Hostname: page-component-586b7cd67f-vdxz6 Total loading time: 0 Render date: 2024-11-26T19:05:26.882Z Has data issue: false hasContentIssue false
  • English
  • Français

Tuning of a wireless power transfer system with a hybrid capacitor array

Published online by Cambridge University Press:  06 April 2016

Nurcan Keskin  and
Huaping Liu
Nurcan Keskin*
Affiliation:
School of Electrical Engineering and Computer Science, Oregon State University, Corvallis, OR 97331-5501, USA
Huaping Liu
Affiliation:
School of Electrical Engineering and Computer Science, Oregon State University, Corvallis, OR 97331-5501, USA
*
Corresponding author:N. Keskin Email: [email protected]
Get access

Abstract

Power transfer efficiency in loosely coupled inductive systems can be enhanced by resonance. Primary and secondary can be tuned to same resonant frequency. In this paper, MOSFET-based Varactors and switchable capacitors are used for re-tuning of such a system at 13.56 MHz. This is achieved either using each cap structure alone or as a hybrid model. These techniques are designed for 13.56 MHz wireless power transfer system.

Keywords

Wireless powerInductively coupledMOSCAPTuningAntenna
Type
Research Article
Information
Wireless Power Transfer , Volume 3 , Issue 1 , March 2016 , pp. 9 - 14
Copyright
Copyright © Cambridge University Press 2016 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1]Tseng, R.; Novak, B.V.; Shevde, S.; Grajski, K.A.: Introduction to the alliance for wireless power loosely-coupled wireless power transfer system specification version 1.0, in IEEE Wireless Power Transfer Conf., Technologies, Systems and Applications, Perugia, Italy, 15–16 May (2013), 79–83.Google Scholar
[2]Riehl, P.S. et al. : Wireless power systems for mobile devices supporting inductive and resonant operating modes. IEEE Trans. Microw. Theory Tech., 63 (3) (2015), 780–790.Google Scholar
[3]Dai, J.; Ludois, D.C.: A survey of wireless power transfer and a critical comparison of inductive and capacitive coupling for small gap applications. IEEE Trans. Power Electron., (2015), 30, 1–14.Google Scholar
[4]Lu, Y.; Li, X.; Ki, W.-H.; Tsui, C.-Y.; Yue, P.: A 13.56 MHz fully integrated 1x/2x active rectifier with compensated bias current for inductively powered devices, in IEEE ISSCC, (2013), 66–68.Google Scholar
[5]Li, X.; Tsui, C.-Y.; Ki, W.-H.: A 13.56MHz wireless power transfer system with reconfigurable resonant regulating rectifier and wireless power control for implementable medical devices. IEEE J. Solid-State Circuits, 50 (4) (2015), 978–989.CrossRefGoogle Scholar
[6]Stielau, O.H.; Covic, G.A.: Design of loosely coupled inductive power transfer systems, in Proc. Power System Technology, (2000), 85–90.Google Scholar
[7]Wang, C.-S.; Stielau, O.H.; Covic, G.A.: Load Models and their application in the design of loosely coupled inductive power transfer systems, in Proc. Power System Technology, (2000), 1053–1058.Google Scholar
[8]Fotopoulou, K.; Flynn, B.W.: Wireless power transfer in loosely coupled links: coil misalignment model. IEEE Trans. Magn., 47 (2) (2011), 416–430.Google Scholar
[9]Zhou, W.; Hao, M.: Design considerations of compensation topologies in ICPT system, in Applied Electronics Conf., (2007), 985–990.Google Scholar
[10]Jegadeesan, R.; Guo, Y.-X.: Topology selection and efficiency improvement of inductive power links. IEEE Trans. Antenna Propag., 60 (10) (2012), 4846–4854.Google Scholar
[11]Mastri, F.; Costanzo, A.; Dionigi, M.; Mongiardo, M.: Harmonic balance design of wireless resonant-type power transfer links, in IEEE MTT-S Int. Microwave Workshop on Innovative Wireless Power Transmission (IMWS), (2012), 245–248.CrossRefGoogle Scholar
[12]Rashidzadeh, R.; Basith, I.I.: A test probe for TSV using resonant inductive coupling, in IEEE Int. Test Conf., (2013), 1–6.Google Scholar
[13]Hu, C.C.: Modern Semiconductor Devices for Integrated Circuits, 1st ed., Prentice-Hall, 2009.Google Scholar
[14]Ogawa, K.; Oodachi, N.; Obayashi, S.; Shoki, H.: A study of efficiency improvement of wireless power transfer by impedance matching, in IEEE MTT-S Int. Microwave Workshop on Innovative Wireless Power Transmission (IMWS), (2012), 155–157.Google Scholar
[15]Mercier, P.P.; Chandrakasan, A.: Rapid wireless capacitor charging using a multi-tapped inductively-coupled secondary coil, in IEEE Trans. Circuits and Systems I Regular Papers, September (2013), 2263–2272.Google Scholar
[16]Jung, Y.K.; Lee, B.: Design of adaptive optimal load circuit for maximum wireless power transfer efficiency, in Asia-Pacific Microwave Conf. Proc. (APMC), (2013), 1221–1223.Google Scholar
[17]Lee, J.; Lim, Y.-S.; Yang, W.-J.; Lim, S.-O.: Wireless power transfer system adaptive to change in coil separation. IEEE Trans. Antennas Propag., 62 (2014), 889–897.Google Scholar
[18]Heebl, J.D.; Thomas, E.M.; Penno, R.P.; Grbic, A.: Comprehensive analysis and measurement of frequency-tuned and impedance-tuned wireless non-radiative power-transfer systems. IEEE Antennas Propag. Mag., (2014), 56, 44–60.Google Scholar
[19]Lee, H.-M.; Kwon, K.-Y.; Li, W.; Ghovanloo, M.: A power-efficient switched-capacitor stimulating system for electrical/optical deep brain stimulation. IEEE J. Solid-State Circuits, (2015), 50, 360–374.Google Scholar
[20]Buisman, K. et al. : Varactor topologies for RF adaptivity with improved power handling and linearity, in Proc. IEEE/MTT-S Int. Microwave Symp., (2007), 319–322.Google Scholar
[21]Buisman, K.; Cong, Huang ; Zampardi, P.J.; de Vreede, L.C.N.: RF power insensitive varactors. IEEE Microw. Wireless Compon. Lett., (2012), 22, 418–420.Google Scholar
[22]Ogawa, K.; Oodachi, N.; Obayashi, S.; Shoki, H.: a study of efficiency improvement of wireless power transfer by impedance matching, in IEEE MTT-S Int. Microwave Workshop Series on Innovative Wireless Power Transmission: Technologies, Systems, Applications (IMWS-IWPT), May (2012), 155–157.Google Scholar
[23]Sample, A.P.; Waters, B.H.; Wisdom, S.T.; Smith, J.R.: Enabling seamless wireless power delivery in dynamic environments. Proc. IEEE, 101 (6) (2013), 1343–1358.Google Scholar
[24]Lai, X.; Yuan, F.: Remote calibration of wireless power harvest, in MWSCAS, (2013), 501–504.Google Scholar
[25]Saltanovs, R.: Multi-capacitor circuit application for the wireless energy transmission system coils resonant frequency adjustment, in IEEE Wireless Power Transfer Conf. (WPTC), (2015), 1–3.CrossRefGoogle Scholar