Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-29T07:41:37.065Z Has data issue: false hasContentIssue false

Phase Transformations and Crystallography of Twins in Martensite in Ti-Pd Alloys

Published online by Cambridge University Press:  10 February 2011

M. Nishida
Affiliation:
Department of Materials Science, Kumamoto University, Kurokami, Kumamoto 860, Japan, [email protected]
Y. Morizono
Affiliation:
Department of Materials Science, Kumamoto University, Kurokami, Kumamoto 860, Japan, [email protected]
H. Kijima
Affiliation:
Graduate School, Kumamoto University, Kurokami, Kumamoto 860, Japan
A. Ikeya
Affiliation:
Graduate School, Kumamoto University, Kurokami, Kumamoto 860, Japan
H. Iwashita
Affiliation:
Graduate School, Kumamoto University, Kurokami, Kumamoto 860, Japan
K. Hiraga
Affiliation:
Institute for Materials Research, Tohoku University, Katahira, Aoba, Sendai 980–77, Japan
Get access

Abstract

Phase transformations and crystallography of twins in near-equiatomic Ti-Pd alloys have been studied. In the first half we have found that the transformation temperature decreases with decreasing the Pd contents and the successive transformations take place in the Ti-rich alloys. While the transformation temperature is nearly constant with the composition and a single transformation takes place in the equiatomic and Pd-rich alloys. The solubility limit of TiPd compound in Ti-rich side is extended to about 55 at%Ti at 900°C and abruptly decreased with decreasing temperature. In the latter half we have found three twinning modes, i.e., {111} Type I, <121> Type II and {101} compound twins, in the martensite. The {111} Type I and <121> Type II twinnings which are conjugate to each other coexist in the same variant. The {111} Type I twins are dominantly observed and the <121> Type II twins are less frequently observed. The former twinning is considered to be a lattice invariant shear. There is no martensite variant consisting wholly of the <121> Type II twins throughout the present observation. The <121> Type II twinning is considered to be a deformation twin due to the elastic interaction during the transformation. The {101} compound twinning is also considered to be a deformation twin, since the twin has an isolated fashion in the martensite variant. The boundary structure of the above three twinning modes was also discussed on the basis of lattice image.

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Donkersloot, H. C. and van Vucht, J. H. N., J. Less Common Met. 20, p. 63 (1970).Google Scholar
2. Enami, K., Seki, H. and Nenno, S., Tetsu-to-Hagane. 72, p. 563 (1986).Google Scholar
3. Krautwasser, P., Bhan, S. and Shcubert, K., Z. Metallkd. 59, S. 724 (1968).Google Scholar
4. Bilby, B. A. and Crocker, A. G., Proc. Roy. Soc. Ser. A. 288, p. 240 (1965).Google Scholar
5. Lindquist, P. G. and Wayman, C. M., MRS Int'l. Mtg. on Adv. Mats. 9, p. 123 (1989).Google Scholar
6. Knowles, K. M. and Smith, D. A., Acta Metall. 29, p. 101 (1981).Google Scholar
7. Hara, T., Ohba, T., Miyazaki, S. and Otsuka, K., Mater. Trans. JIM. 33, p. 1105 (1992).Google Scholar
8. Morizono, Y., Nishida, M. and Chiba, A., Trans. Mat. Res. Soc. Japan. 16B, p. 1151 (1994).Google Scholar
9. Knowles, K. M., Phil. Mag. A45, p. 357 (1982).Google Scholar
10. Nishida, M., Yamauchi, K., Itai, I., Ohgi, H. and Chiba, A., Acta Metall, et Mater. 43, p. 1229 (1995)Google Scholar