In the present study, the essential oil from the leaves of River Red Gum (Eucalyptus camaldulensis Dehnh) was distilled by microwave applied in situ hydrodistillation (MWHD) and the properties obtained were compared with hydrodistillation (HD) techniques. The chemical composition of essential oil obtained by the microwave method was analyzed by gas chromatography (GC) and GC–mass spectrometry (MS). The results showed that the essential oil from E. camaldulensis could successfully be distilled by using microwave irradiation power. Microwave power has been supplied from a cavity having a multimode microwave reactor 2455 MHz with a maximum power of 1000 W. Electromagnetic power distribution has been analyzed inside the cavity. The yield of essential oil increased with increasing microwave irradiation power. It was also found that the content of main compounds clearly varied according to methods applied. However, the yield of essential oil determined by MWHD was slightly lower than that of conventional HD method at conditions studied.

In this paper, the design and the measurements of three-dimensional through silicon vias (TSVs) based-integrated solenoids embedded within high-resistive silicon is presented. Prior to silicon implementation, a rigorous theoretical analysis is proposed to put in obviousness the advantages of using such coil architecture for L and S band applications. This analysis, demonstrates a clear reduction of the footprint passive function lying on the external substrate together with a reduced capacitive coupling with the local environment. Two-port radio frequency measurements have been performed in a wide-frequency range (100 MHz – 50 GHz) in order to support the theoretical investigations. Solenoids exhibit high-quality factors below 4 GHz – Q = 25 @ 2 GHz for a 800 pH device – and clearly outperforms classical planar architecture considered in most of the integrated circuit processes. Two different modeling approaches (compact modeling and EM modeling) are then proposed in order to speed-up their design implementation in a typical CAD design flow. Based on the available data, a good agreement is shown between and simulated data.