability in bulk nanocrystalline Ni.
Materials Science and Engineering: A,
Vol. 427,
Issue. 1-2,
p.
7.
Sun, Fusheng
Zúñiga, Alejandro
Rojas, Paula
and
Lavernia, Enrique J.
2006.
Thermal stability and recrystallization of nanocrystalline Ti produced by cryogenic milling.
Metallurgical and Materials Transactions A,
Vol. 37,
Issue. 7,
p.
2069.
Sun, Fusheng
Rojas, Paula
Zúñiga, Alejandro
and
Lavernia, Enrique J.
2006.
Nanostructure in a Ti alloy processed using a cryomilling technique.
Materials Science and Engineering: A,
Vol. 430,
Issue. 1-2,
p.
90.
Roy, Indranil
Chauhan, Manish
Mohamed, Farghalli A.
and
Lavernia, Enrique J.
2006.
Thermal stability in bulk cryomilled ultrafine-grained 5083 Al alloy.
Metallurgical and Materials Transactions A,
Vol. 37,
Issue. 3,
p.
721.
Jodoin, B.
Ajdelsztajn, L.
Sansoucy, E.
Zúñiga, A.
Richer, P.
and
Lavernia, E.J.
2006.
Effect of particle size, morphology, and hardness on cold gas dynamic sprayed aluminum alloy coatings.
Surface and Coatings Technology,
Vol. 201,
Issue. 6,
p.
3422.
Ahn, Byungmin
Newbery, A. Piers
Lavernia, Enrique J.
and
Nutt, Steven R.
2007.
Effect of degassing temperature on the microstructure of a nanocrystalline Al–Mg alloy.
Materials Science and Engineering: A,
Vol. 463,
Issue. 1-2,
p.
61.
Chen, Hanbin
and
Yang, Bin
2008.
Effect of Precipitations on Microstructures and Mechanical Properties of Nanostructured Al-Zn-Mg-Cu Alloy.
MATERIALS TRANSACTIONS,
Vol. 49,
Issue. 12,
p.
2912.
Li, W.
Meng, Q.P.
Liu, P.
Ma, F.C.
and
Rong, Y.H.
2010.
Thermal Stability in Nanocrystalline Fe-30 Wt Pct Ni Alloy Induced by Surface Mechanical Attrition Treatment.
Metallurgical and Materials Transactions A,
Vol. 41,
Issue. 11,
p.
2992.
Han, Jung H.
and
Mohamed, Farghalli A.
2011.
Quantitative Measurements of Grain Boundary Sliding in an Ultrafine-Grained Al Alloy by Atomic Force Microscopy.
Metallurgical and Materials Transactions A,
Vol. 42,
Issue. 13,
p.
3969.