Hostname: page-component-7bb8b95d7b-w7rtg Total loading time: 0 Render date: 2024-09-17T20:07:06.875Z Has data issue: false hasContentIssue false

Nox Reduction on Char using Microwaves Carolynn

Published online by Cambridge University Press:  15 February 2011

W. Buenger
Affiliation:
Buenger Dow Chemical, Gas Separations R&D, Freeport, TX 77541
Edward R. Peterson
Affiliation:
Peterson Dow Chemical, Organic Product R&D, Freeport, TX 77541
Chang-Yul Cha
Affiliation:
Cha CHA Corporation, 372 W. Lyons St., Laramie, WY 82070
Get access

Abstract

More than 18 million tons of nitrogen oxide (NO and NO2) are emitted into the air over the United States each year. These oxides contribute to the formation of acid rain and street level ozone, and are most concentrated in areas of industrial and commercial activity. The response of the Environmental Protection Agency to the problem has been to legislate anti-pollution laws and regulations which will be enforced in increasingly strict stages beginning in 1997. Existing NOx abatement technologies do not meet the long range NOx abatement needs of the processing industries and utilities.

Char, a heat treated and volatile form of coal, can effectively adsorb NOx from waste gas. Microwave energy, when properly applied, can convert the NOx and carbon via reduction to nitrogen and carbon dioxide. The basic principles of this technology are taught as well as some of the pertinent development aspects currently under investigation.

Type
Research Article
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Bansal, R.C., Donnet, J-B, and Stoeckli, F., Activated Carbon (Marcel Dekker, Inc., New York, 1988), pp 3035.Google Scholar
2. Richter, E., Kleinschmidt, R., Pilarczyk, E., Knoblauch, K., and Juntgen, H., Thermochimica Acta (Elsevier Science Publishers, Amsterdam, 1985), pp. 311314.Google Scholar
3. Rubel, A.M., Stencel, J.M., and Ahmed, S.N., presented at the 1993 American Chemical Society Meeting, Denver, CO, 1993 (Published in preprints of Fuel Chemistry Division).Google Scholar
4. Furusawa, T., Kunii, D., Ogumas, A., and Yamada, N., International Chemical Engineering, 20(2), 239 (1980).Google Scholar
5. Teng, H. and Suuberg, E., J. Phys. Chem., 97, 478 (1993).Google Scholar
6. Teng, H. and Suuberg, E., Ind. Eng. Chem. Res., 32, 416 (1993).Google Scholar