In this paper we present a high temperature heating device, working under defined environmental conditions, for a Siemens D500 Bragg–Brentano powder diffractometer. The powder sample is prepared in a flat mould on a metal block consisting either of copper or of platinum depending on the temperature range selected for investigations. Although the heating cell can be used separately under ambient conditions up to sample temperatures of 1000 °C, it is possible to work under defined environmental conditions in the temperature range between 20 and 200 °C and up to a water vapour pressure of 1000 mbar. For that purpose a special cover for the in situ control of temperature and water vapour pressure has been constructed. It is important to note that the three sample conditions (sample temperature, gas temperature, and gas humidity) can be adjusted separately by the user. Current studies have shown that the described X-ray heating device is a powerful tool to study dehydration reactions in the frame of fundamental research as well as to understand industrially relevant processes concerning dehydration reactions and their mechanisms.

We developed a simulation model for terrestrial sites including sensible heat exchange between the atmosphere and ground surface, inter- and intra-layer heat conduction by rock and soil, and shortwave and longwave radiation. Water fluxes included snowmelt, freezing/thawing of soil water, soil capillary flow, and vapour flows among atmosphere, soil, and snow. The model accounted for 96–99% of variation in soil temperature data. No long-term temporal trends in soil temperature were apparent. Soil water vapour concentration in thawed surface soil in summer often was higher than in frozen deeper soils, leading to downward vapour fluxes. Katabatic winds caused a reversal of the usual winter pattern of upward vapour fluxes. The model exhibited a steady state depth distribution of soil water due to vapour flows and in the absence of capillary flows below the top 0.5 cm soil layer. Beginning with a completely saturated soil profile, soil water was lost rapidly, and within a few hundred years approached a steady state characterized by dry soil (< 0.5% gravimetric) down to one metre depth and saturated soil below that. In contrast, it took 42 000 years to approach steady state beginning from a completely dry initial condition.

The assumption that seeds imbibe most of the water required for germination as liquid through seed-to-soil contact has been a dominant theme in germination research and seeding technology. Under most conditions, seeds are also exposed to water vapour during imbibition, but the relative contributions of liquid and vapour are difficult to assess. In water uptake models that include vapour, procedures used to estimate potential vapour imbibition have underappreciated the effect of distance on diffusion rate. At the same time, the amount of seed-to-soil contact and the liquid bridge from soil water to the seed tend to be greatly overestimated, considering the soil water contents often found in the field. Most researchers have recorded an approximately equal time to germination at soil water contents ranging from field capacity to nearly permanent wilting point, and little response to bulk density, soil type or seed–soil contact. While hydraulic conductivity decreases by several orders of magnitude as soil water content, bulk density and seed-contact decrease, relative humidity remains near 100%. There are several experiments demonstrating timely germination in water vapour alone. The combined evidence contradicts the assumption that seed–soil contact is important for imbibition of water by seeds. Water vapour should be considered the primary source of water for seeds in unsaturated soils.

Areas surveyed for ELT projects using satellite data are described. A synopsis of the methodology used is given and selected results from recent studies are presented.