Hostname: page-component-586b7cd67f-vdxz6 Total loading time: 0 Render date: 2024-11-26T20:22:03.107Z Has data issue: false hasContentIssue false
  • English
  • Français

Preparation and Characterization of PMN (PbMgxNb1−xOz) Films by Sputtering

Published online by Cambridge University Press:  15 February 2011

J.S. Cross ,
M. Tsukada ,
K. Kurihara ,
N. Kamehara  and
K. Niwa
J.S. Cross
Affiliation:
Materials Research Division, Fujitsu Laboratories Ltd., 10–1 Morinosato-wakamiya, Atsugi 243–01 Japan
M. Tsukada
Affiliation:
Materials Research Division, Fujitsu Laboratories Ltd., 10–1 Morinosato-wakamiya, Atsugi 243–01 Japan
K. Kurihara
Affiliation:
Materials Research Division, Fujitsu Laboratories Ltd., 10–1 Morinosato-wakamiya, Atsugi 243–01 Japan
N. Kamehara
Affiliation:
Materials Research Division, Fujitsu Laboratories Ltd., 10–1 Morinosato-wakamiya, Atsugi 243–01 Japan
K. Niwa
Affiliation:
Materials Research Division, Fujitsu Laboratories Ltd., 10–1 Morinosato-wakamiya, Atsugi 243–01 Japan
Get access

Abstract

Thin films of Pb(MgxNb1−x)Oz were produced by reactive sputtering from a lead target and columbite magnesium niobate powder targets at temperatures of 500–700°C on Pt/Ti/Si, Pt/SiO2/Si, MgO(lOO) and SrTiO3(100) substrates. The films in general deposited on Pt consisted of PbO and pyrochlore phases depending upon the deposition temperature. ICP analysis revealed that the films contained slightly less Mg than the target. This was attributed to negative ion preferential resputtering of the film within the discharge. However, films deposited at 650°C on MgO and SrTiO3 substrates from a lead target and magnesium niobate target which contained excess MgO, contained a highly oriented perovskite (100) Pb(Mg1/3Nb2/3)O3 [PMN] phase according to X-ray diffraction analysis. It was observed that the substrate composition and orientation greatly influenced the crystallinity of the deposited films.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 361: Symposium I2 – Ferroelectric Thin Films IV , 1994 , 483
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Swartz, S.L. and Shrout, T.R., Mater. Res. Bull. 17, 1245 (1982).Google Scholar
2 Shrout, T.R. and Halliyal, A., Am. Ceram. Soc. Bull. 66[4], 704 (1987).Google Scholar
3 Okuwada, K., Nakamura, S., Imai, M. and Kakuno, K., Jap. J. Appl. Phys. 29[6], 1153 (1990).Google Scholar
4 Uusimaki, A., Zhang, H.-X., Leppavuori, S., and Moilanen, H. and Rautioaho, R., Ferroelect. Lett. 17, 105 (1994)Google Scholar
5 Tantigate, C. and Safari, A., in Thin Film Ferroelectrics IV, (Mater. Res. Soc. Proc., this volume, Pittsburgh, PA, 1995).Google Scholar
6 Jiang, M.C. and Wu, T.B., J. Mater. Res. 9[7], 1879 (1994).Google Scholar
7 Pignolet, A., Roy, R.A., Doyle, J.P., and Cuomo, J.J., J. Vac. Sci Technol. A 12[5], 2840 (1994).Google Scholar
8 Adachi, H. and Wasa, K., in Ferroelectric Thin Films, edited by Myers, E.R. and Kingon, A.I. (Mater. Res. Soc. Proc. 200, Pittsburgh, PA, 1990). pp. 103–114.Google Scholar
9 Hamerich, A., Wunderlich, R., and Müller, J., J. Vac. Sci. Technol. A 12[5], 2873 (1994).Google Scholar
10 Kugimiya, K., Ueda, I., and Iizima, K., in Ferroelectric Thin Films II, edited by Kingon, A.I., Myers, E.R., and Tuttle, B. (Mater. Res. Soc. Proc. 243, Pittsburgh, PA, 1993) pp. 179–184.Google Scholar