Reduced tillage is said to be one of the potential ways to reverse land degradation and ultimately increase the productivity of degrading soils of Africa. We hypothesised that crop yield following a modest application of 2 t ha−1 of crop residue in a reduced tillage system is similar to the yield obtained from a conventional tillage system, and that incorporation of legumes in a cropping system leads to greater economic benefits as opposed to a cropping system involving continuous maize. Three cropping systems (continuous maize monocropping, legume/maize intercropping and rotation) under different tillage and residue management systems were tested in sub-humid western Kenya over 10 seasons. While soybean performed equally well in both tillage systems throughout, maize yield was lower in reduced than conventional tillage during the first five seasons but no significant differences were observed after season 6. Likewise, with crop residue application, yields in conventional and reduced tillage systems are comparable after season 6. Nitrogen and phosphorus increased yield by up to 100% compared with control. Gross margins were not significantly different among the cropping systems being only 6 to 39% more in the legume–cereal systems relative to similar treatments in continuous cereal monocropping system. After 10 seasons of reduced tillage production, the economic benefits for our cropping systems are still not attractive for a switch from the conventional to reduced tillage.

The results of research done on water relations of rubber are collated and summarised in an attempt to link fundamental studies on crop physiology to crop management practices. Background information is given on the centres of origin (Amazon Basin) and production of rubber (humid tropics; south-east Asia), but the crop is now being grown in drier regions. The effects of water stress on the development processes of the crop are summarised, followed by reviews of its water relations, water requirements and water productivity. The majority of the recent research published in the international literature has been conducted in south-east Asia. The rubber tree has a single straight trunk, the growth of which is restricted by ‘tapping’ for latex. Increase in stem height is discontinuous, a period of elongation being followed by a ‘rest’ period during which emergence of leaves takes place. Leaves are produced in tiers separated by lengths of bare stem. Trees older than three to four years shed senescent leaves (a process known as ‘wintering’). ‘Wintering’ is induced by dry, or less wet, weather; trees may remain (nearly) leafless for up to four weeks. The more pronounced the dry season the shorter the period of defoliation. Re-foliation begins before the rains start. The supply of latex is dependent on the pressure potential in the latex vessels, whereas the rate of flow is negatively correlated with the saturation deficit of the air. Radial growth of the stem declines in tapped trees relative to untapped trees within two weeks of the start of tapping. Roots can extend in depth to more than 4 m and laterally more than 9 m from the trunk. The majority of roots are found within 0.3 m of the soil surface. Root elongation is depressed during leaf growth, while root branching is enhanced. Stomata are only found on the lower surface of the leaf, at densities from 280 to 700 mm−2. The xylem vessels of rubber trees under drought stress are vulnerable to cavitation, particularly in the leaf petiole. By closing, the stomata play an essential role in limiting cavitation. Clones differ in their susceptibility to cavitation, which occurs at xylem water potentials in the range of −1.8 to −2.0 MPa. Clone RRII 105 is capable of maintaining higher leaf water potentials than other clones because of stomatal closure, supporting its reputation for drought tolerance. Clones differ in their photosynthetic rates. Light inhibition of photosynthesis can occur, particularly in young plants, when shade can be beneficial. Girth measurements have been used to identify drought-tolerant clones. Very little research on the water requirements of rubber has been reported, and it is difficult to judge the validity of the assumptions made in some of the methodologies described. The actual evapotranspiration rates reported are generally lower than might be expected for a tree crop growing in the tropics (<3 mm d−1). Virtually no research on the yield responses to water has been reported and, with the crop now being grown in drier regions, this is surprising. In these areas, irrigation can reduce the immaturity period from more than 10 years to six years. The important role that rubber plays in the livelihoods of smallholders, and in the integrated farming systems practised in south-east Asia, is summarized.

