Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-23T04:08:42.251Z Has data issue: false hasContentIssue false
  • English
  • Français

Calibration of the Method for Measuring 14C in Combustion Gases

Published online by Cambridge University Press:  26 July 2016

S Chałupnik ,
A Smoliński  and
M Wysocka
S Chałupnik
Affiliation:
Central Mining Institute, Silesian Centre for Environmental Radioactivity, Plac Gwarków 1, 40–166 Katowice, Poland
A Smoliński
Affiliation:
Central Mining Institute, Silesian Centre for Environmental Radioactivity, Plac Gwarków 1, 40–166 Katowice, Poland
M Wysocka
Affiliation:
Central Mining Institute, Silesian Centre for Environmental Radioactivity, Plac Gwarków 1, 40–166 Katowice, Poland
Get access Rights & Permissions [Opens in a new window]

Abstract

Much recent effort has been focused on the development of monitoring methods to calculate the percentage of biomass in the fuel used for energy generation in power plants. One possible method is based on measurements of radiocarbon concentration in combustion gases by liquid scintillation (LS) spectrometry. Fossil fuels contain no 14C due to their age. Therefore, after the combustion of such fuels, the resulting CO2 contains no 14C as well. The only source of 14C comes from the admixture of biomass containing modern carbon. 14C is a beta-emitting radionuclide with a maximum beta energy of 156 keV. There is no emission of gamma rays during decay; therefore, no possibility of gamma spectrometry exists. A difficult task thus is to validate the method and to calibrate it in agreement with the known amount of biomass in the fuel. For this purpose, a set of samples was prepared that were mixtures of hard coal and biomass with a known percentage of carbon. The oxycombustion method was applied for sample preparation in which the combustion of the fuel is done in pure oxygen; therefore, the combustion gas contains mostly CO2 and steam. The CO2 from the gas sample is then adsorbed by 3-methoxypropylamine. A known amount of this absorbent was mixed with a scintillation cocktail and measured in the LS spectrometer. In this way, a calibration curve has been obtained, allowing quantitative measurements of biomass content in the fuel.

Type
Articles
Information
Radiocarbon , Volume 56 , Issue 3 , 2014 , pp. 1207 - 1214
Copyright
Copyright © 2014 by the Arizona Board of Regents on behalf of the University of Arizona 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

European Committee for Standardization (CEN). 2011. Solid recovered fuels. Methods for the determination of biomass content. EN 15440:2011. Brussels.Google Scholar
European Union (EU). 2009. Directive 2009/28/EC of the European Parliament and of the Council of 23 April 2009 on the promotion of the use of energy from renewable sources and amending and subsequently repealing Directives 2001/77/EC and 2003/30/EC (Dz. U. L.140/16.V.52, 2009 r.).Google Scholar
Edler, R. 2009. The use of liquid scintillation counting technology for the determination of biogenic materials. In: Eikenberg, J, Jäggi, M, Beer, H, Baehrle, H, editors. LSC 2008, Advances in Liquid Scintillation Spectrometry. Tucson: Radiocarbon. p 261–7.Google Scholar
International Organization for Standardization (ISO). 2005. Determination of the detection limit and decision threshold for ionizing radiation measurements, Part 7, Fundamentals and general applications. International Standard ISO 19297–7:2005(E). Geneva: ISO Publishing Office.Google Scholar
Molnár, M, Nagy, S, Svingor, É, Svetlik, I. 2005. Refining the CO2 absorption method for low-level 14C liquid scintillation counting in the ATOMKI. In: Chałupnik, S, Schönhofer, F, Noakes, J, editors. LSC 2005, Advances in Liquid Scintillation Spectrometry. Tucson: Radiocarbon. p 407–15.Google Scholar
Smoliński, A. 2011. Coal char reactivity as a fuel selection criterion for coal-based hydrogen-rich gas production in the process of steam gasification. Energy Conversion and Management 52(1):37–45.Google Scholar
Vartti, VP. 2009. Optimizing the counting conditions for carbon-14 for the sample oxidizer-liquid scintillation counting method. In: Eikenberg, J, Jäggi, M, Beer, H, Baehrle, H, editors. LSC 2008, Advances in Liquid Scintillation Spectrometry. p 293–8.Google Scholar
Walanus, A, Goslar, T. 2009. Datowanie radiowglowe [Radiocarbon dating]. Kraków: AGH University of Science and Technology.Google Scholar