Crossref Citations
This article has been cited by the following publications. This list is generated based on data provided by
Crossref.
Miyake, Y.
Nishiyama, K.
Makimura, S.
Kawamura, N.
Shimomura, K.
Kadono, R.
Higemoto, W.
Fukuchi, K.
Beveridge, J.L.
Ishida, K.
Matsuzaki, T.
Watanabe, I.
Matsuda, Y.
Sakamoto, S.
Nakamura, S.N.
and
Nagamine, K.
2003.
The muon science facility at the JAERI/KEK joint project.
Physica B: Condensed Matter,
Vol. 326,
Issue. 1-4,
p.
255.
Lafourcade, P.
and
Llibre, M.
2003.
First steps toward a sketch-based design methodology for wire-driven manipulators.
p.
143.
Kobayashi, Hiroaki
and
Ozawa, Ryuta
2003.
Adaptive neural network control of tendon-driven mechanisms with elastic tendons.
Automatica,
Vol. 39,
Issue. 9,
p.
1509.
Kino, H.
and
Setoguchi, T.
2003.
Development of a serial-link structural robot supported by wire cable drive actuators: a basic analysis of two-links robot with a wire cable.
Vol. 1,
Issue. ,
p.
854.
Wang Hongguang
Zhao Mingyang
Fang Lijin
Li Shujun
and
Zhang Bo
2003.
The mechanism and kinematics of a 3-DOF in-parallel actuated manipulator.
Vol. 2,
Issue. ,
p.
804.
Kino, H.
2003.
Principle of orthogonalization for completely restrained parallel wire driven robot.
p.
509.
Chunping Sui
and
Mingyang Zhao
2004.
Control of a 3-DOF Parallel Wire Driven Stiffness-Variable Manipulator.
p.
204.
Merlet, J-P.
2004.
On Advances in Robot Kinematics.
p.
211.
Krut, S.
Company, O.
and
Pierrot, F.
2004.
Force performance indexes for parallel mechanisms with actuation redundancy, especially for parallel wire-driven manipulators.
Vol. 4,
Issue. ,
p.
3936.
Fang, S.
Franitza, D.
Torlo, M.
Bekes, F.
and
Hiller, M.
2004.
Motion Control of a Tendon-BasedParallel Manipulator Using Optimal Tension Distribution.
IEEE/ASME Transactions on Mechatronics,
Vol. 9,
Issue. 3,
p.
561.
Mroz, Geoff
and
Notash, Leila
2004.
Design and prototype of parallel, wire‐actuated robots with a constraining linkage.
Journal of Robotic Systems,
Vol. 21,
Issue. 12,
p.
677.
Franitza, Daniel
and
Fang, Shiqing
2004.
Seilkraftoptimierung für redundante Parallelmanipulatoren mit Seilantrieben.
PAMM,
Vol. 4,
Issue. 1,
p.
155.
Kino, H.
Yabe, S.
Honjo, N.
and
Kawamura, S.
2004.
A sensor-actuator map for organization of position sensor feedback control for multiple links structure / wire driven system.
Vol. 2,
Issue. ,
p.
551.
Ou Ma
and
Xiumin Diao
2005.
Dynamics analysis of a cable-driven parallel manipulator for hardware-in-the-loop dynamic simulation.
p.
837.
Kino, Hitoshi
Yabe, Shigeru
and
Kawamura, Sadao
2005.
A force display system using a serial-link structure driven by a parallel-wire mechanism.
Advanced Robotics,
Vol. 19,
Issue. 1,
p.
21.
Behzadipour, Saeed
and
Khajepour, Amir
2005.
A New Cable-Based Parallel Robot with Three Degrees of Freedom.
Multibody System Dynamics,
Vol. 13,
Issue. 4,
p.
371.
Ottaviano, E.
Ceccarelli, M.
Paone, A.
and
Carbone, G.
2005.
A Low-Cost Easy Operation 4-Cable Driven Parallel Manipulator.
p.
4008.
Kino, H.
Yahiro, T.
Takemura, F.
and
Morizono, T.
2006.
Adaptive Position Control for Fully Constrained Parallel Wire Driven Systems.
p.
79.
Maruyama, Tomoari
Xu, Chunquan
Ming, Aiguo
and
Shimojo, Makoto
2006.
Motion Control of Ultra-High-Speed Manipulator with a Flexible Link Based on Dynamically Coupled Driving.
Journal of Robotics and Mechatronics,
Vol. 18,
Issue. 5,
p.
598.
Ottaviano, Erika
Ceccarelli, Marco
and
Pelagalli, Paolo
2006.
A Performance Analysis of a 4 Cable-Driven Parallel Manipulator.
p.
1.