Hostname: page-component-6bf8c574d5-qdpjg Total loading time: 0 Render date: 2025-02-18T06:41:59.583Z Has data issue: false hasContentIssue false
  • English
  • Français

Structure and Physical Properties of TiO2-V2O5 Gel Coatings

Published online by Cambridge University Press:  25 February 2011

Hiroshi Hirashima  and
Seiji Kamimura
Hiroshi Hirashima
Affiliation:
Keio University, Faculty of Science and Technology, Hiyoshi 3–14–1, Kohoku-ku, Yokohama, 223, Japan
Seiji Kamimura
Affiliation:
Keio University, Faculty of Science and Technology, Hiyoshi 3–14–1, Kohoku-ku, Yokohama, 223, Japan
Get access

Abstract

Semiconducting V2O5 gels containing up to 30 mol% of TiO2 were prepared through simultaneous hydrolysis of alkoxides in ethanol solution. Coatings of these gels about 5 nm to 20 μm,in thickness were made by dip coating. The coatings were yellowish green and transparent. The fiber-like structure of the gels was observed by TEM. The gels were about 10 nm or less in diameter, and the diameter decreased with increasing TiO2 content. The refractive indices, n, and the thickness, d, of the coatings were determined by ellipsometry. d was approximately proportional to the square root of the pulling rate. When d was less than 10 nm, the refractive indices parallel to the pulling direction were lower than those perpendicular to the pulling direction. The dc conductivity parallel to the surface of the coatings, σ//, of V2O5 gel coating was higher than that of crystalline V2O5. The dc conductivity perpendicular to the surface of the coatings, σ/, was about 3 to 4 orders of magnitude lower than σ//. With increasing Tio2 content, both σ// and σ/ decreased.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 121: Symposium H – Better Ceramics Through Chemistry III , 1988 , 779
Copyright
Copyright © Materials Research Society 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Livage, J., in Better Ceramics Through Chemistry, edited by Brinker, C.J., Clark, D.E., and Ulrich, D.R. (Mater. Res. Soc. Proc. 32, Pittsburgh, PA 1984) pp. 125–134.Google Scholar
2. Hirashima, H., Koyama, T., and Yoshida, T., Yogyo-Kyokai-Shi, 93, 554 (1985).Google Scholar
3. Hirashima, H., Kamimura, S., Muratake, R., and Yoshida, T., presented at the 4th International Workshop on Glasses and Glass-Ceramics from Gels, Kyoto, Japan 1987 (to be published in J. Non-Cryst. Solids).Google Scholar
4. Sakka, S., Kamiya, K., Makita, K., and Yamamoto, Y., J. Non-Cryst. Solids, 63, 223 (1984).Google Scholar
5. Sayer, M. and Mansingh, A., Phys. Rev. B 6, 4629 (1972).Google Scholar
6. Azzam, R.M.A. and Bashara, N.M., Ellipsometry and Polarized Light, Paperback ed. (North-Holland, Amsterdam, 1987) p. 359.Google Scholar
7. Ezoe, M., Murase, Y., Daimon, K., and Kato, E., Yogyo-Kyokai-Shi, 94, 823 (1986);Google Scholar
Ezoe, M. and Kato, E., Yogyo-Kyokai-Shi, 95, 1207 (1987).Google Scholar