Cemented tungsten carbide has been analyzed using laser-pulsed atom probe tomography (APT). The influence of experimental parameters, including laser pulse energy, pulse repetition rate, and specimen base temperature, on the acquired data were evaluated from different aspects, such as mass spectrum, chemical composition, noise-to-signal ratio, and multiple events. Within all the applied analysis conditions, only 1 MHz pulse repetition rate led to a strong detector saturation effect, resulting in a largely biased chemical composition. A comparative study of the laser energy settings showed that an ~12 times higher energy was required for the less focused green laser of the LEAPTM 3000X HR system to achieve a similar evaporation field as the finer spot ultraviolet laser of the LEAPTM 5000 XS system.

To enable mechanical milling of small (0.1–1.0 g) samples, a cylindrical grinding vessel machined from polypropylene and furnished with tungsten carbide rods has been designed and produced for use inside the conventional jar of a McCrone Micronizing Mill. The vessel is about one-seventh the volume of the conventional jar supplied by the manufacturer. The conditions of milling for both the conventional and the miniaturized-grinding assemblies were tested using quartz sand as a limiting case. The median grain sizes of the resultant powders were measured by an X-ray gravitational-sedimentation method, with contamination from the grinding media measured by Rietveld refinement and by instrumental neutron activation analysis. The use of tungsten carbide grinding elements permits rapid wet milling of a small sample to the same median grain size in about one-third of the time required by a regular sample ground in corundum. The relative contamination (by tungsten carbide on a weight basis) using the miniaturized-grinding assembly is about 6(1)% of the proportion of corundum contamination yielded by the conventional grinding assembly.