Hostname: page-component-586b7cd67f-t7fkt Total loading time: 0 Render date: 2024-11-25T17:31:21.472Z Has data issue: false hasContentIssue false
  • English
  • Français

Stress Induced During the Solid-phase Crystallization of Amorphous Silicon Deposited by LPCVD

Published online by Cambridge University Press:  15 February 2011

T. Mohammed-Brahim ,
K. Kis-Sion ,
D. Briand ,
M. Sarret ,
F. Lebihan  and
B. Fortin
T. Mohammed-Brahim
Affiliation:
GMV Universitd Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
K. Kis-Sion
Affiliation:
GMV Universitd Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
D. Briand
Affiliation:
GMV Universitd Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
M. Sarret
Affiliation:
GMV Universitd Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
F. Lebihan
Affiliation:
GMV Universitd Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
B. Fortin
Affiliation:
GMV Universitd Rennes I, Campus de Beaulieu, 35042 Rennes Cedex, France
Get access

Abstract

The Solid Phase Crystallization (SPC) of amorphous silicon films deposited by Low Pressure Chemical Vapor phase Deposition (LPCVD) using pure silane at 550'C was studied by in-situ monitoring the film conductance. The saturation of the conductance at the end of the crystallization process is found transient. The conductance decreases slowly after the onset of the saturation. This degradation is also observed from other analyses such as ellipsometry spectra, optical transmission and Arrhenius plots of the conductivity between 250 and 570K. Hall effect measurements show that the degradation is due to a decrease of the free carrier concentration n and not to a decrease of the mobility. This indicates a constant barrier height at the grain boundaries. The decrease of n is then due to a defect creation in the grain. Hence, whatever the substrate used, an optimum crystallization time exists. It depends on the amorphous quality film which is determined by the deposition techniques and conditions and on the crystallization parameters.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 403: Symposium I – Polycrystalline Thin Films: Structure, Texture, Properties and Applications II , 1995 , 513
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Miura, H., Ohta, H., Okamoto, N. and Kaga, T., Appl. Phys. Lett. 60, 2746 (1992).Google Scholar
2. Janai, M., Alfred, D.D., Booth, D.C. and Seraphin, B.O., Solar Energy Materials 1, 11 (1979).Google Scholar
3. Hashimoto, C.M., Miura, H., Asayama, K., Ohta, H. and Ikeda, S., in 50th Annual Device Research Conference, Cambridge, USA (1992)Google Scholar
4. Mohammed-Brahim, T., Kis-Sion, K., Briand, D., Sarret, M. and Bonnaud, O., 13th European Photovoltaic Solar Energy Conference 23–27 October 1995 Nice (France) Proccedings in press.Google Scholar
5. Briand, D., Sarret, M., Duverneuil, P., Mohammed-Brahim, T. and Kis-Sion, K., J. Physique (France) C5, 887 (1995)Google Scholar
6. Ada-Hanifi, M., Sicart, J., Dusseau, J.M., Robert, J.L., J. Appl. Phys. 63, 2311 (1988)Google Scholar
7. Werner, J.H., in Polycrystalline Semicconductors III. edited by Strunk, H.P., Werner, J.H., Fortin, B. and Bonnaud, O. (Solid State Phenomenon 37–38, Scitec Publications, Switzerland, 1994), p. 213 Google Scholar
8. Veprek, S., Iqbal, Z. and Sarrot, F.A., Phil. Mag. B 45, 137 (1982)Google Scholar