Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-29T07:26:21.257Z Has data issue: false hasContentIssue false

Vt-Shift Compensating Amorphous Silicon Pixel Circuits for Flexible OLED Displays

Published online by Cambridge University Press:  11 February 2011

Kapil Sakariya
Affiliation:
Electrical and Computer Engineering, University of Waterloo Waterloo, Ontario N2L 3G1, [email protected]
Peyman Servati
Affiliation:
Electrical and Computer Engineering, University of Waterloo Waterloo, Ontario N2L 3G1, [email protected]
Denis Striakhilev
Affiliation:
Electrical and Computer Engineering, University of Waterloo Waterloo, Ontario N2L 3G1, [email protected]
Arokia Nathan
Affiliation:
Electrical and Computer Engineering, University of Waterloo Waterloo, Ontario N2L 3G1, [email protected]
Get access

Abstract

In this paper, we present design considerations pertinent to amorphous silicon pixel circuits for mechanically flexible active matrix display applications. We describe both circuit topologies and pixel architectures that are amenable to surface emissive pixels in a-Si:H technology. Metastable shifts in the a-Si:H material characteristics after prolonged gate bias or mechanical stress are manifested in the form of increasing TFT threshold voltages and varying mobilities. As a result, the TFT drive current and consequently the OLED brightness decrease, and the pixel eventually turns off. The circuits presented here compensate for this decrease in current through the use of current programming and feedback, and allow for stable OLED brightness over longer time periods. They also enable the implementation of high aperture ratio (close to 100%), low leakage current, surface emissive OLED pixels. Results show that the circuits provide higher linearity and dynamic range than currently available pixel circuits while minimizing the pixel area. Charge injection effects at the gate of the drive TFT have been reduced by using smaller switching TFTs, along with circuit topologies that provide in-pixel current gain. All circuits meet the speed requirements of a QVGA 60 Hz refresh rate display, and occupy less than 300um x 300um area.

Type
Research Article
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Tang, C. W., “An Overview of organic electroluminescent materials and devices,” SID Int. Symp. 1996, Vol. 27, pp. 181184.Google Scholar
2. Cambridge Display Technology (CDT), http://www.cdtltd.co.uk/ Google Scholar
3. Universal Display Corp. (UDC), http://www.universaldisplay.com/ Google Scholar
4. Gleskova, H., Wagner, S., and Suo, Z., “a-Si:H thin film transistors after very high strain,” Journal of Non-Crystalline Solids, Vol. 266–269 part 2, pp. 13201324, May 2000.Google Scholar
5. Miri, A. M. and Chamberlain, S. G., “A totally wet etch fabrication technology for amorphous silicon thin film transistors,” Mat. Res. Soc. Symp. Proc., Vol. 377, pp. 737742, 1995.Google Scholar
6. van Berkel, C. and Powell, M. J., “Resolution of amorphous silicon thin-film transistor instability mechanisms using ambipolar transistors,” App. Phys. Lett., Vol. 51, no. 14, pp. 10941096, Oct. 1987.Google Scholar
7. Mohan, N., Karim, K. S., Nathan, A., ‘Design of multiplexer in Amorphous Silicon Technology’, J. Vac. Sci. Tech. A, Vol. 40, p. 1043, 2002.Google Scholar
8. Gu, G. and Forrest, S. R., “Design of Flat-Panel Displays Based on Organic Light- Emitting Devices,” IEEE Journal of Selected Topics in Quantum Electronics, Vol. 4, No. 1, pp. 8399, Jan./Feb. 1998.Google Scholar
9. He, Y., Hattori, R., Kanicki, J., ‘Current-source a-Si:H thin film transistor circuit for active matrix organic light emitting displays’, IEEE Electron Device Letts., Vol. 21, p. 590, 2000.Google Scholar