Hostname: page-component-78c5997874-xbtfd Total loading time: 0 Render date: 2024-11-06T04:00:32.732Z Has data issue: false hasContentIssue false
  • English
  • Français

An orientation-independent UHF rectenna array with a unified matching and decoupling RF network

Published online by Cambridge University Press:  01 March 2019

M. Fantuzzi ,
G. Paolini ,
M. Shanawani ,
A. Costanzo  and
D. Masotti Open the ORCID record for D. Masotti [Opens in a new window]
M. Fantuzzi
Affiliation:
Department of Electrical, Electronic and Information Engineering “G. Marconi”, University of Bologna, 40136 Bologna, Italy
G. Paolini
Affiliation:
Department of Electrical, Electronic and Information Engineering “G. Marconi”, University of Bologna, 40136 Bologna, Italy
M. Shanawani
Affiliation:
Department of Electrical, Electronic and Information Engineering “G. Marconi”, University of Bologna, 40136 Bologna, Italy
A. Costanzo
Affiliation:
Department of Electrical, Electronic and Information Engineering “G. Marconi”, University of Bologna, 47521 Cesena, Italy
D. Masotti*
Affiliation:
Department of Electrical, Electronic and Information Engineering “G. Marconi”, University of Bologna, 40136 Bologna, Italy
*
Author for correspondence: D. Masotti, E-mail: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

This work describes the design of a rectenna array exploiting orthogonal, closely-spaced UHF monopoles for orientation-independent RF energy harvesting to energize a passive tag, designed for UWB localization, with wake-up radio (WUR) capabilities. To reach this goal, different RF networks are studied to simultaneously realize RF decoupling of the antenna elements and matching of the radiating elements to the non-linear network of rectifiers. The design is performed for a wide power range of the RF incoming signals that need to be exploited for both energizing the passive tag and for providing energy autonomy to a WUR sub-system, used to minimize the long-term power consumption during tag standby operations. Two meandered cross-polarized monopoles, located in close proximity, and thus highly coupled, are adopted for orientation-insensitive operations. The combining RF network is reactive and includes an unbalanced power divider to draw a fraction of the harvested energy to a secondary way for WUR operations. The performance of the harvester is first optimized by EM/non-linear co-design of the whole system over an interval of low RF power levels. The system has been realized and experimentally validated: the superior results obtained, in terms of both dc voltage and power, with respect to a standard single-monopole rectenna, justify the deployment of the presented tag for the energy autonomy of future generation radio-frequency identification tags for indoor localization.

