Hostname: page-component-586b7cd67f-gb8f7 Total loading time: 0 Render date: 2024-11-25T17:41:44.775Z Has data issue: false hasContentIssue false
  • English
  • Français

Stress and Plastic Flow in Silicon During Amorphization by Ion-Bombardment

Published online by Cambridge University Press:  25 February 2011

Cynthia A. Volkert
Cynthia A. Volkert*
Affiliation:
AT&T Bell Laboratories, 600 Mountain Ave, Murray Hill, NJ, 07974
Get access

Abstract

The in-plane stress in silicon wafers during amorphization by ion-bombardment was determined from wafer curvature measurements using an in-situ laser scanning technique. Measurements were made during room temperature bombardment with 2 MeV Ne, Si, Ar, Kr, and Xe ions. In all experiments, compressive stress was built-up in the bombarded region as a function of the fluence, until a maximum was reached at the dose required to form amorphous silicon. During further amorphization by bombardment, the stress decreased and eventually stabilized. If ion bombardment was interrupted during amorphization, a stress increase was observed over a period of several minutes; when the beam was turned on again, the stress returned immediately to the value measured before interruption. Step height measurements were performed on implanted wafers to determine the out-of-plane strain, and RBS was used to determine the damage profiles. A model is proposed that describes the behavior in terms of the expansion of crystalline silicon by the creation of defects and the flow of amorphous silicon under the ion beam.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 157: Symposium A – Beam-Solid Interactions: Physical Phenomena , 1989 , 635
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Manda, M. L., Shepard, M. L., Fair, R. B., and Massoud, H. Z., Mat. Res. Soc. Symp. Froc., 36, 71 (1985).Google Scholar
2 Li, C. Y., Black, R. D., and LaFontaine, W. R., Mat. Res. Soc. Symp. Proa, 130, 225 (1989).Google Scholar
3 EerNisse, E. P., J. Appl. Phys., 43, 1330, (1972).Google Scholar
4 Arnold, G. W., Picraux, S. T., Myers, D. R., Doyle, B. L., Peercy, P. S., Biefeld, R. M., and Dawson, L. R., Mat. Res. Soc. Symp. Proa, 77, 417 (1987).Google Scholar
5 Whan, R. E. and Arnold, G. W., Appl. Phys. Lett., 17, 378 (1970).Google Scholar
6 Custer, J. S., Thompson, M. O., Jacobson, D. C., Poate, J. M., Roorda, S., Sinke, W. C., and Spaepen, F., to be published.Google Scholar
7 Rammensee, M., Klaumunzer, S., Loffler, S., Neitzert, H. C., to be published.Google Scholar
8 EerNisse, E. P., Appl. Phys. Lett., 18, 581, (1971); in Ion Implantation in Semiconductors, edited by I. Ruge and J. Graul (Springer-Verlag, Berlin, 1971) p. 1.5-17.Google Scholar
9 Spitzer, W. G., Hubler, G. K., and Kennedy, T. K., Nucí. Instr. and Meth., 209/210, 309 (1983).Google Scholar
10 Flinn, P. A., Mat. Res. Soc. Symp. Proa, 130, 41 (1989).Google Scholar
11 Hoffman, R. W. in Physics of Thin Films, edited by Hass, G. and Thun, R. E. (Academic Press, New York, 1966), p. 211.Google Scholar
12 Volkert, C. A., to be published.Google Scholar
13 Holland, O. W., El-Ghor, M. K., and White, C. W., Appl. Phys. Lett., 53, 1282 (1988).Google Scholar
14 Olsen, G. L. and Roth, J. A., Mat. Sci. Reports, 3, 1 (1988).Google Scholar
15 Biersack, J. P. and Haggmark, L. G., Nucl. Inst. Meth., 174, 257 (1980).Google Scholar