Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-11-25T17:36:52.059Z Has data issue: false hasContentIssue false

Small-Angle X-Ray Scattering Studies of Glow-Discharge-Produced a-SiGe:H Alloys

Published online by Cambridge University Press:  21 February 2011

Scott J. Jones
Affiliation:
Department of Physics, Colorado School of Mines, Golden, CO 80401
Yan Chen
Affiliation:
Department of Physics, Colorado School of Mines, Golden, CO 80401
D. L. Williamson
Affiliation:
Department of Physics, Colorado School of Mines, Golden, CO 80401
G.D. Mooney
Affiliation:
National Renewable Energy Laboratory, Golden, CO 80401
Get access

Abstract

Electron density fluctuations associated with microstructural features on a scale from about 1 to 25 nm in glow-discharge-deposited a-Si1-xGex:H films were studied by the technique of small-angle x-ray scattering (SAXS). Films prepared in four different deposition systems (in different laboratories) have been characterized and a general increase in the SAXS signal with increasing x is observed. Density deficiencies determined from film flotation measurements lead to the correlation of the increased scattering intensities with increases in the volume fractions of micro voids. Modeling of the data yields void size distributions that demonstrate significantly more of the larger voids (2 to 6 nm) than found at x=0 (around 1 nm). For the alloys with x>0.4, the scattering at the smallest angles was observed to decrease substantially upon tilting of the sample relative to the x-ray beam. This result contrasts with the small or no changes in SAXS upon tilting device-quality x=0 films. This anisotropie scattering associated with the tilting experiments has been modeled with distributions of ellipsoidal microvoids that are preferentially oriented with their major axes normal to the film plane. This latter result is consistent with a columnar-like microstructure. However, one film with x=0.37 shows no evidence for such microstructure.

Type
Research Article
Copyright
Copyright © Materials Research Society 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Mackenzie, K.D., Eggert, J.R., Leopold, D.J., Li, Y.-M., Lin, S. and Paul, W., Phys. Rev. B 31, 2198 (1985).CrossRefGoogle Scholar
2. Hauschildt, D., Fischer, R. and Fuhs, W., Phys. Stat. Sol. B 102, 563 (1980).CrossRefGoogle Scholar
3. Ichimura, T., Ihara, T., Hama, T., Ohsawa, T., Sakai, H. and Uchida, Y., J. Non-Cryst. Solids 77&78, 901 (1985).Google Scholar
4. Williamson, D.L., Manan, A.H., Nelson, B.P. and Crandall, R.S., Appl. Phys. Lett. 55, 783 (1989).Google Scholar
5. Muramatsu, S., Shimada, T., Kajiyama, H., Azuma, K., Watanabe, T., Kamiyama, T. and Suzuki, K., Jpn. J. Appl. Phys. 28, L1092 (1989).Google Scholar
6. Muramatsu, S., Kajiyama, H., Itoh, H., Matsubara, S. and Shimada, T., Proc. 20th IEEE Photovoltaics Specialists Conference (Las Vegas, 1988) 61.Google Scholar
7. Donovan, T.M., Ashley, E.J. and Spicer, W.E., Phys. Lett. 32A, 85 (1970).Google Scholar
8. Mahan, A.H., Williamson, D.L., Nelson, B.P. and Crandall, R.S., Phys. Rev. B 40, 12024 (1989).Google Scholar
9. Cargill, G.S., Phys. Rev. Lett. 28, 1372 (1972).CrossRefGoogle Scholar
10. Catalano, A., Bennett, M., Chen, L., Fieselmann, B., Li, Y., Newton, J., Podlesny, R., Wiedeman, S., Yang, L., NREL Annual Technical Report- May 1990 to April 1991, 6.Google Scholar
11. Turner, W.A., Jones, S.J., Li, Y.-M., Pang, D., Wetsel, A.E., and Paul, W., Solar Cells 30, 245 (1991).Google Scholar