Hostname: page-component-cd9895bd7-jn8rn Total loading time: 0 Render date: 2024-12-27T02:03:06.522Z Has data issue: false hasContentIssue false
  • English
  • Français

Wafer Curvature Studies of Strengthening Mechanisms in Thin Films on Substrates

Published online by Cambridge University Press:  10 February 2011

O. S. Leung  and
W. D. Nix
O. S. Leung
Affiliation:
Department of Materials Science and Engineering, Stanford University, Stanford, CA 94305-2205
W. D. Nix
Affiliation:
Department of Materials Science and Engineering, Stanford University, Stanford, CA 94305-2205
Get access

Abstract

The effects of film thickness and passivation on plasticity of thin metal films on substrates have been studied using gold films as a model system. Wafer curvature/thermal cycling measurements were used to study plasticity in films ranging in thickness from 0.2 to 2.5 micrometers. We were able to describe these stress-temperature curves using a simple phenomenological model for linear kinematic hardening. The yield stresses revealed by the modeling were inversely proportional to the film thickness for thicknesses greater than about one micrometer. This relationship is expected from a dislocation model of plasticity. However, the residual stresses in thinner films are substantially lower than this relationship would predict and on unloading, these films show stress-temperature plots not predicted by the model. Stress-temperature curves were also measured after a tungsten passivation was deposited on the gold surface. Films thinner than one micrometer were substantially strengthened by this passivation and could then be described by the linear kinematic model. The observed stresses are only minimally affected for films thicker than about a micrometer. This strengthening effect on thinner films is consistent with the complete blocking of grain boundary diffusion near the free surface of the film.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 594: Symposium V – Thin Films - Stresses & Mechanical Properties VIII , 1999 , 51
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Venkatraman, R., Bravman, J. C., Nix, W. D., Davies, P. W., Flinn, P. A., and Fraser, D. B., J. Electron. Mater. (USA) p. 1231–7 (1990).Google Scholar
2 Nix, W. D., Metall.Trans. A, 20A, 2217–45 (1989).Google Scholar
3 Thompson, C. V., J. of Mater. Res. 8, 237–8 (1993).Google Scholar
4 Shen, Y. L., Suresh, S., He, M. Y, Bagchi, A., Kienzle, O., Ruhle, M., and Evans, A. G., J. Mater. Res. 13, 1928–37 (1998).Google Scholar
5 Kobrinsky, M. J. and Thompson, C. V., Appl. Phys. Lett. 73, 2429–31 (1998).Google Scholar
6 Gao, H., Zhang, L., Nix, W. D., Thompson, C. V., and Arzt, E., Acta Mater. 47, 2865–78 (1999).Google Scholar
7 Keller, R. M., Kuschke, W. M., Kretschmann, A., Bader, S., Vinci, R. P., Arzt, E., Filter, W. F., Rosenberg, R., Greer, A. L., and Gadepally, K., in Materials Reliability in Microelectronics V. Symposium, edited by Oates, A. S. (Mater. Res. Soc, Pittsburgh, PA, 1995), p. 309–14.Google Scholar
8 Keller, R. M., Sigle, W., Baker, S. P., Kraft, O., Arzt, E., Gao, H., and Sundgren, J. E., in Thin Films: Stresses and Mechanical Properties V I. Symposium, edited by Gerberich, W. W. (Mater. Res. Soc, Pittsburgh, PA, 1997), p. 221–6.Google Scholar
9 Thouless, M. D., Acta Metall. et Mater. 41, 1057–64 (1993).Google Scholar