Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-25T17:50:42.462Z Has data issue: false hasContentIssue false
  • English
  • Français

On The Measurement Of Residual Stress In Thin Films

Published online by Cambridge University Press:  10 February 2011

Z. B. Zhao ,
J. Hershberger ,
S. M. Yalisove  and
J. C. Bilello
Z. B. Zhao
Affiliation:
Department of Materials Science and Engineering, The University of Michigan, Ann Arbor, MI 48109–2136
J. Hershberger
Affiliation:
Department of Materials Science and Engineering, The University of Michigan, Ann Arbor, MI 48109–2136
S. M. Yalisove
Affiliation:
Department of Materials Science and Engineering, The University of Michigan, Ann Arbor, MI 48109–2136
J. C. Bilello
Affiliation:
Department of Materials Science and Engineering, The University of Michigan, Ann Arbor, MI 48109–2136
Get access

Abstract

This work reports a comparative study on three curvature based techniques for stress measurement in thin films, including double crystal diffraction topography (DCDT), profilometry, and laser scanning technique (LST). These techniques measure different physical quantities. In the former case, the curvature of crystal lattice planes is assessed while in the latter two cases, the curvature of physical surface of a sample is measured. The current experiments use these three techniques to determine the quantities of interest for a variety of films deposited on Si (100) wafers. In general, profilometry and LST produce similar results on surface curvature. For specimens where the residual stresses produces large curvatures of both types (lattice curvature and surface curvature), the results by DCDT and LST agree fairly well. When small to moderate curvatures are present, the two methods deviate to varying degrees on absolute curvatures. Nevertheless, DCDT and LST generally yield similar results on differential curvatures, i.e., the stress induced curvature differentials. When proper consideration is taken for the inherent limits of each technique, both DCDT and LST can be used as valid procedures for stress measurement in thin film-substrate systems.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 505 , 1997 , 519
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Noyan, I. C. and Cohen, J. B., Residual Stress measurement by Diffraction and Interpretation,(Springer, Now York, 1987), P117.Google Scholar
2.Noyan, I. C., Huang, T. C. and York, B. R., CRC Critical Review in Solid State and Materials Science, 20, 125 (1995).Google Scholar
3.Fouss, P. H. and Brennan, S., Ann Rev. of Materials Science, 20, 365 (1990).Google Scholar
4.Malhotra, S. G., Rek, Z. U., Yalisove, S. M. and Bilello, J. C., A 15, 345 (1996).Google Scholar
5.Renninger, M., Phy. Lett., 1, 104 (1962).Google Scholar
6.Renninger, M., Z. Phys., 19, 20 (1965).Google Scholar
7.Kuo, C. L., Emamian, M. and Bilello, J. C., Rev. Sci. Instrum., 55, 107 (1984).Google Scholar
8.Kuo, C. L., Vanier, P. E. and Bilello, J. C., J. Appl. Phys., 55, 375 (1984).Google Scholar
9.Sinha, A. K., Levinstein, H. J., and Smith, T. E., J. Appl. Phys., 49, 2423 (1978).Google Scholar
10.Pan, J. T. and Blech, I., J. Appl. Phys., 55, 2874 (1984).Google Scholar
11.Flinn, P. A., Gardner, D. S. and Nix, W. D., IEEE Trans. On Electron Devices, 34, 689 (1987).Google Scholar
12.Witvrouw, A. and Spaepen, F., J. Appl. Phys., 73, 7344 (1993).Google Scholar
13.Geisz, J. F., Kuech, T. F., and Lagally, M. G., J. Appl. Phys., 75, 1530 (1994).Google Scholar
14.Volkert, C. A., J. Appl. Phys., 70, 3521 (1991).Google Scholar
15.Cuthrell, R. E., Mattox, D. M., Peeples, C. R., Dreike, P. L. and Lamppa, K. P., J. Vac. Sci. Technol., A 6, 2914 (1988).Google Scholar
16.Morrison, D. J., Jones, J. W., Was, G. S., Mashayekhi, A. and Hoffman, D. W., Mat. Res. Symp. Poc., 130, P41 (1989).Google Scholar
17.Zhao, Z. B., Parfitt, L. J., Hershberger, J., Yalisove, S. M. and Bilello, J. C., to be publishedGoogle Scholar