Hostname: page-component-586b7cd67f-gb8f7 Total loading time: 0 Render date: 2024-11-23T03:21:27.874Z Has data issue: false hasContentIssue false
  • English
  • Français

Structural Characterization Of Laser Lift-Off GaN

Published online by Cambridge University Press:  10 February 2011

Eric A. Stach ,
M. Kelsch ,
W.S. Wong ,
E.C. Nelson ,
T. Sands  and
N.W. Cheung
Eric A. Stach
Affiliation:
National Center for Electron Microscopy, Materials Science Division, Lawrence Berkeley National Laboratory, Berkeley, CA 94720: email: [email protected]; http://ncem.lbl.gov
M. Kelsch
Affiliation:
National Center for Electron Microscopy, Materials Science Division, Lawrence Berkeley National Laboratory, Berkeley, CA 94720: email: [email protected]; http://ncem.lbl.gov On leave from the Max Plank Institute für Metallforschung, Stuttgart, Germany
W.S. Wong
Affiliation:
Department of Materials Science and Engineering, University of California, Berkeley, CA 94720
E.C. Nelson
Affiliation:
National Center for Electron Microscopy, Materials Science Division, Lawrence Berkeley National Laboratory, Berkeley, CA 94720: email: [email protected]; http://ncem.lbl.gov
T. Sands
Affiliation:
Department of Materials Science and Engineering, University of California, Berkeley, CA 94720
N.W. Cheung
Affiliation:
Department of Electrical Engineering and Computer Science, University of California, Berkeley 94720
Get access

Abstract

Laser lift-off and bonding has been demonstrated as a viable route for the integration of III-nitride opto-electronics with mainstream device technology. A critical remaining question is the structural and chemical quality of the layers following lift-off. In this paper, we present detailed structural and chemical characterization of both the epitaxial layer and the substrate using standard transmission electron microscopy techniques. Conventional diffraction contrast and high resolution electron microscopy indicate that the structural alteration of the material is limited to approximately the first 50 nm. Energy dispersive electron spectroscopy line profiles show that intermixing is also confined to similar thicknesses. These results indicate that laser lift-off of even thin layers is likely to result in materials suitable for device integration. Additionally, because the damage to the sapphire substrate is minimal, it should be possible to polish and re-use these substrates for subsequent heteroepitaxial growths, resulting in significant economic benefits.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 617: Symposium J – Laser-Solid Interactionsfor Materials Processing , 2000 , J3.5
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Nakamura, S., et al. MRS Int. J. Nitride Semi. Res., 4S1, 1999.Google Scholar
2 For a review, see Denbaars, S.P, Proc. IEEE; 85, 1740 1997.Google Scholar
3 Kelly, M.K., Ambacher, O., Dimitrov, R., Handschuh, R., Stutzmann, M.; phys. stat. sol. a. 159, R3–4, 1997; Kelly, et al.; Jap. J. Appl. Phys., Part 2.38, (3A) p.L217, 1997.Google Scholar
4 Wong, W.S., Sands, T., and Cheung, N.W., Appl. Phys. Lett. 72, 599 (1998).Google Scholar
5 Wong, W.S., Sands, T., Cheung, N.W., Kneissl, M., Bour, D.P., Mei, P., Romano, L.T. and Johnson, N.M., Appl. Phys. Lett. 75, 1360 (1999).Google Scholar
6 Wong, W.S., Cho, Y., Weber, E.R., Sands, T., Yu, K.M., Krüger, J., Wengrow, A.B. and Cheung, N.W., Appl. Phys. Lett. 75, 1887 (1999).Google Scholar
7 Wong, W.S., Wengrow, A.B., Cho, Y., Salleo, A., Quitoriano, N.J., Cheung, N.W., and Sands, T., J. Electron. Mater. 28,1409 (1999).Google Scholar
8 Bravman, J.C. and Sinclair, R., J. Elect. Mic. Tech. 1, 53, 1984.Google Scholar
9 Wolk, J.A., Yu, K.M., Bourret-Courchesne, E.D. and Johnson, E., Appl. Phys. Lett. 70, 2268 (1997).Google Scholar
10 Selke, H., Einfeldt, S., Birkle, U., Hommel, D. and Ryder, P.L., in Microscopy of Semiconducting Materials, 10th vol. Oxford (1997).Google Scholar
11 Potin, V., Vermaut, P., Ruterana, R. and Nouet, G., J. Elect. Mat. 27, 266 (1998).Google Scholar