Hostname: page-component-586b7cd67f-t8hqh Total loading time: 0 Render date: 2024-11-22T10:05:48.007Z Has data issue: false hasContentIssue false
  • English
  • Français

The aerospace wireless sensor network system compatible with microwave power transmission by time- and frequency-division operations

Part of: WPT for Sustainable Electronics (WiPE)

Published online by Cambridge University Press:  24 April 2015

Satoshi Yoshida ,
Naoki Hasegawa  and
Shigeo Kawasaki
Satoshi Yoshida
Affiliation:
Institute of Space and Astronautical Science, Japan Aerospace Exploration Agency, 3-1-1 Yoshinodai, Chu-oh, Sagamihara 252-5210, Japan. Phone: +81 50 3362 5732
Naoki Hasegawa
Affiliation:
Institute of Space and Astronautical Science, Japan Aerospace Exploration Agency, 3-1-1 Yoshinodai, Chu-oh, Sagamihara 252-5210, Japan. Phone: +81 50 3362 5732 Research Institute for Sustainable Humanosphere, Kyoto University, Gokasho, Uji, Kyoto 611-0011, Japan
Shigeo Kawasaki*
Affiliation:
Institute of Space and Astronautical Science, Japan Aerospace Exploration Agency, 3-1-1 Yoshinodai, Chu-oh, Sagamihara 252-5210, Japan. Phone: +81 50 3362 5732
*
Corresponding author: S. Kawasaki Email: [email protected]
Get access

Abstract

A novel wireless sensor network system with compatibility of microwave power transmission (MPT) using a Gallium Nitride (GaN) power amplifier has been fabricated and tested. The sensor node operates using electrical power supplied by the MPT system. Time- and frequency-division operations are proposed for the compatibility. Under the frequency-division operation, receiving signal strength indicator of −85 dBm and packet error rate of <1% were measured when the available DC power of a rectifier with 160 mW output power. Under 120-min measurement, sustainable power balance between radio-frequency–DC conversion and power consumption in stable operation of the sensor node was achieved.

