Hostname: page-component-586b7cd67f-rcrh6 Total loading time: 0 Render date: 2024-11-25T18:54:25.056Z Has data issue: false hasContentIssue false
  • English
  • Français

Stress in Giant Magnetoresistive Ni66Fe16Co18/Ag Multilayer thin Films

Published online by Cambridge University Press:  21 February 2011

J.D. Jarratt  and
J.A. Barnard
J.D. Jarratt
Affiliation:
Department of Metallurgical and Materials Engineering The University of Alabama, Tuscaloosa, Alabama 35487–0202.
J.A. Barnard
Affiliation:
Department of Metallurgical and Materials Engineering The University of Alabama, Tuscaloosa, Alabama 35487–0202.
Get access

Abstract

Thin film stress has been measured in (Ni66Fe16Co18 25 Å/Ag 50 Å) multilayer thin films that exhibit annealing-induced giant magnetoresistance (GMR) known as ‘discontinuous’ GMR1. This GMR results when NiFeCo layers are broken up into discontinuous ferromagnetic islands or platelets by immiscible Ag atom grain boundary diffusion normal to the film plane. As-deposited films display no GMR and are in compression. An MR value of 5 % with a relatively sharp profile can be induced in a ten bilayer sample annealed at 400°C for 15 min. Annealing generally results in a decrease in the as-deposited compressive stress and can result in tensile stress at high enough temperatures. Interestingly, at the annealing temperatures corresponding to the maximum induced GMR, there is a plateau in the otherwise monotonic decrease in compressive stress with increasing temperature.

Stress-temperature plots reveal a plateau in the stress value during the heating of a ten bilayer sample due to plastic deformation in the film via densification. Isothermal stress-time plots done on a single sample show increasing compressive stress relief after each successively higher temperature anneal. The stress was also measured in a single bilayer film with the same volume of film as in a ten bilayer sample but far fewer interfaces. High and low angle x-ray diffraction (HXRD, LXRD) was used to reveal the structural evolution with annealing. Magnetic (M-H) hysteresis measurements revealed increasing coercivity and decreasing induced as-deposited in-plane magnetic uniaxial anisotropy with annealing temperature.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 356: Symposium B2 – Thin Films: Stresses and Mechanical Properties V , 1994 , 403
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Hylton, T.L., Coffey, K.R., Parker, M.A., Howard, J.K., Science 261, 1021 (1993).Google Scholar
[2] Baibich, M.N., Broto, J.M., Fert, A., Nguyen Van Dau, F., Petroff, F., Eitenne, P., Creuzet, G., Friederich, A., Chazelas, J., Phys. Rev. Lett. 61, 2472 (1988).Google Scholar
[3] Binasch, G., Griinberg, P., Saurenbach, F., Zinn, W., Phys. Rev. B. 39(7), 4828 (1989).Google Scholar
[4] J.C. Slonczewski, J. Magn. Magn. Mater. 129, L123 (1994).Google Scholar
[5] Tolman, C.H., J. Appl. Phys. 38, 3409 (1967).Google Scholar
[6] McKeehan, L.W., Phys. Rev. 51, 136 (1937).Google Scholar
[7] Jimbo, M., Kanda, T., Goto, S., Tsunashima, S., Uchiyama, S., Jpn. J. Appl. Phys. 31, L1348 (1992).Google Scholar
[8] Hossain, S., Seale, D., Qiu, G., Jarratt, J., Barnard, J.A., Fujiwara, H., Parker, M.R., J. Appl. Phys. 75(10), 7067 (1994).Google Scholar
[9] Jarratt, J.D. and Barnard, J.A., Mater. Res. Soc. Symp. Proc. 343, 399 (1994).Google Scholar
[10] Hoffman, R.W., Phvsics of Thin Films. Vol. 3, Academic Press, New York, 211 (1966).Google Scholar
[11] d’Heurle, F. M., Berenbaum, L., Rosenberg, R, Trans. Met. Soc. A1ME 242, 502 (1968).Google Scholar
[12] Gardner, D.S. and Flinn, P.A., J. Appl. Phys. 67(15), 1831 (1990).Google Scholar
[13] Prutton, M., Thin Ferromagnetic Films. Butterworths & Co., London (1964).Google Scholar
[14] Stoney, G.G., Proc. Roy. Soc. 82, 172 (1909).Google Scholar
[15] L.G. Harrison, Trans. Faraday Soc. 57, 1191 (1961).Google Scholar
[16] Gall, M., Pellerin, J.G., Ho, P.S., Coffey, K.R., Howard, J.K., Mater. Res. Soc. Symp. Proc. 343, 217 (1994).Google Scholar
[17] Josell, D. and Spaepen, F., Acta Metall. Mater. 41(10), 3017 (1993).Google Scholar