Cereal rye cover crop (cereal rye) and preemergence (PRE) herbicides are becoming common practices for managing herbicide-resistant weeds in soybean production. Adopting these two practices in combination raises concerns regarding herbicide fate in soil, given that the cereal rye biomass can intercept the herbicide spray solution, preventing it from reaching the soil. Delaying cereal rye termination until soybean planting (planting green) optimizes biomass accumulation but might also increase PRE interception. To better understand the dynamics between cereal rye and PRE herbicides, a field experiment was conducted to evaluate two soil management practices (tillage and no-till) and two cereal rye termination practices in the planting-green system (glyphosate [1,260 g ae ha−1] and roller-crimper) on the spray deposition and fate of PRE herbicides and soybean yield. The spray deposition was assessed by placing water-sensitive paper cards on the soil surface before spraying the PRE herbicides (sulfentrazone [153 g ai ha−1] + S-metolachlor [1,379 g ai ha−1]). Herbicide concentration in soil (0 to 7.6 cm) was quantified 25 d after treatment (DAT). The presence of no-till stubble and cereal rye biomass reduced the spray coverage compared to tillage at PRE application, which reflected in a reduction in the concentration of both herbicides in soil 25 DAT. Soybean yield was reduced in all three years when the cereal rye was terminated with a roller-crimper but only reduced in one year when terminated with glyphosate. Our findings indicate that mainly cereal rye biomass reduced the concentration of PRE herbicides in the soil due to the interception of the spray solution during application. Although higher cereal rye biomass accumulation can provide better weed suppression according to the literature, farmers should be aware that the biomass can lower the concentration of PRE herbicides reaching the soil, thus intensifying field scouting to ensure that weed control is not being negatively affected.

The introduction of 2,4-D–resistant soybean will provide an additional POST herbicide site of action for control of herbicide-resistant broadleaf weeds. The introduction of this technology also brings concern of off-site movement of 2,4-D onto susceptible crops such as sensitive soybean and tomato. The 2,4-D formulation approved for use in 2,4-D–resistant soybean restricts application of the herbicide to nozzles that produce very coarse to ultra-coarse droplet spectrums. The use of larger droplet spectrums for broadcast applications can reduce herbicide deposition onto target weeds and thus influence herbicide efficacy. Field experiments were conducted to evaluate the influence of nozzle design on herbicide deposition onto target plants and the resulting efficacy of a POST application of 280 g ha−1 glyphosate plus 280 g ha−1 2,4-D. The TTI11004 nozzle produced an ultra-coarse droplet spectrum and reduced coverage and deposition density on spray cards as compared with the XR11004 and TT11004 nozzles that produced medium droplet spectrums. The AIXR11004 nozzle also reduced deposition density on spray cards but did not reduce coverage. Herbicide solution deposition onto glyphosate-resistant Palmer amaranth, tall waterhemp, giant ragweed, and horseweed ranged from 0.28 to 0.72 µl cm−2 and was not influenced by nozzle design. Herbicide efficacy was reduced by the TTI11004 nozzle on Palmer amaranth and horseweed compared with the AIXR11004, TT11004, and XR11004 nozzles when applications were made to either high densities of plants or plants exceeding the labeled height. The use of the AIXR11004 and TTI11004 nozzles that are listed as approved nozzles for glyphosate plus 2,4-D applications on 2,4-D–resistant soybean did not reduce herbicide deposition onto four of the most troublesome broadleaves and did not reduce herbicide efficacy when applied in conjunction with lower weed densities and smaller weeds.