Farmers in the Lake Alaotra region of Madagascar are currently evaluating a range of conservation agriculture (CA) cropping systems. Most of the expected agroecological functions of CA (weed control, erosion control and water retention) are related to the degree of soil cover. Under farmers’ conditions, the grain and biomass productivity of these systems is highly variable and the biomass is used for several purposes. In this study, we measured biomass production of cover crops and crops in farmers’ fields. Further, we derived relationships to predict the soil cover that can be generated for a particular quantity of mulch. We used these relationships to explore the variability of soil cover that can be generated in farmers’ fields, and to estimate how much of the biomass can be removed for use as livestock feed, while retaining sufficient soil cover. Three different kinds of cropping systems were investigated in 91 farmers’ fields. The first two cropping sequences were on the hillsides: (i) maize + pulse (Vigna unguiculata or Dolichos lablab) in year 1, followed by upland rice in year 2; (ii) the second crop sequence included several years of Stylosanthes guianensis followed by upland rice; (iii) the third crop sequence was in lowland paddy fields: Vicia villosa or D. lablab, which was followed by rice within the same year and repeated every year. The biomass available prior to rice sowing varied from 3.6 t ha−1 with S. guianensis to 7.3 t ha−1 with V. villosa. The relationship between the mulch quantity (M) and soil cover (C) was measured using digital imaging and was well described by the following equation: C = 1 − exp(−Am × M), where Am is an area-to-mass ratio with R2 > 0.99 in all cases. The calculated average soil cover varied from 56 to 97% for maize + V. unguiculata and V. villosa, respectively. In order to maintain 90% soil cover at rice sowing, the average amount of biomass of V. villosa that could be removed was at least 3 t ha−1 for three quarters of the fields. This quantity was less for other annual or biennial cropping systems. On average the V. villosa aboveground biomass contained 236 kg N ha−1. The study showed that for the conditions of farmers of Malagasy, the production and conservation of biomass is not always sufficient to fulfil all the above-cited agroecological functions of mulch. Inventory of the soil cover capacity for different types of mulch may help farmers to decide how much biomass they can remove from the field.

The economics of coffee plantations is intrinsically linked to pruning, which can improve the canopy architecture and thereby increase productivity. However, recommended pruning times on conilon coffee plantations have been made on an entirely empirical basis. In this study, by evaluating growth, photosynthetic gas exchanges, starch accumulation and crop productivity, the effects of pruning at different times between harvest and flowering were investigated for six conilon coffee clones with distinct stages of fruit maturation (early, intermediate and late). Clones with an early maturation stage were pruned at four different times: 0, 30, 60 and 90 days after harvest (DAH). Intermediate clones were pruned at 0, 30 and 60 DAH, and late clones were pruned at 0 and 30 DAH. Overall, the rates of shoot growth and net photosynthesis, the stomatal conductance and the crop yield were not affected by the pruning treatments in any of the clones. In addition, pruning times did not affect the concentrations of starch or the photochemical efficiency of photosystem II. The carbon isotope composition ratio was marginally affected by the treatments. These results suggest that the pruning time after harvests is relatively unimportant and pruning operations can be scheduled to optimise the use of labour, which directly impacts the production costs of coffee.

At various locations in North Ethiopia (Tigray), field experiments were conducted from 2006 to 2009 to assess the crop response to water stress of tef (Eragrostis tef (Zucc.) Trotter) under rainfed, fully irrigated and deficit irrigation conditions. Observed soil water content (SWC), canopy cover (CC), biomass production (B) and final grain yield (Y) were used to calibrate and validate AquaCrop for tef. Data from an experiment in a controlled environment in 2008 were also considered in the calibration process. Simulations of SWC, CC, B and Y were evaluated by determining the index of agreement, the root mean square error, the coefficient of determination and the Nash–Sutcliffe efficiency. The statistical parameters showed an adequate fit between observations and simulations. The model was able to simulate for tef growing under rainfed condition the observed fast drop in SWC and CC when the rains ceased. The overall goodness of fit between the observed and simulated CC and SWC indicated that the thresholds for root zone depletion at which water stress (i) affects canopy development, (ii) induces stomata closure and (iii) triggers early canopy senescence were well selected. The normalised biomass water productivity (WP*) for tef was 14 g m−2 for the local variety and 21 g m−2 for the improved variety, which is a lot smaller than the WP* expected for C4 plants (30–35 g m−2). The results revealed an increase of 27% in reference harvest index (HIo) of tef in response to mild water stress during the yield formation of up to 33%. However, severe water stress causing stomata closure had a negative effect on HIo. Once it is properly calibrated, AquaCrop can provide room to improve the water productivity of tef by developing guidelines for good agricultural management strategies.