Keywords

Wireless power transmissionWireless sensor networkMicrowave power transmission
Type
Research Article
Information
Wireless Power Transfer , Volume 2 , Special Issue 1: Wireless Power Transmission for Sustainable Electronics (WiPE) , March 2015 , pp. 3 - 14
Check for updates
Copyright
Copyright © Cambridge University Press 2015 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Kawasaki, S.: The green energy harvesting winds by the RF/microwave power transmission, in Wireless Power Transfer Conf., May 2013, 111–114.Google Scholar
[2] Salas, M.; Focke, O.; Herrmann, A.S.; Lang, W.: Wireless power transmission for structural health monitoring of fiber-reinforced-composite materials. IEEE Sens. J., 14 (7) (2014), 2171–2176.Google Scholar
[3] Hu, X.; Wang, J.; Yu, Q.; Liu, W.; Qin, J.: A wireless sensor network based on ZigBee for telemedicine monitoring system, in Int. Conf. on Bioinformatics and Biomedical Engineering, May 2008, 1367–1370.CrossRefGoogle Scholar
[4] Watthanawisuth, N.; Lomas, T.; Wisitsoraat, A.; Uantranont, A.: Wireless wearable pulse oximeter for health monitoring using ZigBee wireless sensor network, in Int. Conf. on Electrical Engineering/Electronics Computer Telecommunications and Information Technology, May 2010, 575–579.Google Scholar
[5] Teo, T.H.; Lim, G.K.; Sutomo, D.; Tan, K.H.; Gopalakrishnan, P.K.; Singh, R.: Ultra low-power sensor node for wireless health monitoring system, in Proc. IEEE Int. Symp. Circuits Systems, May 2007, 2363–2366.Google Scholar
[6] Moges, M.; Robertazzi, T.G.: Wireless sensor networks: scheduling for measurement and data reporting. IEEE Trans. Aerosp. Electron. Syst., 42 (1) (2006), 327–340.CrossRefGoogle Scholar
[7] Karolys, A.; GenKuong, F.: Multi-drop, simultaneous sampling sensor network system for aerospace testing and monitoring applications, in Sensors Applications Symp., February 2007, 1–6.Google Scholar
[8] Senesky, D.G.; Jamshidi, B.; Cheng, K.B.; Pisano, A.P.: Harsh environment silicon carbide sensors for health and performance monitoring of aerospace systems: a review. IEEE Sens. J., 9 (11) (2009), 1472–1478.Google Scholar
[9] Wagner, R.S.; Barton, R.J.: Performance comparison of wireless sensor network standard protocols in an aerospace environment: ISA100.11a and ZigBee Pro, in IEEE Aerospace Conf., March 2012, 1–14.Google Scholar
[10] Liu, J.; Demirkiran, I.; Yang, T.; Helfrick, A.: Feasibility study of IEEE 802.15.4 for aerospace wireless sensor networks, in Digital Avionics Systems Conf., October 2009, 1.B.3–1–1.B.3–10.CrossRefGoogle Scholar
[11] Takacs, A. et al. : Energy harvesting for powering wireless sensor networks on-board geostationary broadcasting satellites, in Int. Conf. on Green Computing and Communications, November 2012, 637–640.Google Scholar
[12] Zhao, X. et al. : Active health monitoring of an aircraft wing with an embedded piezoelectric sensor/actuator network. Smart Mater. Struct., 16 (2007) (2007), 1218–1225.Google Scholar
[13] Zheng, W.H.; Armstrong, J.T.: Wireless intra-spacecraft communication: the benefits and the challenges, in NASA/ESA Conf. on Adaptive Hardware and Systems, June 2010, 75–78.Google Scholar
[14] Vladimirova, T. et al. : Characterising wireless sensor motes for space applications, in NASA/ESA Conf. on Adaptive Hardware and Systems, August 2007, 43–50.Google Scholar
[15] ICNIRP: Guldelines for limiting exposure to time-varying electric, magnetic and electromagnetic fields (up to 300 GHz). Health Phys., 74 (1998), 494–522.Google Scholar
[16] Oruganti, S.K.; Heo, S.H.; Ma, H.; Bien, F.: Wireless energy transfer-based transceiver systems for power and/or high-data rate transmission through thick metal walls using sheet-like waveguides. Electon. Lett., 50 (12) (2014), 886–888.Google Scholar
[17] Ichihara, T.; Mitani, T.; Shinohara, N.: Study on intermittent microwave power transmission to a ZigBee device, in Int. Microwave Symp. Series – Innovative Wireless Power Transmission, May 2012, 40–43.Google Scholar
[18] Xie, L.; Shi, Y.; Hou, Y.T.; Lou, A.: Wireless power transfer and applications to sensor networks. IEEE Wireless Commun., 20 (4) (2013), 140–145.Google Scholar
[19] Baek, J.; Ahn, C.; Kim, B.-C.; Choi, S.; Kwak, S.: High frequency wireless power transfer system for robot vacuum cleaner, in Int. Conf. on Consumer Electronics, January 2014, 308–310.CrossRefGoogle Scholar
[20] Mayordomo, I.; Drager, T.; Alayon, J.A.; Bernhard, J.: Wireless power transfer for sensors and systems embedded in fiber composites, in Wireless Power Transfer Conf., May 2013, 107–110.Google Scholar
[21] Virili, M.; Alimenti, F.; Roselli, L.; Mezzanotte, P.; Dionigi, M.: Organic frequency doubler RFID tag exploiting 7.5-MHz wireless power transfer, IEEE Wireless Power Transfer Conf., May 2013, 33–36.Google Scholar
[22] Xue, R.-F.; Cheng, K.W.; Je, M.: High-efficiency wireless power transfer for biomedical implants by optimal resonant load transformation. IEEE Trans. Circuits Syst., 60 (4) (2013), 867–874.CrossRefGoogle Scholar
[23] Li, T.; Han, Z.; Ogai, H.; Sawada, K.; Wang, J.: A microchip-controlling wireless power transfer system for sensor network, in Proc. SICE Annual Conf., August 2012, 337–341.Google Scholar
[24] Georgiadis, A.; Collado, A.; Niotaki, K.: Optimal signal selection and rectenna design challenges for electromagnetic energy harvesting and wireless power transfer, in Asia-Pacific Microwave Conf., November 2014, 597–599.Google Scholar
[25] Arbizzani, N.; Prete, M.D.; Masotti, D.; Costanzo, A.: Detection of closely-spaced objects by a low-cost reader at 2.45 GHz, in IEEE MTT-S Int. Microwave Symp. Technical Digest, June 2012, 1–3.Google Scholar
[26] Popovic, Z.; Falkenstein, E.A.; Costinett, D.; Zane, R.: Low-power far-field wireless powering for wireless sensors. Proc. IEEE, 101 (6) (2013), 1397–1409.Google Scholar
[27] Visser, H.J.; Vullers, R.J.M.: RF energy harvesting and transport for wireless sensor network applications: principles and requirements. Proc. IEEE, 101 (6) (2013), 1410–1423.Google Scholar
[28] Yano, Y.: Take the expressway to go greener, in International Solid-State Circuits Conf. Digest of Technical Papers, February 2012, 24–30.CrossRefGoogle Scholar
[29] Guenda, L.; Collado, A.; Carvalho, N.B.; Georgiadis, A.; Niotaki, K.: Electromagnetic geo-referenced footprints for energy harvesting systems, in IEEE Radio and Wireless Symp., January 2012, 339–342.Google Scholar
[30] Lim, T.B.; Lee, N.M.; Poh, B.K.: Feasibility study on ambient RF energy harvesting for wireless sensor network, in IEEE MTT-S Int. Microwave Workshop Series on RF and Wireless Technologies for Biomedical and Healthcare Applications, December 2013, 1–3.Google Scholar
[31] Jung, H.-J.; Lee, S.-W.; Jang, D.-D.: Feasibility study on a new energy harvesting electromagnetic device using aerodynamic instability. IEEE Trans. Magn., 45 (10) (2009), 4376–4379.Google Scholar
[32] Ishizaki, H.; Ikeda, H.; Yoshida, Y.; Maeda, T.; Kuroda, T.; Mizuno, M.: A Battery-less WiFi-BER modulated data transmitter with ambient radio-wave energy harvesting, in 2011 Symp. on VLSI Circuits, June 2011, 162–163.Google Scholar
[33] Vidojkovic, M. et al. : A 2.4 GHz ULP OOK single-chip transceiver for healthcare applications, in ISSCC Digest of Technical Papers, February 2011, 458–460.CrossRefGoogle Scholar
[34] Kawasaki, S.: Microwave WPT to a rover using active integrated phased array antennas, in 5th Eur. Conf. on Antennas and Propagation, April 2011, 3909–3912.Google Scholar
[35] Tashiro, S. et al. : Evaluation of 5-GHz band MIMO communication quality under the wireless power transmission situation in a spacecraft, in Thailand-Japan MicroWave Conf., August 2012, 1–2.Google Scholar