Hostname: page-component-78c5997874-g7gxr Total loading time: 0 Render date: 2024-11-20T02:42:59.200Z Has data issue: false hasContentIssue false
  • English
  • Français

Non-Destructive Characterisation of Thermal Barrier Coatings Using Impedance Spectroscopy

Published online by Cambridge University Press:  17 March 2011

Junfa Mei ,
Xin Wang  and
Ping Xiao
Junfa Mei
Affiliation:
Department of Mechanical Engineering, Brunel University, Uxbridge, UB8 3PH, UK
Xin Wang
Affiliation:
Department of Mechanical Engineering, Brunel University, Uxbridge, UB8 3PH, UK
Ping Xiao
Affiliation:
Department of Mechanical Engineering, Brunel University, Uxbridge, UB8 3PH, UK
Get access

Abstract

Impedance spectroscopy (IS) has been used to characterise the degradation of thermal barrier coatings (TBCs) due to thermal treatments at 1100°C for a period up to 200 hrs. The growth of the oxide layer at the yttria stabilised zirconia (YSZ)/bond coat interface in TBCs can be examined by measuring the impedance diagrams. From the analysis of the impedance diagrams of TBCs, the electrical properties of YSZ were found to be nearly constant during the thermal treatments, indicating there was little change in the microstructure and composition of YSZ. However, there was a clear change in the electrical properties of the oxide layer in the TBCs after thermal treatments, suggesting both microstructural and composition changes occurred in the oxide layer. These studies indicate that the IS is a very useful method in non-destructive characterisation of the degradation of TBCs.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 645: Symposium M – Thermal Barrier Coatings-2000 , 2000 , M8.7.1
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Lee, W. Y., Stinton, D. P., Berndt, C. C., Erdogon, F., Lee, Y. D. and Mutasim, Z., J. Am. Ceram. Soc., 79 [12] 3003–12 (1996).Google Scholar
2. Tawancy, H. M., Sridhar, N., Abbas, N. M. and Rickerby, D., J. Mater. Sci., 33 [3] 681–686 (1998).Google Scholar
3. Liu, H., Mojica-Calderon, C., Lyon, S. B. and Stack, M. M., Solid State Ionics 126 (1999) 363–372 Google Scholar
4. Ali, M. S., Xiao, P., Materials at High Temperatures, 17(1) 7–12 (2000)Google Scholar
5. Pint, B. A., Wright, I. G., Lee, W. Y., Zhang, Y., Prussner, K., Alexander, K. B., Materials Science and Engineering A245(1998) 201–211 Google Scholar
6. Fontana, Mars G., “Oxidation of Kinetics”, in Corrosion Engineering, 3rd Edition, pp.513–516, MacGrow-Hill Book Company 1987 Google Scholar
7. Jiles, D., Introduction to the Electronic Properties of Materials, Chapman & Hall (1994)Google Scholar
8. MacDonal, F., Impedance Spectroscopy, Jon Wiley & Sons, 1987.Google Scholar
9. Samsonov, G.V.. translated from Russian by Turton, C. Nigel and Tatiana, . Turton, I., Chapter IV, “Electrical and Magnetic properties”, pp.263–280 in The Oxide Handbook, IFI/PLENUM, New York-Washington-London, 1973.Google Scholar
10. Buchanan, R. C., “Properties of Ceramic Insulators” pp1–79 in Ceramic Materials for Electronics, MacGrow-Hill Book Company 1987 Google Scholar
11. Kleitz, M., Dessemond, L. and Steil, M. C., Solid State Ionics, 75 107–115 (1995).Google Scholar
12. Kingery, W. D., Bowen, H. K., Uhlmann, D. R., Section 17 “Electrical Conductivity”, pp847–904 in Introduction to Ceramics, Second Edition, John Wiley& Sons / New York (1976).Google Scholar
13. Birks, N., Meier, G.H. and Pettit, F. S., JOM, p42–46, Dec. 1994.Google Scholar
14. Provenzano, V. et al. , J. Am. Ceram. Soc., 55, 492–496 (1972)Google Scholar