Hostname: page-component-cd9895bd7-mkpzs Total loading time: 0 Render date: 2024-12-27T01:57:36.261Z Has data issue: false hasContentIssue false
  • English
  • Français

Tunable Infrared Detection Using Epitaxial Silicide/Silicon Heterostructures

Published online by Cambridge University Press:  03 September 2012

I. Sagnes ,
Y. Campidelli ,
F. Chevalier ,
S. Bodnar ,
C. Renard  and
P. A. Badoz
I. Sagnes
Affiliation:
FRANCE TELECOM-CNET, BP 98, 38243 Meylan Cedex, France
Y. Campidelli
Affiliation:
FRANCE TELECOM-CNET, BP 98, 38243 Meylan Cedex, France
F. Chevalier
Affiliation:
FRANCE TELECOM-CNET, BP 98, 38243 Meylan Cedex, France
S. Bodnar
Affiliation:
FRANCE TELECOM-CNET, BP 98, 38243 Meylan Cedex, France
C. Renard
Affiliation:
LETI-CEA-Technologies Avancées, CENG-DOPT/S.LIR, 85X-38041 Grenoble Cedex, France
P. A. Badoz
Affiliation:
FRANCE TELECOM-CNET, BP 98, 38243 Meylan Cedex, France
Get access

Abstract

A new silicide/silicon IR detector is presented which has the potential for multicolour detection due to the tunability of its photoresponse. This tunable internal photoemission sensor (TIPS) fabricated using the Ir/Si/ErSi2 system, consists of two back–to–back Schottky diodes separated by a thin undoped Si layer. The two metals have different Schottky barrier heights so that the depleted Si forms an asymmetrical potential barrier to the carriers photocreated in each metallic film. The photocurrent flowing between the two metallic films is therefore strongly dependent on the shape and height of the effective potential barrier that can be varied by a bias applied between the two metallic electrodes. The Ir/Si/ErSi2 photoresponse and cut–off wavelength are indeed dramatically modulated when a small bias (less than 1 volt) is applied between the Ir and ErSi2 electrodes. The quantum efficiencies, measured in the 1 to 3 μm range, are comparable to the best obtained in Schottky and SiGe/Si internal photoemission detectors. A quantitative model derived from the Fowler formalism (by taking into account (i) the hole and electron photocurrents and (ii) the wavelength dependence of the photon absorption in each metallic film) fits all the experimental data over the whole range of photon energy and applied biases. The effective barrier heights thus measured as a function of applied bias are in good agreement with those deduced from activation energy analysis of the TIPS dark current and show that the cut–off wavelength can be modulated from 2.5 μm to more than 6 μm. Finally, electrical and photoresponse measurements on Cr/Si/SiGe(p+) structures (using the same TIPS mode of operation) also demonstrate the photoresponse tunability, thus combining the TIPS tunability with the extended wavelength range of operation (up to 10 μm) of SiGe/Si detectors.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 320: Symposium D – Silicides, Germanides, and Their Interfaces , 1993 , 65
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Pires, J. de Sousa, All, P., Crowder, B., d'Heurle, F., Petersson, S., Stolt, L., and Tove, P.A., Appl. Phys. Lett. 35 (1979) 202.CrossRefGoogle Scholar
2 Duboz, J.y., Badoz, P.A., d'Avitaya, F. Arnaud, and Rosencher, E., Phys. Rev. B40 (1989) 10607.CrossRefGoogle Scholar
3 Pahun, L., Campidelli, Y., d'Avitaya, F. Arnaud, and Badoz, P.A., Appl. Phys. Lett. 60 (1992) 1156.CrossRefGoogle Scholar
4 d'Avitaya, F. Arnaud, Badoz, P.A., Campidelli, Y., Chroboczek, J.A., Duboz, J.Y., Perio, A., and Pierre, J., Thin Solid Films 184 (1990) 283.CrossRefGoogle Scholar
5 Sagnes, I., Campidelli, Y., Vincent, G., and Badoz, P.A., Materials Science and Engineering B21 (1993) 312.CrossRefGoogle Scholar
6. Born, M. and Wolf, E., Principal of Optics (Pergamon, New York, 1970), Chap. 10.Google Scholar
7 Palik, E.D., Handbook of optical constants of solids (Academic Press, 1985), pp. 296 and 547.Google Scholar
8 Sagnes, I., Vincent, G., and Badoz, P.A., J. Appl. Phys. 72 (1992) 4295.CrossRefGoogle Scholar
9 Fowler, R.H., Phys. Rev. 38 (1931) 45.CrossRefGoogle Scholar
10 Sze, S.M., Physics of semiconductors devices (John Wiley, 1981), chap. 5.Google Scholar
11 Regolini, J.L., Bensahel, D., Scheid, E., and Mercier, J., Appl. Phys. Lett. 54 (1989) 658.CrossRefGoogle Scholar
12 Glowacki, F. and Campidelli, Y., E-MRS, Strasbourg 1993, to be published.Google Scholar
13 Tsaur, B.Y., Chen, C.K., and Marino, S.A., IEEE Electron Device Lett. 12 (1991) 293.CrossRefGoogle Scholar