Hostname: page-component-669899f699-8p65j Total loading time: 0 Render date: 2025-04-27T20:50:53.580Z Has data issue: false hasContentIssue false
  • English
  • Français

Multicell actuator based on a sliding mode control*

Published online by Cambridge University Press:  17 July 2008

O. Béthoux ,
J.-P. Barbot  and
M. Hilairet
O. Béthoux*
Affiliation:
Laboratoire de Génie Électrique de Paris, CNRS UMR 8507, Supélec, Université Paris-Sud, UPMC Université Paris 6, 11 rue Joliot-Curie, Plateau de Moulon, 91192 Gif-sur-Yvette Cedex, France
J.-P. Barbot
Affiliation:
ECS-EA 3649 E.N.S.E.A., 6 avenue du Ponceau, 95014 Cergy-Pontoise, France
M. Hilairet
Affiliation:
Laboratoire de Génie Électrique de Paris, CNRS UMR 8507, Supélec, Université Paris-Sud, UPMC Université Paris 6, 11 rue Joliot-Curie, Plateau de Moulon, 91192 Gif-sur-Yvette Cedex, France
*
[email protected]
Get access

Abstract

This paper deals with reliability of motor drive systems. It focuses on the switching power converter which is the weakest drive part. It investigates a new architecture which provides intrinsic redundancy. The method used in this fault switch detection and diagnosis is based on a sliding mode observer. The original aspect of this new approach is that the observer influences the control algorithm in order to rule out or accept the possibility of the device failure. This leads to the right decision which induces the rebuilding of the converter topology. This fault tolerant control strategy assures continuous operation even though one switch failure occurs.

Keywords

Type
Research Article
Information
The European Physical Journal - Applied Physics , Volume 43 , Issue 2: Reliability in Electromagnetic Systems (IET) , August 2008 , pp. 217 - 223
Copyright
© EDP Sciences, 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

Footnotes

*

This article has been submitted as part of “IET –Colloquium on Reliability in Electromagnetic Systems”, 24 and 25 May 2007, Paris

References

Hanna, R.A., Prabhu, S., IEEE Trans. Ind. Applicat. 33, 1407 (1997) CrossRef
O.V. Thorsen, M. Dalva, A survey of the reliability with an analysis of faults on variable frequency drives in industry, in EPE'95, European Conf. Power Electronics and Applications, Sevilla, Spain, 1995, pp. 1033-1038
Kastha, D., Bose, B.K., IEEE Trans. Ind. Applicat. 30, 1028 (1994) CrossRef
C. Lochot, Ph.D. thesis, Institut National Polytechnique de Toulouse, 1999
Ph. Baudesson, Ph.D. thesis, Institut National Polytechnique de Toulouse, 2000
Th. Meynard, H. Foch, Dispositif de conversion d'énergie électrique à semi-conducteurs, patent: France No. 91.09582; Europe, Japon, USA, Canada No. 92.00652
Th. Meynard, H. Foch, EPE J. 2, 45 (1992) CrossRef
O. Béthoux, J-P. Barbot, Multi-cell chopper control law preserving optimal limit cycles, in IEEE Conf. on Control Applications, CCA/CACSD, Glasgow, Scotland, 2002
O. Béthoux, Ph.D. thesis, Université de Cergy-Pontoise, 2005
R. Bensaid, M. Fadel, Floating voltages estimation in three-cells converters using discrete-time Kalman Filter, IEEE PESC 2001, Vancouver, Canada, July 2001
V.I. Utkin, Sliding Modes in Control and Optimization (Springer-Verlag, 1992)