Skip to main content Accessibility help
×
Hostname: page-component-78c5997874-s2hrs Total loading time: 0 Render date: 2024-11-08T05:02:01.174Z Has data issue: false hasContentIssue false

4 - Cooperative Networks with Wireless Energy Harvesting

from Part II - Architectures, Protocols, and Performance Analysis

Published online by Cambridge University Press:  01 December 2016

Sudha Lohani
Affiliation:
University of British Columbia, Vancouver, BC, Canada
Roya Arab Loodaricheh
Affiliation:
314-2730 Acadia Road, Vancouver, BC, Canada
Shankhanaad Mallick
Affiliation:
110-8738 French Street, Vancouver, BC, Canada
Ekram Hossain
Affiliation:
University of Manitoba, Winnipeg, MB, Canada
Vijay Bhargava
Affiliation:
University of British Columbia, Vancouver, BC, Canada
Dusit Niyato
Affiliation:
Nanyang Technological University, Singapore
Ekram Hossain
Affiliation:
University of Manitoba, Canada
Dong In Kim
Affiliation:
Sungkyunkwan University, Korea
Vijay Bhargava
Affiliation:
University of British Columbia, Vancouver
Lotfollah Shafai
Affiliation:
University of Manitoba, Canada
Get access

Summary

Introduction

Energy harvesting has emerged as one of the enabling technologies for Green Communication. As the name suggests, energy harvesting is a technique by which energy of ambient sources, for example, solar, wind, and thermal, is converted into electrical energy and used to power network equipment or mobile devices [1, 2]. This technology makes use of perpetual renewable energy sources, which reduces the consumption of high-cost constant energy sources. Lately, wireless power transfer has gained much attention in the field of energy harvesting since wireless signal is also an ambient source of energy in itself [3, 4]. Owing to the lower range of harvested energy, RF energy harvesting has potential for powering smaller network nodes.

Wireless energy harvesting technology has been studied in two different paradigms of wireless communication networks. The first is simultaneous wireless information and power transfer (SWIPT) in downlink [5–7]. The SWIPT technique is used to transmit wireless energy to user equipments (UEs) whilst carrying out downlink information transmission to them as shown in Figure 4.1. The technological requirements necessary to enable this simultaneous information and energy transmission at the receiver circuit will be discussed later in this chapter. The SWIPT technique increases the energy efficiency of the network since the energy cost decreases for UEs capable of harvesting energy from the received information signal [8]. In other words, energy spent at the information transmitter is partially reused at the receiver. The reuse of energy is partial mainly because of the path-loss and non-ideal energy harvesting efficiency.

On the other hand, when the UEs are carrying out uplink transmission, it is not possible to transmit energy to them using the SWIPT technique. Hence, another important paradigm of wireless energy harvesting networks is wireless-powered communication (WPC) in the uplink [9, 10]. In this technique, some fraction of the uplink transmission duration is dedicated to downlink energy transmission (DET) from the access point (AP) to the UEs. The energy harvested during this time is utilized by the UEs for uplink information transmission (UIT) to the AP in the remaining fraction of time as shown in Figure 4.2.

Type
Chapter
Information
Wireless-Powered Communication Networks
Architectures, Protocols, and Applications
, pp. 135 - 169
Publisher: Cambridge University Press
Print publication year: 2016

