Low level radioactive liquid discharges have been carried out in the Loire river since 1963. Since then, the number of power plants located on the Loire river and its tributaries has been steadily increasing to reach, in the year 2000, 14 reactors operating on 5 different sites. The question arose to evaluate to what extent the addition of several nuclear power plants on the same river system could increase the concentrations in radionuclides in the environment and affect the dose to the public. To address this issue, EDF initiated in 1998 the “Loire river and estuary radioecology” program with the focus on assessing possible accumulation of radionuclide in river bottom sediments or on river shores. The following radionuclides were considered because of their importance in power plant liquid discharges: tritium, 14C, 58Co, 60Co, $^{110{\rm m}}$Ag, 134Cs, 137Cs, 54Mn, 124Sb, and 131I. Radionuclide concentrations in the dissolved, particulate and sedimentary forms were evaluated using the CRESCENDO model. The development and validation of this model required a multi-step process. The first step was to design a 350-km long 1D hydraulic and water transport based on currently available tools and data. Next, daily tritium concentrations measured in Angers, at the downstream limit of the river, were compared with computed values. The following step was to calibrate the sediment transport model. Areas where fine particles settled (dams and river shores) were monitored to improve our understanding of sediment dynamics. Then equations representing radionuclide exchange between water and particles were derived from laboratory experiments and included in the model. After each step the computed values were compared to measure data sets to ensure the model adequately described the processes involved. In the final step, the CALVADOS model was used to calculate dose to the public at different locations along the Loire river.