Dicamba-resistant soybean technology provides an additional site of action for POST control of herbicide-resistant broadleaf weeds in soybean but also raises concern of off-site movement and damage to sensitive crops in adjacent fields. Dicamba formulations approved for use on dicamba-resistant soybean require applicators to use nozzles producing large droplets to reduce the risk of spray-particle drift. The use of nozzles with relatively larger droplet spectra can reduce herbicide deposition on target weeds, especially if a filtering effect from the crop canopy occurs. Experiments were conducted to evaluate the influence of broadcast nozzle design on the deposition and efficacy of 280 g ha−1 glyphosate plus 140 g ha−1 dicamba applied POST to four herbicide-resistant weed species. The TTI11004 nozzle, the original nozzle labeled for dicamba applications on dicamba-resistant soybean, reduced deposition coverage and density on spray cards compared with the TT11004 and XR11004 nozzle. The AIXR11004 nozzle produces a very coarse droplet spectrum and did not reduce coverage on spray cards, though it did reduce deposition density. Herbicide solution deposition onto Palmer amaranth, tall waterhemp, giant ragweed, and horseweed ranged from 0.41 to 0.52, 0.55 to 0.87, 0.49 to 0.58, and 0.38 to 0.41 µl cm−2, respectively. Nozzle design and droplet spectrum did not influence the deposition of herbicide solution onto the target weed, as all nozzles were equivalent for all species and site-years. Herbicide efficacy was not influenced by nozzle design, as weed control and plant height reduction were similar for all species. The results of this experiment show that the use of the TTI11004 nozzle for dicamba applications to dicamba-resistant soybean will provide acceptable herbicide deposition and efficacy when applied under the label requirements of weed height and carrier volume.

Fenoxaprop, fluazifop/fluazifop-P, haloxyfop, and quizalofop at 0.14 kg ai ha−1 and sethoxydim at 0.28 kg ai ha−1 were applied broadcast over-the-top in spray volumes of 94 and 374 L ha−1, each at 138 and 345 kPa, to control johnsongrass in soybeans over a 5-yr period. The two spray volumes provided equal control, but control was better when treatments were applied at 345 kPa than at 138 kPa. There were no significant interactions among herbicides, spray volumes, or spray pressures. Most of the spray was deposited on the upper surface of the plant canopy. Less than 10% of the herbicide spray applied penetrated into the canopy onto water-sensitive spray cards located 10, 20, 30, or 40 cm above the ground.

Greenhouse studies were conducted to determine the influence of plant density and spray volume on the retention, spray deposition, efficacy, and translocation of the amine salt of triclopyr in purple loosestrife. More spray solution was retained on leaves at 935 Lha−1 than at 94 Lha−1 at populations of 0, 4, or 8 nontarget neighbors. Spray coverage decreased with decreasing height within the plant canopy when spray cards were placed in the top, middle, and soil surface adjacent to the central target plant. Within a population, spray card coverage generally increased as spray volume increased. Regrowth from the crown was affected by spray volume, and uniform spray coverage of the plant was required for adequate control of vegetative regrowth and was achieved with spray volumes of 374 and 935 L ha−1 spray volume. Regrowth of purple loosestrife was greater at 94 Lha−1 at all three plant populations indicating that less herbicide penetrated the canopy to reach the basal portion of the plant. A laboratory experiment was conducted to investigate the translocation of radiolabelled triclopyr to roots and crowns of purple loosestrife. Only 0.3 to 1.4% of absorbed 14C-labelled material was translocated to roots and crowns. Low spray volumes and dense stands of purple loosestrife would likely result in poor control because inadequate amounts of triclopyr reach the basal portion of the plant and translocate to vegetative propagules.

Field studies with flatfan, twinjet, flood and rotary atomizers were conducted in 1987 and 1988. The results indicated that tridiphane at 0.6 kg ai/ha plus atrazine at 1.7 kg ai/ha with 2.0 L/ha of soybean oil adjuvant was more effective in controlling giant foxtail and common lambsquarters when applied by the flatfan, twinjet, and rotary atomizers. Image analysis indicated that weed control by a postemergence herbicide was generally enhanced by better application coverage. Droplet size measurement by phase droplet particle/droplet analyzer demonstrated that the rotary atomizer produced a narrower range of droplet diameters between the Dv.1 and Dv.9 volumes than any of the other atomizers.