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] P. T. V., Bhuvaneswari, R., Balakumar, V., Vaidehi, and P., Balamuralidhar, “Solar energy harvesting for wireless sensor networks,” in Proc. 1st International Conference on Computational Intelligence, Communication Systems and Networks (CICSYN ‘09), July 2009, pp. 57–61.
[2] R., Kappel, W., Pachler, M., Auer et al., “Using thermoelectric energy harvesting to power a self-sustaining temperature sensor in body area networks,” in Proc. IEEE International Conference on Industrial Technology (ICIT), February 2013, pp. 787–792.
[3] L., Varshney, “Transporting information and energy simultaneously,” in Proc. IEEE International Symposium on Information Theory (ISIT), July 2008, pp. 1612–1616.
[4] H., Jabbar, Y., Song, and T., Jeong, “RF energy harvesting system and circuits for charging of mobile devices,” IEEE Transactions on Consumer Electronics, vol. 56, no. 1, pp. 247–253, February 2010.Google Scholar
[5] X., Zhou, R., Zhang, and C. K., Ho, “Wireless information and power transfer: Architecture design and rate-energy tradeoff,” IEEE Transactions on Communications, vol. 61, no. 11, pp. 4754–4767, November 2013.Google Scholar
[6] K., Huang and E., Larsson, “Simultaneous information and power transfer for broadband wireless systems,” IEEE Transactions on Signal Processing, vol. 61, no. 23, pp. 5972–5986, December 2013.Google Scholar
[7] R., Zhang and C. K., Ho, “MIMO broadcasting for simultaneous wireless information and power transfer,” IEEE Transactions on Wireless Communications, vol. 12, no. 5, pp. 1989–2001, May 2013.Google Scholar
[8] D. W. K., Ng, E. S., Lo, and R., Schober, “Wireless information and power transfer: Energy efficiency optimization in OFDMA systems,” IEEE Transactions on Wireless Communications, vol. 12, no. 12, pp. 6352–6370, December 2013.Google Scholar
[9] J., Hyungsik and R., Zhang, “Throughput maximization in wireless powered communication networks,” IEEE Transactions on Wireless Commun., vol.13, no.1, pp. 418–428, January 2014.Google Scholar
[10] S., Lohani, R. A., Loodaricheh, E., Hossain, and V. K., Bhargava, “Relay-based harvestthen- transmit protocol for uplink cellular networks,” in IEEE Globecom Workshops (GC Workshops), December. 2014, pp. 912–917.
[11] Krikidis, Ioannis, “Simultaneous information and energy transfer in large-scale networks with/without relaying,” IEEE Transactions on Commun., vol. 62, no. 3, pp. 900–912, March 2014.Google Scholar
[12] A. A., Nasir, X., Zhou, S., Durrani, and R. A., Kennedy, “Relaying protocols for wireless energy harvesting and information processing,” IEEE Transactions on Wireless Communications, vol. 12, no. 7, pp. 3622–3636, July 2013.Google Scholar
[13] S. K., Yoon, S. J., Kim, and U. K., Kwon, “Energy relaying in mobile wireless sensor networks,” in Proc. IEEE Consumer Communications and Networking Conference (CCNC), January 2013, pp. 673–676.Google Scholar
[14] D., Mishra, S., De, S., Jana et al., “Smart RF energy harvesting communications: challenges and opportunities,” IEEE Communications Magazine., vol. 53, no. 4, pp. 70–78. April 2015.Google Scholar
[15] T., Riihonen, S., Werner, and R., Wichman, “Comparison of full-duplex and half-duplex modes with a fixed amplify-and-forward relay,” IEEE Wireless Communications and Networking Conference (WCNC), April 2009, pp. 1–5.
[16] M., Moghaddari and E., Hossain, “Cooperative communications in OFDM and MIMO cellular relay networks: Issues and approaches,” in Cooperative Cellular Wireless Networks, E., Hossain, D. I., Kim, and V. K., Bhargava, Eds. Cambridge : Cambridge University Press, 2011.
[17] A. A., Nasir, X., Zhou, S., Durrani, and R. A., Kennedy, “Wireless-powered relays in cooperative communications: Time-switching relaying protocols and throughput analysis,” IEEE Transactions on Communications, vol. 63, no. 5, pp. 1607–1622, May 2015.Google Scholar
[18] I., Krikidis, S., Timotheou, and S., Sasaki, “RF energy transfer for cooperative networks: Data relaying or energy harvesting?,” IEEE Communications Letters, vol. 16, no. 11, pp. 1772–1775, November 2012.Google Scholar
[19] C., Zhong. H. A., Suraweera, G., Zheng, I., Krikidis, and Z., Zhang, “Wireless information and power transfer with full duplex relaying,” IEEE Transactions on Communications, vol. 62, no. 10, pp. 3447–3461, October 2014.Google Scholar
[20] Y., Zeng and R., Zhang, “Full-duplex wireless-powered relay with self-energy recycling,” IEEE Wireless Communications Letters, vol. 4, no. 2, pp. 201–204, April 2015.Google Scholar
[21] K., Kaushik, D., Mishra, S., De et al., “Experimental demonstration of multi-hop RF energy transfer,” in Proc. 24th International Symposium on Personal Indoor and Mobile Radio Communications (PIMRC), September 2013, pp. 538–542.Google Scholar
