Hostname: page-component-586b7cd67f-tf8b9 Total loading time: 0 Render date: 2024-11-25T15:50:01.156Z Has data issue: false hasContentIssue false
  • English
  • Français

The Temperature Dependent Damping Behavior of Novel Nanocomposites for Structural Materials Applications

Published online by Cambridge University Press:  01 February 2011

Ramazan Asmatulu ,
Rick Claus ,
Jeff Mecham  and
Dan Inman
Ramazan Asmatulu
Affiliation:
Fiber & Electro Optics Research Center, Bradley Department of Electrical and Computer Engineering, Virginia Tech, Blacksburg, VA 24061
Rick Claus
Affiliation:
Fiber & Electro Optics Research Center, Bradley Department of Electrical and Computer Engineering, Virginia Tech, Blacksburg, VA 24061 NanoSonic Inc., 1485 South Main Street, Blacksburg, VA 24060
Jeff Mecham
Affiliation:
NanoSonic Inc., 1485 South Main Street, Blacksburg, VA 24060
Dan Inman
Affiliation:
Center for Intelligent Materials, Virginia Tech, Blacksburg, VA 24061.
Get access

Abstract

Near nanoscale fine particles including vanadium dioxide (VO2) and zinc oxide (ZnO) were incorporated into matrix materials (tin and polymer adhesives). A number of mechanical damping tests were conducted on the prepared composite materials at frequency ranges of 0 − 2 kHz and over a broad temperature range. The mechanical vibration test results showed that VO2 and ZnO gave significantly higher negative-stiffness (or damping) at approximately 68 °C (155 F) and 29 °C (85 F). For example, approximately 15% and 12% damping values were achieved at first and second resonance frequencies, respectively, which can potentially prevent vibration on the materials. This significant improvement on the damping of the nanocomposite material may be because of the ferroelasticity, viscoelasticity and/or interfacial sliding at those particular temperatures. It was also observed the etching of substrate surfaces improved adhesion and contributed consistent results to vibration testing reproducibility. Thus, it is concluded that nanocomposite existing damping properties can be an important method to achieve large damping responses over a broad temperature range.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 791: Symposium Q – Mechanical Properties of Nanostructured Materials and Nanocomposites , 2003 , Q2.7
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Lakes, R.S., Lee, T., Bersie, A. and Wang, Y.C., Nature 2001, 410, 565–567.Google Scholar
2. Salje, E.K.H., Phase Transitions in Ferroelastic and Co-Elastic Crystals Cambridge press, New York, NY, 1990, pp. 4–10, 283–286.Google Scholar
3. http://silver.neep.wisc.edu/~lakes/Poisson.html Google Scholar
4. Edwards, L.K., Lakes, R.S. and Nixon, W.A., Journal of Applied Physics, Vol. 87, No: 3, February 1, 2000, 1135–1140.Google Scholar
5. Luo, X. and DDL., Chung, Carbon 38(2000) 1499–1524.Google Scholar
6. Biaobing, W., Zuowan, Z. and Lixia, G., Materials Research Bulletin, 38(2003), 1149–1455.Google Scholar
7. Li, S., Hu, J., Song, F. and Wang, X., Cement and Concrete Composites, 18(1996) 445–453.Google Scholar
8. Park, I.M., Choi, I.D., Cho, K.M., Kim, B.R. “High Temperature and Damping Properties of Squeeze Cast Hybrid Mg Matrix Composites,” Proceeding of the 65th World Foundry Congress, Gyeongju, Korea, 2002, 489–498.Google Scholar
9. Unpublished damping reports (Virginia Tech & Nanosonic, Inc.)Google Scholar
10. Xiaonong, Z., Di, Z., Renjie, W., Zhengang, Z. and Can, W., Scripta Materials, Vol. 37, No: 11, 1997, 1631–1635.Google Scholar
11. Austin, E.M. “Influence of Higher Order Modeling Techniques on the Analysis of Layered Viscoelastic Damping Treatments,” PhD Thesis at Virginia Tech, 1998.Google Scholar
12. Lam, M.J., Saunders, W.R. and Inman, D.J., Smart Materials and Structures, Vol. 9, No: 3, 2000, 362–371.Google Scholar
13. Hegewald, T. and Inman, D.J., Journal of Intelligent Material Systems and Structures, Vol. 12, No: 3, 2001, 191–203.Google Scholar
14. Wang, Y.C. and Lakes, R.S., Journal of Applied Physics, Vol. 90, No: 12, December 15, 2001, 6458–6465.Google Scholar
15. Asmatulu, R., Claus, R.O. and Tuzcu, I. “Adhesion Failures of Thin Film Coatings by Internal and External Stresses at Interfaces,” Proceedings of the 5th International Congress on Thermal Stresses and Related Topics, TS2003, 8–11 June 2003, MA–6.Google Scholar
16. Tuzcu, I., Asmatulu, R. and Hasanyan, D. “Control of the Vibration and Temperature in a Thermoelastic Rod,” Proceeding of the 5th International Congress on Thermal Stresses and Related Topics, TS2003, 8–11 June 2003, Blacksburg, VA, pp. WA–6/WA-6–1–4.Google Scholar