Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-25T15:24:42.488Z Has data issue: false hasContentIssue false
  • English
  • Français

Ultraviolet-Assisted Pulsed Laser Deposition of Barium Strontium Titanate on Si: Characterization of the Interfacial Layer

Published online by Cambridge University Press:  01 February 2011

V. Craciun ,
D. Craciun ,
N. D. Bassim ,
J. M. Howard  and
R. K. Singh
V. Craciun
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville, FL 326110 Laser Department, National Institute for Laser, Plasma, and Radiation Physics, Bucharest, Romania
D. Craciun
Affiliation:
Laser Department, National Institute for Laser, Plasma, and Radiation Physics, Bucharest, Romania
N. D. Bassim
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville, FL 326110
J. M. Howard
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville, FL 326110
R. K. Singh
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville, FL 326110
Get access

Abstract

Barium strontium titanate (BST) thin films were grown directly on Si substrates by the conventional and ultraviolet-assisted pulsed laser deposition techniques. X-ray photoelectron spectroscopy, x-ray diffraction and reflectivity, variable angle spectroscopic ellipsometry, current-voltage, capacitance-voltage, and high-resolution transmission electron microscopy were used to investigate the composition, thickness, and electrical properties of the grown structures. It has been found that at the interface between the Si substrate and the grown dielectric layer, an interfacial layer was always formed. The chemical composition of the layer consisted of SiOx partially mixed with the grown BST, without any evidence of silicate formation.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 718: Symposium D – Perovskite Materials , 2002 , D7.14
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Singh, R. K. and Kumar, D., Mat. Sci. Engr. Reports R22, 113 (1998).Google Scholar
2. Craciun, V. and Singh, R. K., Electrochem. Solid-State. Lett. 2, 446 (1999).Google Scholar
3. Craciun, V., Lambers, E. S., Bassim, N. D., Singh, R.K., and Craciun, D., J. Mater. Res. 15 (2000) 488.Google Scholar
4. Craciun, V., Singh, R.K., Perriere, J., Spear, J., and Craciun, D., J. Electrochem. Soc. 147, 1077 (2000).Google Scholar
5. Srivastava, A., Craciun, V., Howard, J. M., and Singh, R. K., Appl. Phys. Lett. 75, 3002 (1999).Google Scholar
6. Craciun, V. and Singh, R. K., Appl. Phys. Lett. 76, 1932, (2000).Google Scholar
7. Craciun, V., Howard, J. M., Bassim, N. D., and Singh, R. K., Transport and Microstructural Phenomena in Oxide Electronics, Editors: Blank, Dave H., Ginley, David S., Hawley, Marilyn E., Streiffer, Stephen K., Paine, David C., MRS Proceedings Volume 666, F11.4 (2001).Google Scholar
8. Craciun, V., Bassim, N. D., Howard, J. M., Spear, J., Bates, S., Singh, R. K. MRS Spring Meeting, Transport and Microstructural Phenomena in Oxide Electronics, Editors: Blank, Dave H., Ginley, David S., Hawley, Marilyn E., Streiffer, Stephen K., Paine, David C., MRS Proceedings Volume 666, F8.11.1 (2001).Google Scholar
9. Wilk, G. D. and Wallace, R. M., Appl. Phys. Lett. 76, 112, (2000).Google Scholar
10. Iacona, F., Kelly, R., and Marletta, G., J. Vac. Sci. Technol. A 17, 2771, (1999).Google Scholar
11. Knauss, L. A., Pond, J. M., Horwitz, J. S., Chrisey, D. B., Mueller, C. H., and Treece, R., Appl. Phys. Lett. 69, 25, (1996).Google Scholar