[22] R. A., Loodaricheh, S., Mallick, and V. K., Bhargava, “Resource allocation for OFDMA systems with selective relaying and energy harvesting,” in Proc. IEEE 80th Vehicular Technology Conference (VTC Fall), September 2014, pp. 1–5.Google Scholar
[23] H. W., Kuhn, “The Hungarian method for the assignment problem,” in Naval Research Logistic Quarterly, vol. 2, nos. 1–2, pp. 83–97, March 1955.Google Scholar
[24] S. O., Krumke, Integer Programming. Polyhedra and Algorithms, 2006 (available at www.bayanbox.ir/view/7671377560979429366/Integer-Programming-Krumke.pdf).
[25] R. A., Loodaricheh, S., Mallick, and V. K., Bhargava,“Energy-efficient resource allocation for OFDMA cellular networks with user cooperation and QoS provisioning,” IEEE Transactions on Wireless Communications vol. 13, no. 11, pp. 6132–6146, November 2014.Google Scholar
[26] R., Nabar, F., Kneubuhler, and H., Bolcskei, “Performance limits of amplify-and-forward based fading relay channels,” in Proc. IEEE ICASSP, 2004, pp. 565–568.Google Scholar
[27] S., Boyd and L., Vandenberghe, Convex Optimization. Cambridge : Cambridge University Press, 2004 (available at http://books.google.ca/books?id=mYm0bLd3fcoC).
[28] S., Lohani, R. A., Loodaricheh, E., Hossain, and V. K., Bhargava, “On multiuser resource allocation in relay-based wireless-powered uplink cellular networks,” IEEE Transactions on Wireless Communications, vol. 15, no. 3, pp. 1851–1865, March 2016.Google Scholar
[29] A., Sabharwal, P., Schniter, D., Guo et al., “In-band full-duplex wireless: Challenges and opportunities,” IEEE Journal on Selected Areas in Communications, vol. 32, no. 9, pp. 1637–1652, September 2014.Google Scholar
[30] H., Ju and R., Zhang, “Optimal resource allocation in full-duplex wireless-powered communication network,” IEEE Transactions on Communications, vol. 62, no. 10, pp. 3528–3540, October 2014.Google Scholar
[31] E., Ahmed, A. M., Eltawil, and A., Sabharwal, “Self-interference cancellation with phase noise induced ICI suppression for full-duplex systems,” in Proc. IEEE Global Communications Conference (GLOBECOM), December 2013, pp. 3384–3388.Google Scholar
[32] D., Korpi, L., Anttila, V., Syrjala, and M., Valkama, “Widely linear digital self-interference cancellation in direct-conversion full-duplex transceiver,” IEEE Journal on Selected Areas in Communications, vol. 32, no. 9, pp. 1674–1687, September 2014.Google Scholar
[33] X., Zhou, R., Zhang, and C. K., Ho, “Wireless information and power transfer: Architecture design and rate-energy tradeoff,” IEEE Transactions on Communications, vol. 61, no. 11, pp. 4754–4767, November 2013.Google Scholar
[34] Y., Gu and S., Aissa, “Interference aided energy harvesting in decode-and-forward relaying systems,” in Proc. IEEE International Conference on Communications (ICC), June 2014, pp. 5378–5382.Google Scholar
[35] A. A., Nasir, D. T., Ngo, X., Zhou, R. A., Kennedy, and S., Durrani, “Joint resource optimization for heterogeneous multicell networks with wireless energy harvesting relays,” CoRR, 2014 (available at http://dblp.uni-trier.de/rec/bib/journals/corr/NasirNZKD14).
[36] H., Chen, Y., Jiang, Y., Li, Y., Ma, and B., Vucetic, “A game-theoretical model for wireless information and power transfer in relay interference channels,”in Proc. IEEE International Symposium on Information Theory (ISIT), June–July 2014, pp. 1161–1165.Google Scholar

Save book to Kindle

To save this book to your Kindle, first ensure [email protected] is added to your Approved Personal Document E-mail List under your Personal Document Settings on the Manage Your Content and Devices page of your Amazon account. Then enter the ‘name’ part of your Kindle email address below. Find out more about saving to your Kindle.

Note you can select to save to either the @free.kindle.com or @kindle.com variations. ‘@free.kindle.com’ emails are free but can only be saved to your device when it is connected to wi-fi. ‘@kindle.com’ emails can be delivered even when you are not connected to wi-fi, but note that service fees apply.

Find out more about the Kindle Personal Document Service.

Available formats
×

Save book to Dropbox

To save content items to your account, please confirm that you agree to abide by our usage policies. If this is the first time you use this feature, you will be asked to authorise Cambridge Core to connect with your account. Find out more about saving content to Dropbox.

Available formats
×

Save book to Google Drive

To save content items to your account, please confirm that you agree to abide by our usage policies. If this is the first time you use this feature, you will be asked to authorise Cambridge Core to connect with your account. Find out more about saving content to Google Drive.

Available formats
×