Greenhouse and laboratory studies were conducted to examine the effects of site of plant exposure to glyphosate spray on efficacy, absorption, and translocation in pitted morningglory. Absorption of 14C-glyphosate in four-leaf pitted morningglory gradually increased with time from 19% at 1 h after treatment (HAT) to 44% at 192 HAT. The amount of 14C translocated with time ranged from 0.4% at 1 HAT to 25% at 192 HAT. Vining 1-m tall plants were controlled 75 to 100% when the top-, middle-, bottom one-third, or entire plant was treated with 1.38 or 2.76 kg ha−1 glyphosate, with control affected more by glyphosate rate than plant section exposed to glyphosate spray. Absorption of 14C-glyphosate at 96 HAT was similar whether it was applied to the top-, middle-, bottom one-third, or entire plant of 1-m tall pitted morningglory. The amount of 14C translocated out of the treated area (5 to 6%) did not differ whether it was applied to top-, middle-, or bottom one-third plant section. Results indicate that absorption and translocation of 14C-glyphosate in pitted morningglory was rapid and increased with time. Treating any one-third section of pitted morningglory plants was as effective as entire plant exposure, and control with glyphosate is more affected by rate than the degree of plant exposure to glyphosate.

Herbicide efficacy, coverage, and retention were evaluated for spray applied through Drift Guard, Turbo TeeJet, AI TeeJet, and TurboDrop drift-reducing nozzles compared to a conventional flat-fan nozzle. Percentage spray coverage detected on water-sensitive cards was greater for conventional and Drift Guard nozzles than for Turbo TeeJet, AI TeeJet, and TurboDrop nozzles. Spray without adjuvants was retained better by redroot pigweed for treatments applied with conventional and Drift Guard nozzles than Turbo TeeJet, AI TeeJet, and TurboDrop nozzles. However, spray with adjuvants was retained similarly for all nozzle types when averaged over spray adjuvant and two weed species. The efficiency of spray retention was greater for spray applied in 47 than in 190 L/ha spray volume for all nozzles. Paraquat and glyphosate, representing contact and translocated herbicides, respectively, provided similar grass species control for all nozzle types, regardless of spray volume. Paraquat and glyphosate were also equally or more effective in 47 compared to 190 L/ha spray volume.

Field experiments were conducted to determine the influence of nozzle type, spray volume, and adjuvants on herbicide efficacy. Carfentrazone and imazamox, representing contact and translocated herbicides, respectively, were equally or more effective when applied with drift-reducing TurboDrop or Drift Guard nozzles than the conventional flat-fan nozzle in 95% of the comparisons. Imazamox was equally effective when applied in 47, 94, or 190 L/ha spray volume, regardless of nozzle type or adjuvant. Carfentrazone applied in 47 L/ha spray volume controlled flax and sunflower as well as in 94 or 190 L/ha, provided urea ammonium nitrate fertilizer and either nonionic surfactant or methylated vegetable oil were included in the spray mixture. Conversely, carfentrazone with only urea ammonium nitrate was less effective when applied in 47 than in 94 or 190 L/ha spray volume. Carfentrazone and imazamox applied in low spray volumes (47 L/ha) gave consistent control when an effective adjuvant was included in the spray mixture.

The effect of three spray variables (droplet number, active ingredient concentration, and droplet size) on uptake and translocation of formulated 14C-triclopyr ester was studied in greenhouse-grown Populus tremuloides seedlings. The dose per plant in all treatments was held constant. In all experiments, absorption (as a percentage of dose applied) was much greater than translocation (as percentage of dose absorbed). Absorption and translocation decreased as concentration (ai) was increased and droplet number decreased. Absorption and translocation also decreased as droplet number decreased and droplet size increased. When concentration (ai) was increased and droplet size decreased, absorption again decreased but to a much lesser extent than in the other two experiments; there was no significant effect on translocation. A time-course experiment indicated that uptake rate began to decrease within 1.5 h of application. The rate of decrease was greater at the higher concentration (ai), suggesting that the decrease was associated with contact injury. A model to integrate the application parameters and translocation gave a high correlation between dose per unit droplet stain circumference and translocation.