Keywords

RFID and sensorswireless power transfer and energy harvesting
Type
Research Papers
Information
International Journal of Microwave and Wireless Technologies , Volume 11 , Special Issue 5-6: EuMW 2018 Special Issue (Part I) , June 2019 , pp. 490 - 500
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2019 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.EPCTM Radio-Frequency Identity Protocols Generation-2 UHF RFID, v 2.0.1, 2015.Google Scholar
2.Finkenzeller, K (2010) RFID Handbook: Fundamentals and Applications in Contactless Smart Cards and Identification, 3rd Edn. New York, NY, USA: Wiley.Google Scholar
3.Costanzo, A and Masotti, D (2017) Energizing 5G: near- and far-field wireless energy and data transfer as an enabling technology for the 5 G IoT. IEEE Microwave Magazine 18, 125–136.Google Scholar
4.Zhang, D, Yang, LT, Chen, M, Zhao, S, Guo, M and Zhang, Y (2016) Real-time locating systems using active RFID for internet of things. IEEE Systems Journal 10, 1226–1235.Google Scholar
5.Costanzo, A, Masotti, D, Ussmueller, T and Weigel, R (2013) Tag, you're it: ranging and finding via RFID technology. IEEE Microwave Magazine 14, 36–46.Google Scholar
6.Costanzo, A, Dardari, D, Aleksandravicius, J, Decarli, N, Del Prete, M, Fabbri, D, Fantuzzi, M, Guerra, A, Masotti, D, Pizzotti, M and Romani, A (2017) Energy autonomous UWB localization. IEEE Journal of Radio Frequency Identification 1, 228–244.Google Scholar
7.Decarli, N, Guerra, A, Guidi, F, Chiani, M, Dardari, D, Costanzo, A, Fantuzzi, M, Masotti, D, Bartoletti, S, Dehkordi, JS, Conti, A, Romani, A, Tartagni, M, Alesii, R, Di Marco, P, Santucci, F, Roselli, L, Virili, M, Savazzi, P and Bozzi, M (2015) The GRETA architecture for energy efficient radio identification and localization, 2015 International EURASIP Workshop on RFID Technology (EURFID), Rosenheim, Germany, October 2015.Google Scholar
8.Nejad, MB (2008) Ultra Wideband Impulse Radio for Wireless Sensing and Identification (PhD dissertation). at KTH – Royal Institute of Technology, Stockholm, Sweden, December 2008.Google Scholar
9.Fabbri, D, Pizzotti, M and Romani, A (2018) Micropower Design of an Energy Autonomous RF Tag for UWB Localization Applications, 2018 IEEE International Symposium on Circuits and Systems (ISCAS), Florence, Italy, 2018.Google Scholar
10.Fantuzzi, M, Masotti, D and Costanzo, A (2015) A novel integrated UWB–UHF one-port antenna for localization and energy harvesting. IEEE Transactions on Antennas and Propagation 63, 3839–3848.Google Scholar
11.Del Prete, M, Decarli, N, Masotti, D, Dardari, D and Costanzo, A (2018) Exploitation of Multi-sine Intermodulation for Passive Backscattering UWB Localization, 2018 IEEE/MTT-S International Microwave Symposium (IMS), Philadelphia, PA, USA, 2018.Google Scholar
12.Niotaki, K, Kim, S, Jeong, S, Collado, A, Georgiadis, A and Tentzeris, MM (2013) A compact dual-band rectenna using slot-loaded dual band folded dipole antenna. IEEE Antennas and Wireless Propagation Letters 12, 1634–1637.Google Scholar
13.Masotti, D, Costanzo, A, Del Prete, M and Rizzoli, V (2013) A genetic-based design of a tetra-band high-efficiency RF energy harvesting system. IET Microwaves Antennas and Propagation 7, 1254–1263.Google Scholar
14.Craeye, C and González-Ovejero, D (2011) A review on array mutual coupling analysis. Radio Science 46, 1–25.Google Scholar
15.Olgun, U, Chen, CC and Volakis, JL (2011) Investigation of rectenna array configurations for enhanced RF power harvesting. IEEE Antennas and Wireless Propagation Letters 10, 262–265.Google Scholar
16.Fantuzzi, M, Masotti, D and Costanzo, A (2017) Quasi-Isotropic RF Energy Harvester for Autonomous Long Distance IoT Operations, 2017 IEEE MTT-S International Microwave Symposium Digest (IMS), Honolulu, June 2017.Google Scholar
17.Nadeem, I and Choi, D (2018) Study on mutual coupling reduction technique for MIMO antennas. IEEE Access 7, 563–586.Google Scholar
18.Chen, YS and Chang, CP (2016) Design of a four-element multiple-input multiple-output antenna for compact long-term evolution small-cell base stations. IET Microwaves, Antennas and Propagation 10, 385–392.Google Scholar
19.Farahbakhsh, A, Mosalanejad, M, Moradi, G and Mohanna, S (2014) Using polygonal defect in ground structure to reduce mutual coupling in microstrip array antenna. Journal of Electromagnetic Waves and Applications 28, 194–201.Google Scholar
