Hostname: page-component-586b7cd67f-rcrh6 Total loading time: 0 Render date: 2024-11-20T07:18:30.683Z Has data issue: false hasContentIssue false

Time-Dependent Capture Numbers with Repulsive Pair Interactions: Cu/Cu(111) and Ge/Si(001)

Published online by Cambridge University Press:  11 February 2011

J. A. Venables
Affiliation:
Department of Physics & Astronomy, Arizona State University, Tempe AZ 85287–1504, U.S.A. School of Chemistry, Physics & Environmental Science, University of Sussex, Brighton, U.K.
H. Brune
Affiliation:
Institut de Physique des Nanostructures, EPFL, CH 1015 Lausanne, Switzerland.
J. Drucker
Affiliation:
Department of Physics & Astronomy, Arizona State University, Tempe AZ 85287–1504, U.S.A.
Get access

Abstract

Recent experiments and calculations have shown that weak repulsive interactions between adsorbate atoms may shift nucleation kinetics from the well-known diffusion limit towards the attachment-limited case. The distinctions between diffusion- and attachment-limited kinetics are clarified, and the increased importance of the transient nucleation regime in the latter case is shown to be due to a combination of delayed nucleation and reduced capture. A time-dependent interpolation scheme between attachment- and diffusion-limited capture numbers is proposed, and tested against KMC simulations. Using this scheme to interpret recent STM results on Cu/Cu(111), bounds on the maximum adatom-adatom potential repulsive energy of 12±2 meV are deduced. Time-dependent effects also occur in the growth and ripening of strained Ge islands on Si(001), and the similarities and differences between these two systems are discussed.

Type
Research Article
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Venables, J.A., Surface Sci. 299/ 300, 798 (1994).Google Scholar
2. Brune, H., Surface Sci. Rep. 31, 121 (1998);Google Scholar
Brune, H., Bales, G.S., Jacobsen, J., Boragno, C. and Kern, K., Phys. Rev. B 60, 5991 (1999).Google Scholar
3. Venables, J.A., Introduction to Surface and Thin Film Processes (CUP, 2000), chaps 4, 5 & 7.Google Scholar
4. Venables, J.A. and Brune, H., Phys. Rev. B 66, 195404 (2002).Google Scholar
5. Repp, J., Moresco, F., Meyer, G., Rieder, K-H., Hyldgaard, P. and Persson, M., Phys. Rev. Lett. 85, 2981 (2000).Google Scholar
6. Knorr, N., Brune, H., Epple, M., Hirstein, A., Schnieder, M.A. and Kern, K., Phys. Rev. B 65, 115420 (2002).Google Scholar
7. Bogicevic, A., Ovesson, S., Hyldgaard, P., Lundqvist, B.I., Brune, H. and Jennison, D.R., Phys. Rev. Lett. 85, 1910 (2000);Google Scholar
Ovesson, S., Bogicevic, A., Wahnström, G. & Lundqvist, B.I., Phys. Rev. B 64, 125423 (2001);Google Scholar
Ovesson, S., Phys. Rev. Lett. 88, 116102 (2002).Google Scholar
8. Fichthorn, K.A. and Scheffler, M., Phys. Rev. Lett. 84, 5371 (2000);Google Scholar
Fichthorn, K.A., Merrick, M.L. and Scheffler, M., Appl. Phys. A 75, 17 (2002).Google Scholar
9. Venables, J.A., Phil. Mag. 27, 697 (1973) and references quoted.Google Scholar
10. Kandel, D., Phys. Rev. Lett. 78, 499 (1997).Google Scholar
11. Tromp, R.M. and Mankos, M., Phys. Rev. Lett. 81, 1050 (1998).Google Scholar
12. Thies, W. and Tromp, R.M., Phys. Rev. Lett. 76, 2770 (1996);Google Scholar
Tromp, R.M. and Hannon, J.B., Surface Rev. Lett. 9, 1565 (2002).Google Scholar
13. Krishnamurthy, M., Drucker, J.S. and Venables, J.A, J. Appl. Phys. 69, 6461 (1991);Google Scholar
Drucker, J., Phys. Rev. B 48, 18203 (1993).Google Scholar
14. Chaparro, S.A., Zhang, Y., Drucker, J., Chandrasekhar, D. and Smith, D.J., J. Appl. Phys. 87, 2245 (2000);Google Scholar
Chaparro, S.A., Zhang, Y. and Drucker, J. Appl. Phys. Lett. 76, 3534 (2000).Google Scholar
15. Venables, J.A., Bennett, P.A., Brune, H., Drucker, J. and Harding, J.H., Phil. Trans. R. Soc. Lond. A 361, in press (2003), and work in progress.Google Scholar