Salt (NaCl) and matric stress (polyethylene glycol; PEG 6000) impacts on germination were analysed in two rapeseed (Brassica napus var oleifera Del.) cultivars (Exagone: salt and water stress tolerant; Toccata: salt and water stress sensitive), which had the same imbibition kinetics when incubated in distilled water. Final germination percentage (G) and time to reach 50% G (T50) were affected either by 325 mM NaCl or −0.9 MPa PEG in Toccata but not in Exagone. Cultivars did not differ for protein concentration and protease activity in any germination condition; thus, protein metabolism seems not to be implicated in response to stress. Hydroxurea and cytochalasine-D inhibited germination in Toccata exposed to −0.9 MPa PEG but not in Exagone, suggesting that Exagone tolerance could be due to a lower amount of damaged DNA and lower requirement for DNA replication due to cell elongation rather than cell division for radicle elongation. Soluble sugars concentration increased in salt-stressed seeds from Exagone more than in Toccata and this could have allowed osmotic adjustment and therefore cell elongation despite the presence of external NaCl. Priming treatments with gibberellic acid, kinetin, NaCl and PEG hastened seed germination under control conditions but had no effect or even negative effects on germination under both salt and matric stresses.

AquaCrop, the FAO water productivity model, is used as a tool to predict crop production under water limiting conditions. In the first step AquaCrop was calibrated and validated for barley (Hordeum vulgare L.). Data sets of field experiments at seven different locations in four countries (Ethiopia, Italy, Syria and Montana, USA) with different climates in different years and with five different cultivars were used for model calibration and validation. The goodness-of-fit between observed and simulated soil water content, green canopy cover, biomass and grain yield was assessed by means of the coefficient of determination (R2), the Nash–Sutcliff efficiency (E), the index of agreement (d) and the root mean square error (RMSE). The statistical parameters indicated an adequate accuracy of simulations (validation regression of yield: R2 = 0.95, E = 0.94, d = 0.99, RMSE = 0.34). Subsequently, sowing strategies in the semi-arid environment of northern Ethiopia were evaluated with the validated model. Dry sowing had a probability of 47% germination failure attributable to false start of the rainy season. On the other hand, delay sowing at the start of the rainy season to eliminate germinating weeds should be kept as short as possible because grain yields strongly reduce in the season due to water stress when sowing is delayed on shallow soils. This research demonstrates the ability of AquaCrop to predict accurately crop performance with only a limited set of input variables, and the robustness of the model under various environmental and climatic conditions.

Within the context of participatory varietal selection of peanut (Arachis hypogaea L.) in East Timor, this study investigated an approach to identify yield determinants in farmer-managed varietal trials in a type of exploratory agronomy. A singular increase of 47% in peanut on-farm productivity by variety Utamua over local varieties was recorded across agro-ecologies over 616 farmer-managed trials in five cropping seasons. Utamua has larger (c. 70%) seed than local, which resulted in poor germination initially. Farmers then started seed priming, and, by the last two seasons’ trials, 50% of farmers with on-farm trials seed primed. The volume of trials allied with detailed recording of agro-ecological, household and management conditions allowed the identification of factors affecting yield, such as seeding arrangement (two seeds/hill more productive than one seed/hill) and soil pH (pH 7–8.5 more productive than lower pH), using an unbalanced ANOVA design. Farmer innovations in management could be identified within varietal trials highlighting future agronomic possibilities.

Photosynthesis and biomass production by millet (Pennisetum glaucum) and taro (Colocasia esculenta) grown under baobab (Adansonia digitata) and néré (Parkia biglobosa) was studied at Nobéré (Burkina Faso) with the aim of optimising parkland systems productivity. Millet yielded the highest biomass under Baobab and the lowest biomass was recorded in the zone close to the tree trunk of néré. In contrast, the biomass of taro was higher in heavy shaded zones under néré and the zone close to baobab's trunk. The two crops showed an increasing trend of photosynthesis rate (PN) from tree trunk to the open area. However, the increase in the PN of taro from tree trunk to the open field was lower compared to that of millet. By increasing its leaf area index (LAI) under shade, taro displayed higher biomass production under tree compared to the open area while an opposite trend was observed in millet. The high millet biomass production under baobab could be explained by light availability and the reduction of temperature under shade compared to the open field. The adaptation of taro to shade by increasing its LAI and thus avoiding drastic reduction in PN under shade resulted in better biomass production under heavy shade. Therefore, it was concluded that by replacing millet with taro under dense tree crowns the productivity of agroforestry parkland systems could be increased.