20.Chiu, C, Cheng, C, Murch, RD and Rowell, CR (2007) Reduction of mutual coupling between closely-packed antenna elements. IEEE Transactions on Antennas and Propagation 55, 1732–1738.Google Scholar
21.Wei, K, Li, JY, Wang, L, Xing, ZJ and Xu, R (2016) S-shaped periodic defected ground structures to reduce microstrip antenna array mutual coupling. Electronics Letters 52, 1288–1290.Google Scholar
22.Assimonis, SD, Yioultsis, TV and Antonopoulos, CS (2012) Computational investigation and design of planar EBG structures for coupling reduction in antenna applications. IEEE Transactions on Magnetics 48, 771–774.Google Scholar
23.Abdalla, MA and Ibrahim, AA (2017) Design and performance evaluation of metamaterial inspired MIMO antennas for wireless applications. Wireless Personal Communications 95, 1001–1017.Google Scholar
24.Xu, H, Wang, G and Qi, M (2013) Hilbert-shaped magnetic waveguided metamaterials for electromagnetic coupling reduction of microstrip antenna array. IEEE Transactions on Magnetics 49, 1526–1529.Google Scholar
25.Khan, MS, Capobianco, AD, Asif, SM, Anagnostou, DE, Shubair, RM and Braaten, BD (2017) A compact CSRR-enabled UWB diversity antenna. IEEE Antennas and Wireless Propagation Letters 16, 808–812.Google Scholar
26.Vishvaksenan, KS, Mithra, K, Kalaiarasan, R and Raj, KS (2017) Mutual coupling reduction in microstrip patch antenna arrays using parallel coupled-line resonators. IEEE Antennas Wireless Propagation Letters 16, 2146–2149.Google Scholar
27.Ou, Y, Cai, X and Qian, K (2017) Two-element compact antennas decoupled with a simple neutralization line. Progress In Electromagnetics Research 65, 63–68.Google Scholar
28.Wang, K, Li, L and Eibert, TF (2013) Comparison of compact monopole antenna arrays with eigenmode excitation and multiport conjugate matching. IEEE Transactions on Antennas and Propagation 61, 4054–4062.Google Scholar
29.Khan, M and Warnick, KF (2014) Noise figure reduction by port decoupling for dual circular polarised microstrip antenna. Electronics Letters 50, 1662–1664.Google Scholar
30.Xia, R, Qu, S, Li, P, Jiang, Q and Nie, Z (2015) An efficient decoupling feeding network for microstrip antenna array. IEEE Antennas and Wireless Propagation Letters 14, 871–874.Google Scholar
31.Wu, CH, Chiu, CL and Ma, TG (2016) Very compact fully lumped decoupling network for a coupled two-element array. IEEE Antennas Wireless Propagation Letters 15, 158–161.Google Scholar
32.Chen, SC, Wang, YS and Chung, SJ (2008) A decoupling technique for increasing the port isolation between two strongly coupled antennas. IEEE Transactions on Antennas and Propagation 56, 3650–3658.Google Scholar
33.Fantuzzi, M, Masotti, D and Costanzo, A (2018) Rectenna array with RF-Uncoupled Closely-spaced Monopoles for Autonomous Localization, 2018 European Microwave Conference (EuMC), Madrid, September 2018.Google Scholar
34.Del Prete, M, Costanzo, A, Magno, M, Masotti, D and Benini, L (2016) Optimum excitations for a dual-band microwatt wake-up radio. IEEE Transactions on Microwave Theory and Technique 64, 4731–4739.Google Scholar
35.Texas Instruments Inc. (2015) BQ25570 Nano Power Boost Charger and Buck Converter for Energy Harvester Powered Applications.Google Scholar
36.Costanzo, A, Donzelli, F, Masotti, D and Rizzoli, V (2010) Rigorous design of RF multi-resonator power harvesters, 2010 European Conf. Antennas and Propagation (EuCAP), Barcelona, Spain, 2010.Google Scholar
37.Masotti, D, Francia, P, Costanzo, A and Rizzoli, V (2013) Rigorous electromagnetic/circuit-level analysis of time-modulated linear arrays. IEEE Transaction on Antennas and Propagation 61, 5465–5474.Google Scholar
38.Costanzo, A, Romani, A, Masotti, D, Arbizzani, N and Rizzoli, V (2012) RF/baseband co-design of switching receivers for multiband microwave energy harvesting. Elsevier Journal on Sensors and Actuators A: Physical 179, 158–168.Google Scholar
39.Rizzoli, V, Costanzo, A and Monti, G (2004) General electromagnetic compatibility analysis for nonlinear microwave integrated circuits, 2004 IEEE MTT-S Int. Microwave Symp. (IMS), Fort Worth, Texas, June 2004.Google Scholar
40.Harrington, RF (1973) Time-Harmonic Electromagnetic Fields. New York: McGraw-Hill.Google Scholar
41.Crupi, G and Schreurs, DM-P (2013) Microwave De-embedding – From Theory to Applications, 1st Edn. London, UK: Academic Press - Elsevier.Google Scholar