Article contents
Major active faults in Italy: available surficial data
Published online by Cambridge University Press: 01 April 2016
Abstract
An inventory of the available surficial data on active faults in Italy has been compiled by gathering all the available information on peninsular Italy (project by CNR, National Group for the Defense against Earthquakes), the central-eastern Alps and the Po Plain (EC ‘PALEOSIS’ project). Such information has been summarised in maps (reporting surficial expressions of faults with length L≥11 km) and in a table where fault parameters relevant for seismic hazard assessment (e.g. slip rates, recurrence intervals for surface faulting events, etc..) have been reported. Based on the geological characteristics of the Italian territory, a fault has been considered as active if it shows evidence of Late Pleistocene-Holocene displacements. Active faults in Italy are distributed throughout the entire Apennine chain, in the Sicilian and Calabrian regions and in some Alpine sectors, but knowledge is not homogeneously distributed through the territory. The largest amount of data is related to the central Apennines. In contrast, fault geometries and parameters are less well defined in the southern Apennines, Sicily and Calabria, where investigations have started more recently. Knowledge is sparse in the northern Apeninnes, where data necessary to define fault parameters are lacking and also the chronology of the activity has to be considered cautiously. Abundant blind faulting in the Po Plain hinders the detection of active faults by means of the classical surficial investigations and therefore the present knowledge is limited to the Mantova fault. Blind faults and the peculiar recent geological history of the Alpine areas, which is strongly conditioned by the erosional and depositional activity during and after the last glacial maximum, also hinder the identification of active faults in the central-eastern Alps. Some faults in this Alpine sector are believed to be active, but data on their segmentation are still missing. Available information indicates that Italian active faults are usually characterised by slip rates lower than 1 mm/yr. Recurrence intervals for surface faulting events are longer than 1,000 years in the central and southern Apennines. This review on the Italian active faults represents the first step to produce a map of the major seismic sources in Italy, which in turn will result from the merge of surficial data with seismological and geological subsurficial data. The available knowledge gathered in this paper indicates those areas where data are presently sparse. It should be, therefore, possible to better plan future geomorphological and paleoseismological investigations.
- Type
- Research Article
- Information
- Copyright
- Copyright © Stichting Netherlands Journal of Geosciences 2001
References
- 19
- Cited by