Hostname: page-component-586b7cd67f-tf8b9 Total loading time: 0 Render date: 2024-11-29T07:40:30.699Z Has data issue: false hasContentIssue false
  • English
  • Français

Microstructure and Mechanical Properties of Mechanically Alloyed NiAl

Published online by Cambridge University Press:  26 February 2011

S. J. Hwang ,
P. Nash ,
M. Dollar  and
S. Dymek
S. J. Hwang
Affiliation:
Illinois Institute of Technology, Department of Metallurgical and Materials Engineering, 10 W 33rd St., Chicago, IL 60616, USA
P. Nash
Affiliation:
Illinois Institute of Technology, Department of Metallurgical and Materials Engineering, 10 W 33rd St., Chicago, IL 60616, USA
M. Dollar
Affiliation:
Illinois Institute of Technology, Department of Metallurgical and Materials Engineering, 10 W 33rd St., Chicago, IL 60616, USA
S. Dymek
Affiliation:
Illinois Institute of Technology, Department of Metallurgical and Materials Engineering, 10 W 33rd St., Chicago, IL 60616, USA
Get access

Abstract

Mechanical alloying (MA) has been used to produce NiAl powders from either elemental or prealloyed constituents. The powders were consolidated by hot extrusion resulting in material which was fully dense, with a grain size around 1 μm and a homogeneous distribution of oxide particles with sizes in the range 10 to 100 nm. TEM observation indicates the presence of a significant dislocation density after consolidation. Mechanical properties have been studied by compression testing from room temperature to 1300 K in air. Yield strengths ranged from 1453 MPa to 32 MPa depending on material and test temperature. Work hardening was observed at all test temperatures for both materials. Substantial ductility was observed even at room temperature where it exceeds 7.5 %. The effects of microstructure on the mechanical properties are discussed.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 213: Symposium Q – High-Temperature Ordered Intermetallic Alloys IV , 1990 , 661
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Nash, P., Higgins, G. T., Dillinger, N., Hwang, S. J. and Kim, H., Advances in Powder Metallurgy, 1989. Pub. MPIF, Princeton, 1989, vol. 2, 473–480.Google Scholar
2. Dillinger, N., MS thesis, Illinois Institute of Technology, (1989).Google Scholar
3. Liu, C. T., White, C. L. and Lee, E. H., Scripta Met., 19, 1247 (1985).CrossRefGoogle Scholar
4. Dieter, G. E., Mechanical Metallurgy, 2nd ed. (McGraw Hill, New York, 1976) p. 227 Google Scholar
5. Viswanadham, R. K., Mannan, S. K., Kumar, K. S. and Wolfenden, A., J. Mats Sci. Let., 8, 409 (1989).CrossRefGoogle Scholar
6. Whittenberger, J. D., J. Mats. Sci., 22, 394 (1987)CrossRefGoogle Scholar
7. Darolia, R., Lahrman, D. F., Field, R. D. and Freeman, A. J. in High-Temperature Ordered Intermetallic Alloys III, edited by Liu, C. T., Taub, A. I., Stoloff, N. S., and Koch, C. C. (MRS Symposium Proc. 133, Pittsburgh, PA 1989), pp. 113–118.Google Scholar