After regeneration, the catalyst UOP-R-62 was used for conversion of reforming benzine. The percentage of conversion benzine fraction was considerably smaller than that of the new catalyst sample. To determine the cause of catalyst deactivation, in addition to standard methods of analysis, X-ray diffraction and scanning electron microscopy were used. Real and model samples of UOP-R-62 were analysed. Real samples were prepared with the new catalyst, a used and regenerated catalyst with good activity and a deactivated catalyst. Model samples were prepared from the new catalyst by heating at 400–1100 °C in a porcelain crucible in a muffle furnace for 1 h. Prepared samples were measured in a Philips diffractometer system and examined in a scanning electron microscope. The obtained diffractometer patterns, FWHM value of the 440 reflection of γAl2O3, electron micrographs and images of emitted characteristic X-rays were mutually compared. Only the values obtained from the deactivated catalyst differed from the others. Besides reduced broadening of the 440 line the material exhibited new X-ray diffraction lines, a change in phase composition, and modifications in morphology and microstructure. These changes are an indication that overheating of individual spheres of catalyst UOP-R-62 to a temperature of 700—1100 °C or higher caused their deactivation.